André Luiz Alvarenga Santos
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
André Luiz Alvarenga Santos has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Sônia Denise Ferreira Rocha
Department of Mining Engineering, Universidade Federal de Minas Gerais (UFMG), Belo Horizonte 31270-901, Brazil
7 shared publications - Elbert Muller Nigri
SENAI Innovation and Technology Center (CIT-SENAI), Belo Horizonte 31035-536, Brazil
6 shared publications - Leonardo Junior Fernandes Campos
Curso de Pós-Graduação em Engenharia Metalúrgica, Materiais e de Minas-Mestrado Profissional (CPGEM), Universidade Federal de Minas Gerais (UFMG), Belo Horizonte 31270-901, MG, Brazil
2 shared publications - Amit Bhatnagar
Department of Separation Science, LUT School of Engineering Science, LUT University, Sammonkatu 12, FI-50130, Mikkeli, Finland
1 shared publication - Bruno C. M. Miguel
Universidade Federal de Minas Gerais
1 shared publication - Cláudia Duarte da Conceição
Universidade do Estado de Minas Gerais – UEMG
1 shared publication
Latest Publications
- Open Access
- 5 February 2026
- Published by Elsevier in Minerals Engineering
- Vol. 240
Assessing the specific energy for two iron ores using steel, ceramic and mixed steel-ceramic ball charges in fine grinding
- 5 February 2026
- Published by Elsevier in Minerals Engineering
- Vol. 240
Open AccessAssessing the specific energy for two iron ores using steel, ceramic and mixed steel-ceramic ball charges in fine grinding
- Open Access
Life Cycle Assessment of Fluoride Removal from Mining Effluents Using Electrocoagulation and Biogenic CO2
Fluoride-containing wastewater poses a significant environmental challenge, especially in the mineral processing sector. This study applies a life cycle assessment (LCA) to evaluate an electrocoagulation-based treatment process, integrating biogas-derived CO2 for pH regulation and cogeneration of electricity, using the Egalitarian perspective, which is the most precautionary that takes into account the longest time frame and impact types that are not yet fully established but for which some indication is available. The LCA considered five subsystems: electrocoagulation, pH adjustment, sedimentation, pumping, and sludge transport, across three operational scenarios. Scenario 1 (S1) employed hydrochloric acid for pH control, Scenario 2 (S2) used biogas exclusively for pH regulation, and Scenario 3 (S3) combined biogas-based pH adjustment with power generation. Results showed an environmental impact ranking of S3 < S1 < S2, with S3 reducing overall impacts from 12.5 Pt to 6.4 Pt compared to S1. The electrocoagulation unit was the dominant contributor to environmental burdens; however, in S3, the pH adjustment subsystem delivered a net environmental benefit through surplus electricity generation. Additionally, sludge reuse as a raw material for brick production, implemented in all scenarios, further mitigated impacts. Human health emerged as the most affected endpoint, driven mainly by toxicity (carcinogenic and non-carcinogenic), climate change potential, marine ecotoxicity, and particulate matter formation. These findings highlight the benefits of integrating biogas utilization and sludge valorization into industrial wastewater management strategies.
Open AccessLife Cycle Assessment of Fluoride Removal from Mining Effluents Using Electrocoagulation and Biogenic CO2
Fluoride-containing wastewater poses a significant environmental challenge, especially in the mineral processing sector. This study applies a life cycle assessment (LCA) to evaluate an electrocoagulation-based treatment process, integrating biogas-derived CO2 for pH regulation and cogeneration of electricity, using the Egalitarian perspective, which is the most precautionary that takes into account the longest time frame and impact types that are not yet fully established but for which some indication is available. The LCA considered five subsystems: electrocoagulation, pH adjustment, sedimentation, pumping, and sludge transport, across three operational scenarios. Scenario 1 (S1) employed hydrochloric acid for pH control, Scenario 2 (S2) used biogas exclusively for pH regulation, and Scenario 3 (S3) combined biogas-based pH adjustment with power generation. Results showed an environmental impact ranking of S3 < S1 < S2, with S3 reducing overall impacts from 12.5 Pt to 6.4 Pt compared to S1. The electrocoagulation unit was the dominant contributor to environmental burdens; however, in S3, the pH adjustment subsystem delivered a net environmental benefit through surplus electricity generation. Additionally, sludge reuse as a raw material for brick production, implemented in all scenarios, further mitigated impacts. Human health emerged as the most affected endpoint, driven mainly by toxicity (carcinogenic and non-carcinogenic), climate change potential, marine ecotoxicity, and particulate matter formation. These findings highlight the benefits of integrating biogas utilization and sludge valorization into industrial wastewater management strategies.
