ATAna Lúcia de Toffoli

Ana Lúcia de Toffoli

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Ana Lúcia de Toffoli has a total of 18 co-authors. Here are the top co-authors by number of shared publications:

  • Fernando Mauro Lanças

    Laboratory of Chromatography, Institute of Chemistry at Sao Carlos, University of Sao Paulo, P.O. Box 780, Sao Carlos 13566590, Brazil

    5 shared publications
  • Altair Benedito Moreira

    São Paulo State University (UNESP), Institute of Biosciences, Humanities and Exact Sciences, São José do Rio Preto, São Paulo, Brazil

    4 shared publications
  • Edvaldo Vasconcelos Soares Maciel

    Institute of Chemistry of Sao Carlos, University of Sao Paulo, São Carlos, SP, Brazil

    3 shared publications
  • Márcia Cristina Bisinoti

    Sao Paulo State University (UNESP) 2265 Cristovao Colombo St.

    3 shared publications
  • Bruno Henrique Fumes

    Institute of Chemistry of Sao Carlos, University of Sao Paulo, São Carlos, SP, Brazil

    2 shared publications
  • Kamilla da Mata

    A UNESP, Laboratory of Environmental Sciences Studies, Department of Chemistry and Environmental Sciences, Institute of Biosciences, Letters and Exact Sciences, "Julio de Mesquita Filho" State University of São Paulo, Rua Cristovão Colombo , São José do Rio Preto - SP , Brazil

    2 shared publications

Latest Publications

  • Online fully automated SPE‐HPLC‐MS/MS determination of ceftiofur in bovine milk samples employing a silica‐anchored ionic liquid as sorbent

    by Débora Cecatto Ferreira, Ana Lúcia de Toffoli, Edvaldo Vasconcelos Soares Maciel, Fernando Mauro Lanças

    Solid‐phase extraction coupled online with high performance liquid chromatography and tandem mass spectrometry was successfully applied to determine low concentrations of ceftiofur antibiotic in bovine milk samples. A silica‐anchored ionic liquid was applied as sorbent material to be used as extraction phase in the proposed online system. The material was characterized by Fourier Transform Infrared Spectroscopy and Scanning Electron Microscopy. In order to improve the system reproducibility, the following experimental parameters were optimized: organic solvent percentage, time and sample loading flow rate. Subsequently, the method was validated presenting satisfactory results as adequate selectivity, good linearity and correlation coefficient higher than 0.98. The limit of detection and quantification were 0.1 μg L−1 and 0.7 μg L−1, respectively. The precision of the methodology was evaluated as repeatability and intermediate precision, with relative standard deviation values ​​lower than 15%. The accuracy of the method ranged from 72.8 to 137% and the minimum and maximum recovery values ​​were 73.4 and 111.3%, respectively. After the validation, seven milk samples were analyzed and although ceftiofur was not detected in any of them the method was demonstrated to be efficient when applied to the analysis of milk samples fortified with the pollutant of interest. This article is protected by copyright. All rights reserved


  • Recent trends in sorption‐based sample preparation and liquid chromatography techniques for food analysis

    by Edvaldo V. Soares Maciel, Ana Lúcia de Toffoli, Fernando Mauro Lanças

    The accelerated rising of the world's population increased the consumption of food, thus demanding more rigors in the control of residue and contaminants in food–based products marketed for human consumption. In view of the complexity of most food matrices, including fruits, vegetables, different types of meat, beverages, among others, a sample preparation step is important to provide more reliable results when combined with HPLC separations. An adequate sample preparation step before the chromatographic analysis is mandatory in obtaining higher precision and accuracy in order to improve the extraction of the target analytes, one of the priorities in analytical chemistry. The recent discovery of new materials such as ionic liquids, graphene‐derived materials, molecularly imprinted polymers, restricted access media, magnetic nanoparticles, and carbonaceous nanomaterials, provided high sensitivity and selectivity results in an extensive variety of applications. These materials, as well as their several possible combinations, have been demonstrated to be highly appropriate for the extraction of different analytes in complex samples such as food products. The main characteristics and application of these new materials in food analysis will be presented and discussed in this paper. Another topic discussed in this review covers the main advantages and limitations of sample preparation microtechniques, as well as their off‐line and on‐line combination with HPLC for food analysis.


