Dong-Hyun Tae

Generally, PV (photovoltaic) modules are known as devices which are used semi-permanently for more than 20 years, but the electrical performance and lifespan of PV modules can be significantly degraded due to various environmental factors. Thus, a proper evaluation method for aging phenomenon of PV modules is required. Although there already are methods which compare adjusted PV output power based on STC (standard test condition) with initial PV module specification, or perform direct comparison by conducting the test under STC, there are issues with objectivity or efficiency in the existing evaluation method of aging phenomenon due to the data distortion while adjusting measured data or difficulties in implementation. Therefore, in order to overcome the above-mentioned disadvantage of the existing evaluation method for deterioration in PV modules and evaluate the aging characteristics of PV modules based on on-site measurement data in an accurate and efficient manner, this paper implements a test device for aging diagnosis to measure and collect actual data from a PV module section, and presents a modeling of data analysis for aging phenomenon with MATLAB S/W in order to minimize the variability of PV output, communication error, delay, etc. Furthermore, this paper confirms the usefulness of the presented test device for aging diagnosis of the PV modules which is accurately evaluated by considering on-site measurement of PV output power by season.

In recent years, there have been several types of energy storage technologies adopted in many different areas, such as peak shaving, frequency regulation, and renewable stabilization applications. Moreover, technologies of high energy and power density are useful for load leveling, power smoothing for renewable energy systems (RESs), and peak shaving for demand management. Under these circumstances, an estimation technique for assessing environmental issues applied to electrical energy storage (EES) systems is essential in order to promote commercialization of EES systems. Therefore, this paper proposes an estimation method for CO₂ emission in cases where EES systems are introduced and not introduced. It is essential to evaluate environmental issues in EES systems at operation stages of their life cycle and make an effective contribution to environmental improvement and reduce potential adverse environmental impacts. Thus, this paper deals with an evaluation method for CO₂ emission based on an optimal algorithm including a successive approximation method for the best-mix solution of power sources, etc. From the simulation result based on the proposed evaluation algorithm, it is found that the output power of a coal power plant (high CO₂ emission) is replaced by the output powers of the EES systems and the nuclear generator (low CO₂ emission).

The Korean national policies have enforced to spread the RES (renewable energy sources) as one of the alternative solutions to solve the environmental pollution problems caused by global climate change. Under these circumstances,...

This paper analyses the problem of voltage control by step voltage regulator (SVR) in the primary feeder with large-scaled PV systems, and presents operation ranges and the voltage control limit of micro hydropower generator (MHG) with...