HDHsu-Kang Dow

Hsu-Kang Dow

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Hsu-Kang Dow has a total of 21 co-authors. Here are the top co-authors by number of shared publications:

  • Chun-Hung Lai

    Information and Communications Research Laboratories, Industrial Technology Research Institute, Hsinchu 31057, Taiwan

    2 shared publications
  • Ing-Jer Huang

    Dept. Computer Science and Engineering, National Sun Yat-sen University, Kaohsiung, Taiwan

    2 shared publications
  • Ching-Hua Huang

    Department of Computer Science and Engineering, National Sun Yat-Sen University, Kaohsiung, Taiwan, R.O.C.

    1 shared publication
  • Chung-Nan Lee

    Department of Computer Science and Engineering, National Sun Yat-Sen University, Kaohsiung, Taiwan, R.O.C.

    1 shared publication
  • Da-Jing Zhang Jain

    Department of Computer Science and Engineering, National Sun Yat-Sen University, Kaohsiung, Taiwan, R.O.C.

    1 shared publication
  • Ho-Chun Yang

    Department of Computer Science and Engineering, National Sun Yat-Sen University, Kaohsiung, Taiwan, R.O.C.

    1 shared publication

Latest Publications

  • A Bio-Sensing System-on-Chip and Software for Smart Clothes

    by Hsu-Kang Dow, Ing-Jer Huang, Robert Rieger, Ko-Chi Kuo, Lan-Yuen Guo, Shih-Jung Pao

    In this paper, we present a bionic sensing system that monitor electromyography (EMG), electrocardiogram (ECG), vibration, and temperature for elderly care. The bionic sensor system contains analog front-end circuits (AFE) including sensor read-out circuit for bio-potential signal pickup, a piezo wave sensing circuit for vibration sensing, a low-power analog-to-digital (ADC) circuit with pulse-width modulation (PWM) digital signal output and a bandgap circuit for temperature tracking. For digital signal processing, we integrated a digital signal controller for AFE control and calibration, an ARM-like microprocessor (SYS32TM) for compression and communication. Finally, a phase-lock loop (PLL) circuit for system clock generating and power on reset, The analog and digital part of the chip has been tape-out separately. Analog circuit is integrated and tested with Xilinx Zynq System-on-Module (SoM). This verification platform is versatile for development while maintaining small form factor for user to wear the system while recording the bio-signals. The sensor system is currently used in elderly care and precision sport study.


  • A Reconfigurable Cache for Efficient Use of Tag RAM as Scratch-Pad Memory

    by Ing-Jer Huang, Chun-Hung Lai, Yun-Chung Yang, Hsu-Kang Dow, Hung-Lun Chen

    The cache memory has been a predominant component in modern chips, easily taking up more than 50% of the silicon area. It is then desirable to make the cache memory flexible for different needs. Therefore, many modern processor chips allow users to configure a part of the cache memory as the scratch-pad memory (SPM), a high-speed internal memory for rapid data access. However, such approach uses only the data RAM of the cache memory while leaving the tag RAM unused and thus wasting its capacity. This paper presents a cache organization, called Tag-SPM architecture, which allows the tag RAM to be used as the SPM and thus increases its capacity. It is accomplished with small Tag/Data-SPM controllers and four additional multiplexers in the cache organization. The proposed Tag-SPM architecture has been implemented with an academic ARM-based microprocessor with 4-/4-kB four-way set-associative instruction/data caches at the register transfer level level. Experiments show that the proposed architecture boosts the SPM capacity by 12.5% and requires only 0.08% area (434 gates) overhead without impairing the cache's circuit speed in TSMC's 90-nm standard cell implementation. Furthermore, the power overhead is negligible. When the Tag-SPM architecture is applied to typical cache systems, such as in ARM's Cortex-A5 and Cortex-A53 processors, additional 12.5% SPM space per way can also be gained in both cases. The analyses show that our Tag-SPM architecture is a highly cost-effective way to boost the SPM space.


  • An OpenGL ES 2.0 3D graphics SoC with versatile HW/SW development support

    by Hsu-Kang Dow, Ching-Hua Huang, Chun-Hung Lai, Kai-Hsiang Tsao, Sheng-Chih Tseng, Kun-Yi Wu, Ting-Hsuan Wu, Ho-Chun Yang, Da-Jing Zhang Jain, Yun-Nan Chang, et al.

    A multi-threaded programmable shader pipeline 3D graphics SoC with support for OpenGL ES 2.0 has been developed and fabricated. The sample chip is ARMv4T compatible with the 3D processing capability of 14.9 Mvertices/s, 3.6 Mpixels/s and up to 4K resolution. The die size is 3.85×3.85 mm 2 , with 2.96M gates on a TSMC 90nm CMOS 1P9M. This new SoC includes software to support OpenGL ES API libraries, GLSL compilation and simulation. The SoC also comes with various development tools, including GPU simulators for hardware validation, profile assisted compiler optimization and compiler verification. For developers, we also present a QEMU-based simulation platform and SoC Performance Monitoring Tool Suite (PMTS) to assist developers in optimizing the system and detecting performance bottlenecks.