  • Graphene particles supported on silica as sorbent for residue analysis of tetracyclines in milk employing microextraction by packed sorbent

    by Edvaldo Vasconcelos Soares Maciel, Bruno Henrique Fumes, Ana Lúcia de Toffoli, Fernando Mauro Lanças

    This paper describes the use of graphene‐based sorbents for determination of four tetracyclines in milk. The synthesized materials were combined with microextraction by packed sorbent (MEPS) to act as the sample preparation step. The extraction performance of these sorbents was compared to commercial phases, and graphene supported on silica provided the best results. The analytical method optimization was carried out by employing experimental design. Firstly, an evaluation of the experimental variables (elution solvent, use of EDTA, ionic force, and pH of the washing solution) was made by a 24‐1 factorial experimental design. The variables sampling, washing and elution cycles of MEPS were further optimized under a full 23 experimental design. The validation parameters were determined under optimized conditions resulting in a linearity ranging from 15 to 110 μg/L with R2 values above 0.98, and LOQs ranging from 0.05 to 0.9 μg/L. The accuracy ranged from 87.9 to 118.4% and intra/inter‐day precision reported by the RSDs were lower than 19%. The proposed and validated method was successfully applied to the analysis of 11 milk samples from different animals, revealing traces of tetracyclines in only two of them. This study focused on the evaluation of graphene‐based sorbents combined with MEPS for tetracycline analysis provided equivalent or even better results than other proposed methods, suggesting being a sensitive, fast and reliable alternative method for the determination of tetracyclines in milk samples.


  • Packed in-tube solid phase microextraction with graphene oxide supported on aminopropyl silica: Determination of target triazines in water samples

    by Ana L. De Toffoli, Bruno H. Fumes, Fernando M. Lanças

    On-line in-tube solid phase microextraction (in-tube SPME) coupled to high performance liquid chromatography and tandem mass spectrometry (HPLC-MS/MS) was successfully applied to the determination of selected triazines in water samples. The method based on the employment of a packed column containing graphene oxide (GO) supported on aminopropyl silica (Si) showed that the extraction phase has a high potential for triazines extraction aiming to its physical-chemical properties including ultrahigh specific surface area, good mechanical and thermal stability and high fracture strength. Injection volume and loading time were both investigated and optimized. The method validation using Si-GO to extract and concentrate the analytes showed satisfactory results, good sensitivity, good linearity (0.2–4.0 µg L−1) and low detection limits (1.1–2.9 ng L−1). The high extraction efficiency was determined with enrichment factors ranging from 1.2–2.9 for the lowest level, 1.3–4.9 intermediate level and 1.2–3.0 highest level (n = 3). Although the analytes were not detected in the real samples evaluated, the method has demonstrated to be efficient through its application in the analysis of spiked triazines in ground and mineral water samples.


  • The role of graphene‐based sorbents in modern sample preparation techniques

    by Ana Lúcia De Toffoli, Edvaldo Vasconcelos Soares Maciel, Bruno Henrique Fumes, Fernando Mauro Lanças

    The application of graphene‐based sorbents in sample preparation techniques has increased significantly since 2011. These materials have good physicochemical properties to be used as sorbent and have shown excellent results in different sample preparation techniques. Graphene and its precursor graphene oxide have been considered to be good candidates to improve the extraction and concentration of different classes of target compounds (e.g., parabens, polycyclic aromatic hydrocarbon, pyrethroids, triazines, and so on) present in complex matrices. Its applications have been employed during the analysis of different matrices (e.g., environmental, biological and food). In this review, we highlight the most important characteristics of graphene‐based material, their properties, synthesis routes, and the most important applications in both off‐line and on‐line sample preparation techniques. The discussion of the off‐line approaches includes methods derived from conventional solid‐phase extraction focusing on the miniaturized magnetic and dispersive modes. The modes of microextraction techniques called stir bar sorptive extraction, solid phase microextraction, and microextraction by packed sorbent are discussed. The on‐line approaches focus on the use of graphene‐based material mainly in on‐line solid phase extraction, its variation called in‐tube solid‐phase microextraction, and on‐line microdialysis systems.