- Open Access
- 1 January 2025
- Published by Editora Cubo in Tecnologia em Metalurgia, Materiais e Mineração
- Vol. 22, e3214
Fault detection in a ball mill circuit using principal component analysis
Tecnol. Metal. Mater. Min., vol.22, e3214, 2025
- 1 January 2025
- Published by Editora Cubo in Tecnologia em Metalurgia, Materiais e Mineração
- Vol. 22, e3214
Open AccessFault detection in a ball mill circuit using principal component analysis
Tecnol. Metal. Mater. Min., vol.22, e3214, 2025
- 19 November 2024
- Published by Springer Nature
- p. 253-259
Simultaneous Removal of Arsenic and Sulfate from Mining Wastewater by Ettringite Precipitation
- 19 November 2024
- Published by Springer Nature
- p. 253-259
Simultaneous Removal of Arsenic and Sulfate from Mining Wastewater by Ettringite Precipitation
- Open Access
- 10 October 2023
- Published by Springer Nature in Tungsten
- Vol. 6 (2) , 367-381
Nickel sulfate solution fluoride separation with hydrous zirconium oxide
Fluoride is an impurity in nickel sulfate production, which is required for electric vehicle batteries. Hydrous zirconium oxide (HZO) was evaluated for removing fluoride from nickel sulfate solution. Maximum fluoride removal occurred at pH value 4 and optimal pH value is 4–5, considering Zr solubility. Fluoride availability decreases with pH due to hydrogen fluoride and zirconium fluoride aqueous species. Fluoride removal is initially rapid, with 50 wt.% removal in 7 min, followed by slow removal up to 68 wt.% after 72 h and follows second order rate kinetics. Fluoride removal was dominated by an ion exchange mechanism and resulting Zr–F bonds were observed using Fourier-transform infrared spectroscopy. The presence of nickel sulfate decreased loading capacity compared to a salt-free solution. HZO maintained adsorption capacity through five cycles of loading and regeneration.
- 10 October 2023
- Published by Springer Nature in Tungsten
- Vol. 6 (2) , 367-381
Open AccessNickel sulfate solution fluoride separation with hydrous zirconium oxide
Fluoride is an impurity in nickel sulfate production, which is required for electric vehicle batteries. Hydrous zirconium oxide (HZO) was evaluated for removing fluoride from nickel sulfate solution. Maximum fluoride removal occurred at pH value 4 and optimal pH value is 4–5, considering Zr solubility. Fluoride availability decreases with pH due to hydrogen fluoride and zirconium fluoride aqueous species. Fluoride removal is initially rapid, with 50 wt.% removal in 7 min, followed by slow removal up to 68 wt.% after 72 h and follows second order rate kinetics. Fluoride removal was dominated by an ion exchange mechanism and resulting Zr–F bonds were observed using Fourier-transform infrared spectroscopy. The presence of nickel sulfate decreased loading capacity compared to a salt-free solution. HZO maintained adsorption capacity through five cycles of loading and regeneration.
