Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Muhammad Luqman has a total of 6 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    A Novel Hybrid Converter Proposed for Multi-MW Wind Generator for Offshore Applications

    by Muhammad Luqman, Gang Yao, Lidan Zhou, Tao Zhang, Anil Lamichhane

    Modern multi-MW wind generators have used multi-level converter structures as well as parallel configuration of a back to back three-level neutral point clamped (3L-NPC) converters to reduce the voltage and current stress on the semiconductor devices. These configurations of converters for offshore wind energy conversion applications results in high cost, low power density, and complex control circuitry. Moreover, a large number of power devices being used by former topologies results in an expensive and inefficient system. In this paper, a novel bi-directional three-phase hybrid converter that is based on a parallel combination of 3L-NPC and ‘n’ number of Vienna rectifiers have been proposed for multi-MW offshore wind generator applications. In this novel configuration, total power equally distributes by sharing of total reference current in each parallel-connected generator side power converter, which ensures the lower current stress on the semiconductor devices. Newly proposed topology has less number of power devices compared to the conventional configuration of parallel 3L-NPC converters, which results in cost-effective, compact in size, simple control circuitry, and good performance of the system. Three-phase electric grid is considered as a generator source for implementation of a proposed converter. The control scheme for a directly connected three-phase source with a novel configuration of a hybrid converter has been applied to ratify the equal power distribution in each parallel-connected module with good power factor and low current distortion. A parallel combination of a 3L-NPC and 3L-Vienna rectifier with a three-phase electric grid source has been simulated while using MATLAB and then implemented it on hardware. The simulation and experimental results ratify the performance and effectiveness of the proposed system.


  • Humanoid robot locomotion system with balancing feedback using leg and arm strategy and stepping strategy

    by Muhammad Luqman, Widyawardana Adiprawita, Kusprasapta Mutijarsa

    Humanoid robot must has an ability to move with dynamic motion. Robot is required to walk even get any interference of other robots or other disturbance, and keep its balance. In general, robot motion system is built by 2 kinematics systems, inverse kinematics and forward kinematics. Inverse kinematics is more often used for robot motion because it is more dynamic compare to forward kinematics. Robot motion also has to have a balancing system. In this capstone design, feedback system for robot motion balancing is developed using 2 strategy, leg and arm strategy, and stepping strategy. Leg and arm strategy is a technique to obtain balancing by giving direct feedback to actuator based on Robot Center of Mass (CoM). Stepping is a technique to maintain balance when robot is walking. Stepping is done by making robot motion trajectory to make one of robot's legs take a charge as robot support. Robot motion balancing algorithm has been implemented in robot platform Baldhart v1.0. Robot has ability to keep its balance with maximum disturbance 25° in 4 directions. Robot has ability to move in a plane with different height for maximum 0.6 cm.