Xing Gao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Xing Gao has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Xiaodong Wang
Shenyang University of Technology
3 shared publications - Yingming Liu
Shenyang University of Technology
2 shared publications - Ruojin Wang
College of Electrical Engineering, Shenyang University of Technology, Shenyang 110178, China
1 shared publication - Yingming Liu
School of Electrical Engineering, Shenyang University of Technology, Shenyang, China
1 shared publication - Yingwei Wang
Institute of Electrical Engineering, Shenyang University of Technology, Shenyang 110870, China
1 shared publication - Yonghao Wang
Institute of Electrical Engineering Shenyang University of Technology Shenyang 110870 China
1 shared publication
Latest Publications
- 22 March 2023
- Published by Springer Nature in Journal of Electrical Engineering & Technology
- Vol. 18 (6) , 4011-4023
Impedance Ground Faults Detection and Classification Method for DC Microgrid
- 22 March 2023
- Published by Springer Nature in Journal of Electrical Engineering & Technology
- Vol. 18 (6) , 4011-4023
Impedance Ground Faults Detection and Classification Method for DC Microgrid
- Open Access
- 16 April 2021
- Published by Institution of Engineering and Technology (IET) in IET Renewable Power Generation
- Vol. 15 (11) , 2368-2382
Stockwell‐transform and random‐forest based double‐terminal fault diagnosis method for offshore wind farm transmission line
Due to the difficulty and time‐consumption in locating short‐distance transmission lines for deep‐sea offshore wind farm (DOWF),this paper proposes a novel double‐terminal fault location method by using Stockwell‐transform (ST) and random‐forest (RF). After the fault type and branch are accurately determined, the accurate transmission line fault location is located. Firstly, Stockwell‐transform is employed to extract fault eigenvalues from the collected wind turbine (WT) current signals, which will reduce the sensitivity of eigenvalues to noise. And the Pearson correlation coefficient (PCC) is introduced to remove duplicate eigenvalues. Secondly, the reserved fault eigenvalues are taken as inputs to the different random‐forest to classify fault types and identify the fault branch, respectively. Finally, the double‐terminal fault location principle is established in fault negative sequence network (only ABCG uses positive sequence components). Newton‐Raphson method (NRM) is used to eliminate the influence of asynchrony data, which implies an accurate transmission line fault location for deep‐sea offshore wind farm. More than 4000 fault cases data obtained by Simulink simulation verify the feasibility and performance of the proposed method. The results show that the proposed location method has a high fault recognition rate and is immune to fault inception angle, resistance, location and noise.
- 16 April 2021
- Published by Institution of Engineering and Technology (IET) in IET Renewable Power Generation
- Vol. 15 (11) , 2368-2382
Open AccessStockwell‐transform and random‐forest based double‐terminal fault diagnosis method for offshore wind farm transmission line
Due to the difficulty and time‐consumption in locating short‐distance transmission lines for deep‐sea offshore wind farm (DOWF),this paper proposes a novel double‐terminal fault location method by using Stockwell‐transform (ST) and random‐forest (RF). After the fault type and branch are accurately determined, the accurate transmission line fault location is located. Firstly, Stockwell‐transform is employed to extract fault eigenvalues from the collected wind turbine (WT) current signals, which will reduce the sensitivity of eigenvalues to noise. And the Pearson correlation coefficient (PCC) is introduced to remove duplicate eigenvalues. Secondly, the reserved fault eigenvalues are taken as inputs to the different random‐forest to classify fault types and identify the fault branch, respectively. Finally, the double‐terminal fault location principle is established in fault negative sequence network (only ABCG uses positive sequence components). Newton‐Raphson method (NRM) is used to eliminate the influence of asynchrony data, which implies an accurate transmission line fault location for deep‐sea offshore wind farm. More than 4000 fault cases data obtained by Simulink simulation verify the feasibility and performance of the proposed method. The results show that the proposed location method has a high fault recognition rate and is immune to fault inception angle, resistance, location and noise.
- Open Access
- 17 March 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 53547-53560
WRC-SDT Based On-Line Detection Method for Offshore Wind Farm Transmission Line
Transmission line fault detection is a complex, high-cost and time-consuming work for deep-sea offshore wind farms. Therefore, rapid intelligent on-line fault detection and classification of submarine transmission lines play a very important role in the offshore wind farm reliability improving and operating costs reduction. This paper presents a novel hybrid on-line detection method that combines Wavelet noise Reduction, Clarke transform, Stockwell transform and Decision Tree (WRC-SDT). First, the measured Wind Turbine (WT) voltage signals are processed through wavelet noise reduction and Clarke transform to get the gradient of the voltage component. The gradient of the voltage component is then monitored in order to detect faults. Second, the recorded WT current date are processed through Stockwell transform with a view to obtaining the transmission line fault eigenvalues. The fault eigenvalues are then taken as the input of decision tree in order to classify different types of faults. To verify the feasibility and performance of the proposed method, the comparison of a detection and classification result is presented based on more than 1600 fault simulation data. The results show that WRC-SDT method is immune to fault resistance, starting angle and location. The proposed method is also robust to measurement noise.
- 17 March 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 53547-53560
Open AccessWRC-SDT Based On-Line Detection Method for Offshore Wind Farm Transmission Line
Transmission line fault detection is a complex, high-cost and time-consuming work for deep-sea offshore wind farms. Therefore, rapid intelligent on-line fault detection and classification of submarine transmission lines play a very important role in the offshore wind farm reliability improving and operating costs reduction. This paper presents a novel hybrid on-line detection method that combines Wavelet noise Reduction, Clarke transform, Stockwell transform and Decision Tree (WRC-SDT). First, the measured Wind Turbine (WT) voltage signals are processed through wavelet noise reduction and Clarke transform to get the gradient of the voltage component. The gradient of the voltage component is then monitored in order to detect faults. Second, the recorded WT current date are processed through Stockwell transform with a view to obtaining the transmission line fault eigenvalues. The fault eigenvalues are then taken as the input of decision tree in order to classify different types of faults. To verify the feasibility and performance of the proposed method, the comparison of a detection and classification result is presented based on more than 1600 fault simulation data. The results show that WRC-SDT method is immune to fault resistance, starting angle and location. The proposed method is also robust to measurement noise.