- 31 December 2021
- Published by Taylor & Francis in Journal of Environmental Science and Health, Part A
- Vol. 57 (1) , 18-27
Biogas and calcite handling in calcium fluoride precipitation from aqueous solution guided by thermodynamic simulation with PHREEQC
In this innovative study, biogas has been associated with calcium carbonate [CaCO3] to promote the precipitation of fluorite, aiming at the treatment of wastewater with high content of fluoride. The work associates distinct sources of calcium and CO2 for the precipitation of fluorite according to previous simulation with the free software PHREEQC. Considering the reaction at equilibrium, the minimal predicted Ca dosage was 215 mg/L, lower than the 430 mg/L that was experimentally determined, independent of Ca source. The simultaneous use of CaCO3 and CO2 from distinct gas sources (pure CO2, 1:1 CO2:N2, and biogas) exhibited high performance permitting the reduction of fluoride content from 134 to 10 mg/L, with low gas consumption. The biogas consumption of 66.0 mmol/L, equivalent to 33.4 mmol/L of CO2 (1.47 kgCO2/m3treated wastewater) was predicted, indicating that the biogas storage bag of 700 L would be able to treat 469 L of wastewater. Furthermore, the inert fraction of biogas (CH4) did not impact the reaction and it may be used after the reaction as an alternative source of power, equivalent to 8.25 kWh/m3treated wastewater. Final solids were composed by fluorite and non-dissolved calcite, confirming the predictions obtained by PHREEQC.
- 31 December 2021
- Published by Taylor & Francis in Journal of Environmental Science and Health, Part A
- Vol. 57 (1) , 18-27
Biogas and calcite handling in calcium fluoride precipitation from aqueous solution guided by thermodynamic simulation with PHREEQC
In this innovative study, biogas has been associated with calcium carbonate [CaCO3] to promote the precipitation of fluorite, aiming at the treatment of wastewater with high content of fluoride. The work associates distinct sources of calcium and CO2 for the precipitation of fluorite according to previous simulation with the free software PHREEQC. Considering the reaction at equilibrium, the minimal predicted Ca dosage was 215 mg/L, lower than the 430 mg/L that was experimentally determined, independent of Ca source. The simultaneous use of CaCO3 and CO2 from distinct gas sources (pure CO2, 1:1 CO2:N2, and biogas) exhibited high performance permitting the reduction of fluoride content from 134 to 10 mg/L, with low gas consumption. The biogas consumption of 66.0 mmol/L, equivalent to 33.4 mmol/L of CO2 (1.47 kgCO2/m3treated wastewater) was predicted, indicating that the biogas storage bag of 700 L would be able to treat 469 L of wastewater. Furthermore, the inert fraction of biogas (CH4) did not impact the reaction and it may be used after the reaction as an alternative source of power, equivalent to 8.25 kWh/m3treated wastewater. Final solids were composed by fluorite and non-dissolved calcite, confirming the predictions obtained by PHREEQC.
- 7 October 2020
- Published by Springer Nature in Mining, Metallurgy & Exploration
- Vol. 38 (1) , 187-201
Kinetics of Atmospheric Leaching from a Brazilian Nickel Laterite Ore Allied to Redox Potential Control
- 7 October 2020
- Published by Springer Nature in Mining, Metallurgy & Exploration
- Vol. 38 (1) , 187-201
Kinetics of Atmospheric Leaching from a Brazilian Nickel Laterite Ore Allied to Redox Potential Control
- Open Access
- 1 December 2019
- Published by FapUNIFESP (SciELO) in Brazilian Journal of Chemical Engineering
- Vol. 36 (4) , 1631-1643
CHEMICAL REGENERATION OF BONE CHAR ASSOCIATED WITH A CONTINUOUS SYSTEM FOR DEFLUORIDATION OF WATER
- 1 December 2019
- Published by FapUNIFESP (SciELO) in Brazilian Journal of Chemical Engineering
- Vol. 36 (4) , 1631-1643
Open AccessCHEMICAL REGENERATION OF BONE CHAR ASSOCIATED WITH A CONTINUOUS SYSTEM FOR DEFLUORIDATION OF WATER