Xingmin Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Xingmin Liu has a total of 37 co-authors. Here are the top co-authors by number of shared publications:
Anke Weidenkaff
5 shared publicationsMinghang Li
State Key Laboratory of Solidification Processing Northwestern Polytechnical University Xi'an China
5 shared publicationsGuohong Wang
State Key Laboratory of Solidification Processing Northwestern Polytechnical University Xi'an China
3 shared publicationsHeqiang Liu
State Key Laboratory of Solidification Processing Northwestern Polytechnical University Xi'an China
3 shared publications- Ralf Riedel
Institute of Materials Science Technical University of Darmstadt Darmstadt Germany
3 shared publications Wenjie Xie
Institute of Materials Science Technical University of Darmstadt Darmstadt Germany
3 shared publications
Latest Publications
- Open Access
- 18 April 2023
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 106 (8) , 4931-4943
Temperature‐dependent mechanical and oxidation behavior of in situ formed ZrN/ZrO 2 ‐containing Si 3 N 4 ‐based composite
In this work, Si 3 N 4 and Zr(NO 3 ) 4 were used as raw materials to prepare ZrN/ZrO 2 ‐containing Si 3 N 4 ‐based ceramic composite. The processing, phase composition, and microstructure of the composite were investigated. Hardness and fracture toughness of the ceramics were evaluated via Vickers indentation in Ar at 25°C, 300°C, 600°C, and 900°C. During spark plasma sintering, Zr(NO 3 ) 4 was transformed into tetragonal ZrO 2 , which further reacted with Si 3 N 4 , resulting in the formation of ZrN. The introduction of ZrN enhanced the high‐temperature mechanical properties of the composite, and its hardness and fracture toughness reached 13.4 GPa and 6.1 MPa·m 1/2 at 900°C, respectively. The oxidation experiment was carried out in air at 1000°C, 1300°C, and 1500°C for 5 h. It was shown that high‐temperature oxidation promoted the formation and growth of porous oxide layers. The microstructure and phase composition of the formed oxide layers were investigated in detail. Finally, it was identified that the obtained composite exhibited a higher thermal diffusivity than that of monolithic Si 3 N 4 in the temperature range of 100°C–1000°C.
- 18 April 2023
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 106 (8) , 4931-4943
Open AccessTemperature‐dependent mechanical and oxidation behavior of in situ formed ZrN/ZrO 2 ‐containing Si 3 N 4 ‐based composite
In this work, Si 3 N 4 and Zr(NO 3 ) 4 were used as raw materials to prepare ZrN/ZrO 2 ‐containing Si 3 N 4 ‐based ceramic composite. The processing, phase composition, and microstructure of the composite were investigated. Hardness and fracture toughness of the ceramics were evaluated via Vickers indentation in Ar at 25°C, 300°C, 600°C, and 900°C. During spark plasma sintering, Zr(NO 3 ) 4 was transformed into tetragonal ZrO 2 , which further reacted with Si 3 N 4 , resulting in the formation of ZrN. The introduction of ZrN enhanced the high‐temperature mechanical properties of the composite, and its hardness and fracture toughness reached 13.4 GPa and 6.1 MPa·m 1/2 at 900°C, respectively. The oxidation experiment was carried out in air at 1000°C, 1300°C, and 1500°C for 5 h. It was shown that high‐temperature oxidation promoted the formation and growth of porous oxide layers. The microstructure and phase composition of the formed oxide layers were investigated in detail. Finally, it was identified that the obtained composite exhibited a higher thermal diffusivity than that of monolithic Si 3 N 4 in the temperature range of 100°C–1000°C.
- 28 September 2022
- Published by Wiley in International Journal of Applied Ceramic Technology
- Vol. 20 (1) , 251-260
Advanced Ti 3 C 2 T x MXene‐modified cement nanocomposites toward high efficiency electromagnetic functional materials for green buildings
The proliferation of electronic devices and wireless communication is leading to serious electromagnetic (EM) interference. In this work, Ti 3 C 2 /cement composites were developed as high efficiency EM functional materials by introducing exfoliated Ti 3 C 2 T x MXene with cement for green buildings with EM shielding function. In the composites, few‐layered Ti 3 C 2 MXene were dispersed homogeneously throughout the cement matrix. The EM properties of the composites were studied as a function of the MXene content. With increasing MXene content, real and imaginary part of permittivity was significantly improved owing to the polarization and electrical conduction caused by the MXene phase. Composites with 15 wt.% MXene showed good EM absorbing properties with a maximum effective absorbing bandwidth of 2.67 GHz. Strong EM shielding can be achieved when MXene content increased to 25 wt.%. The EM shielding effectiveness of such composites was higher than 22.0 dB, and the dominating shielding mechanism was EM absorption. This work finds new materials for the development of advanced green buildings with EM shielding function.
