Fulong Jing
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Fulong Jing has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Yu Wang
College of Information and Communication Engineering, Harbin Engineering University, Harbin 150001, China
4 shared publications Chaozhu Zhang
College of Information and Communication Engineering, Harbin Engineering University, No.145 Nantong street, Nangang District, Harbin, 150001, China
2 shared publications- Chunjie Zhang
College of Information and Communication Engineering, Harbin Engineering University, Harbin, China
1 shared publication - Ke Wang
National Demonstration Center for Experimental Electrical & Electronic Education, Yangtze University, Jingzhou 434023, China
1 shared publication - Liangtian Wan
Key Laboratory for Ubiquitous Network and Service Software of Liaoning Province, School of Software, Dalian University of Technology, Dalian, China
1 shared publication Shuhong Jiao
Harbin Engn Univ, Coll Informat & Commun Engn, Harbin 150001, Heilongjiang, Peoples R China
1 shared publication
Latest Publications
- Open Access
- 19 November 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 7, 169038-169046
LFM Signal Analysis Based on Improved Lv Distribution
In this paper, we propose a parameter estimation method named improved Lv distribution (ImLVD) for linear frequency modulated (LFM) signals. In this method, based on the scaling principle, we present a two-scale estimation strategy to acquire low computational cost. The two-scale estimation strategy includes coarse estimation operation and fine estimation operation. To implement the strategy, improved scaled Fourier transform (ISFT) and Chirp-Z transform (CZT) operation are used, where the ISFT can be implemented by fast Fourier transform (FFT) and complex multiplications. By changing the frequency searching range of ISFT, the ISFT is used in different frequency ranges. To improve the anti-noise, we present an improved parameter selection criterion which can reduce the noise correlation effectively. In this paper, the implementation, anti-noise performance, and computational cost are analyzed. Through simulations and analyses, we demonstrate that the ImLVD outperforms the compared algorithms.
- 19 November 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 7, 169038-169046
Open AccessLFM Signal Analysis Based on Improved Lv Distribution
In this paper, we propose a parameter estimation method named improved Lv distribution (ImLVD) for linear frequency modulated (LFM) signals. In this method, based on the scaling principle, we present a two-scale estimation strategy to acquire low computational cost. The two-scale estimation strategy includes coarse estimation operation and fine estimation operation. To implement the strategy, improved scaled Fourier transform (ISFT) and Chirp-Z transform (CZT) operation are used, where the ISFT can be implemented by fast Fourier transform (FFT) and complex multiplications. By changing the frequency searching range of ISFT, the ISFT is used in different frequency ranges. To improve the anti-noise, we present an improved parameter selection criterion which can reduce the noise correlation effectively. In this paper, the implementation, anti-noise performance, and computational cost are analyzed. Through simulations and analyses, we demonstrate that the ImLVD outperforms the compared algorithms.
- Open Access
- 20 December 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 7, 4496-4505
QFM Signals Parameters Estimation Based on Double Scale Two Dimensional Frequency Distribution
- 20 December 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 7, 4496-4505
Open AccessQFM Signals Parameters Estimation Based on Double Scale Two Dimensional Frequency Distribution
- Open Access
- 9 November 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 6, 69407-69414
Underdetermined Blind Source Separation of Synchronous Orthogonal Frequency-Hopping Signals Based on Tensor Decomposition Method
This paper considers the problems of synchronous orthogonal frequency-hopping (FH) signals separation and direction of arrival (DOA) estimation in the underdetermined situation. First of all, in order to estimate the mixing matrix of the FH signals, we stack the two-dimensional covariance matrices of the received FH signals into a third-order tensor, and then, an estimation approach based on the tensor decomposition method is developed to calculate this mixing matrix. Next, to separate these FH signals, a modified source recovery method is proposed. Finally, the DOAs of the FH signals are also obtained. Numerical results demonstrate that compared to the existing algorithms, the proposed algorithm not only presents superior performance but also requires less sparsity limitation and cost time.
- 9 November 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 6, 69407-69414
Open AccessUnderdetermined Blind Source Separation of Synchronous Orthogonal Frequency-Hopping Signals Based on Tensor Decomposition Method
This paper considers the problems of synchronous orthogonal frequency-hopping (FH) signals separation and direction of arrival (DOA) estimation in the underdetermined situation. First of all, in order to estimate the mixing matrix of the FH signals, we stack the two-dimensional covariance matrices of the received FH signals into a third-order tensor, and then, an estimation approach based on the tensor decomposition method is developed to calculate this mixing matrix. Next, to separate these FH signals, a modified source recovery method is proposed. Finally, the DOAs of the FH signals are also obtained. Numerical results demonstrate that compared to the existing algorithms, the proposed algorithm not only presents superior performance but also requires less sparsity limitation and cost time.
- Open Access
- 26 September 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 6, 54310-54319
Frequency-Hopping Signal Parameters Estimation Based on Orthogonal Matching Pursuit and Sparse Linear Regression
This paper addresses the problem of estimating frequency hopping (FH) signals parameters with the single array. The existing optimization algorithms are with unrealistic computational burden. In order to reduce the computation burden, a novel method, based on orthogonal matching pursuit and sparse linear regression (OSLR), is proposed in this paper. The OSLR method consists of two steps. First, by segmenting the received signals into several measurements, orthogonal matching pursuit is used to detect whether the segments include hop timings or not. Second, sparse linear regression is used to estimate the spectrogram of FH signals for the segmentations with hop timings. Numerical simulations demonstrate that the OSLR method can achieve superior performance, and the OSLR method can be exploited to deal with underdetermined blind source separation problem of FH signals.
- 26 September 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 6, 54310-54319
Open AccessFrequency-Hopping Signal Parameters Estimation Based on Orthogonal Matching Pursuit and Sparse Linear Regression
This paper addresses the problem of estimating frequency hopping (FH) signals parameters with the single array. The existing optimization algorithms are with unrealistic computational burden. In order to reduce the computation burden, a novel method, based on orthogonal matching pursuit and sparse linear regression (OSLR), is proposed in this paper. The OSLR method consists of two steps. First, by segmenting the received signals into several measurements, orthogonal matching pursuit is used to detect whether the segments include hop timings or not. Second, sparse linear regression is used to estimate the spectrogram of FH signals for the segmentations with hop timings. Numerical simulations demonstrate that the OSLR method can achieve superior performance, and the OSLR method can be exploited to deal with underdetermined blind source separation problem of FH signals.