  • Development, validation, and application of a method for the GC-MS analysis of fipronil and three of its degradation products in samples of water, soil, and sediment

    by Ana L. de Toffoli, Kamilla da Mata, Márcia C. Bisinoti, Altair B. Moreira

    A method for the identification and quantification of pesticide residues in water, soil, and sediment samples has been developed, validated, and applied for the analysis of real samples. The specificity was determined by the retention time and the confirmation and quantification of analyte ions. Linearity was demonstrated over the concentration range of 20 to 120 µg L(-1), and the correlation coefficients varied between 0.979 and 0.996, depending on the analytes. The recovery rates for all analytes in the studied matrix were between 86% and 112%. The intermediate precision and repeatability were determined at three concentration levels (40, 80, and 120 µg L(-1)), with the relative standard deviation for the intermediate precision between 1% and 5.3% and the repeatability varying between 2% and 13.4% for individual analytes. The limits of detection and quantification for fipronil, fipronil sulfide, fipronil-sulfone, and fipronil-desulfinyl were 6.2, 3.0, 6.6, and 4.0 ng L(-1) and 20.4, 9.0, 21.6, and 13.0 ng L(-1), respectively. The method developed was used in water, soil, and sediment samples containing 2.1 mg L(-1) and 1.2% and 5.3% of carbon, respectively. The recovery of pesticides in the environmental matrices varied from 88.26 to 109.63% for the lowest fortification level (40 and 100 µg kg(-1)), from 91.17 to 110.18% for the intermediate level (80 and 200 µg kg(-1)), and from 89.09 to 109.82% for the highest fortification level (120 and 300 µg kg(-1)). The relative standard deviation for the recovery of pesticides was under 15%.


  • Off-line TMAH-GC/MS and NMR characterization of humic substances extracted from river sediments of northwestern São Paulo under different soil uses

    by Amanda Maria Tadini, Glaucia Pantano, Ana Lúcia de Toffoli, Barbara Fontaine, Riccardo Spaccini, Alessandro Piccolo, Altair Benedito Moreira, Márcia Cristina Bisinoti


  • Synthesis and characterization of cross-linked molecularly imprinted polyacrylamide for the extraction/preconcentration of glyphosate and aminomethylphosphonic acid from water samples

    by Kamilla da Mata, Marcela Zanetti Corazza, Fernanda Midori de Oliveira, Ana Lúcia de Toffoli, César Ricardo Teixeira Tarley, Altair Benedito Moreira


  • Open Access

    Solar radiation effect on the complexation capacity of aquatic humic substances with metals

    by Camila A. Melo, Ana L. De Toffoli, Altair B. Moreira, Márcia C. Bisinoti

    This study had as main objective to assess the effect of solar radiation on the capacity of the aquatic humic substances (AHS) to complex Al3+, Cr3+, CrO42- and Ni2+. Microcosms were prepared with AHS from Preto River containing 5.0 mg L-1 of dissolved organic carbon and different concentrations of metal species, being exposed to solar radiation, in situ. Conditional stability constants obtained for the AHS-Cr3+, AHS-Ni2+ and AHS-CrO42- complexes were 2.0 x 10(-2), 1.1 x 10(-5) and 2.6 x 10(-2), respectively. The results showed that solar radiation is responsible for decreasing capacity complexation in 15-26% for AHS-Al3+, 15-72% for AHS-Cr3+, 12-18% for AHS-CrO42- and 13-42% for AHS-Ni2+. We can conclude that solar radiation alters metals' availability previously complexed to AHS, making them available in the aquatic body