- 28 September 2022
- Published by Wiley in International Journal of Applied Ceramic Technology
- Vol. 20 (1) , 251-260
Advanced Ti 3 C 2 T x MXene‐modified cement nanocomposites toward high efficiency electromagnetic functional materials for green buildings
The proliferation of electronic devices and wireless communication is leading to serious electromagnetic (EM) interference. In this work, Ti 3 C 2 /cement composites were developed as high efficiency EM functional materials by introducing exfoliated Ti 3 C 2 T x MXene with cement for green buildings with EM shielding function. In the composites, few‐layered Ti 3 C 2 MXene were dispersed homogeneously throughout the cement matrix. The EM properties of the composites were studied as a function of the MXene content. With increasing MXene content, real and imaginary part of permittivity was significantly improved owing to the polarization and electrical conduction caused by the MXene phase. Composites with 15 wt.% MXene showed good EM absorbing properties with a maximum effective absorbing bandwidth of 2.67 GHz. Strong EM shielding can be achieved when MXene content increased to 25 wt.%. The EM shielding effectiveness of such composites was higher than 22.0 dB, and the dominating shielding mechanism was EM absorption. This work finds new materials for the development of advanced green buildings with EM shielding function.
- Open Access
- 1 January 2022
- Published by Elsevier in SSRN Electronic Journal
Oxidation-Resistant Vitamin C/Mxene Foam Via Surface Hydrogen Bonding for Stable Electromagnetic Interference Shielding in Air Ambient
MXenes have been in the spotlight of interest as electromagnetic (EM) functional materials. However, the susceptibility of MXenes leads to fast fading in EM interference shielding effectiveness (EMI SE). In this work, oxidation-resistant vitamin C/Ti 3 C 2 T X foam composite was developed as an EMI shielding material. The vitamin C/Ti 3 C 2 T X foam composites exhibited an improved EM SE stability due to the protection of vitamin C by donating electrons. After exposing to air for 10 days, the EMI SE of vitamin C/Ti 3 C 2 T X foam decreased from 42.5 dB to 41 dB while the EMI SE of Ti 3 C 2 T X foam dropped from 47 dB to 35 dB. The EMI SE of vitamin C/Ti 3 C 2 T X foam and Ti 3 C 2 T X foam decreased correspondingly with a further increase in air exposure time. However, the decreasing rate of vitamin C/Ti 3 C 2 T X foam is always slower than that of the Ti 3 C 2 T X foam. This work offers an effective way of designing oxidation-resistant MXene-based EMI shielding materials.
- 1 January 2022
- Published by Elsevier in SSRN Electronic Journal
Open AccessOxidation-Resistant Vitamin C/Mxene Foam Via Surface Hydrogen Bonding for Stable Electromagnetic Interference Shielding in Air Ambient
MXenes have been in the spotlight of interest as electromagnetic (EM) functional materials. However, the susceptibility of MXenes leads to fast fading in EM interference shielding effectiveness (EMI SE). In this work, oxidation-resistant vitamin C/Ti 3 C 2 T X foam composite was developed as an EMI shielding material. The vitamin C/Ti 3 C 2 T X foam composites exhibited an improved EM SE stability due to the protection of vitamin C by donating electrons. After exposing to air for 10 days, the EMI SE of vitamin C/Ti 3 C 2 T X foam decreased from 42.5 dB to 41 dB while the EMI SE of Ti 3 C 2 T X foam dropped from 47 dB to 35 dB. The EMI SE of vitamin C/Ti 3 C 2 T X foam and Ti 3 C 2 T X foam decreased correspondingly with a further increase in air exposure time. However, the decreasing rate of vitamin C/Ti 3 C 2 T X foam is always slower than that of the Ti 3 C 2 T X foam. This work offers an effective way of designing oxidation-resistant MXene-based EMI shielding materials.
- 1 January 2022
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 606 (Pt 2) , 1543-1553
Natural wood templated hierarchically cellular NbC/Pyrolytic carbon foams as Stiff, lightweight and High-Performance electromagnetic shielding materials
- 1 January 2022
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 606 (Pt 2) , 1543-1553
Natural wood templated hierarchically cellular NbC/Pyrolytic carbon foams as Stiff, lightweight and High-Performance electromagnetic shielding materials