Tianzhu Zhang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Tianzhu Zhang has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Anhong Dang
Peking University
4 shared publications - Anning Pang
State Key Laboratory of Photonics and Communications, School of Electronics, Peking University, Beijing, China
4 shared publications - Zhongji Yan
State Key Laboratory of Photonics and Communications, School of Electronics, Peking University, Beijing, China
4 shared publications - Jianping Chen
State Key Laboratory of Photonics and Communications, Department of Electronic Engineering, Shanghai Jiao Tong University, Shanghai, China
2 shared publications Junmin Xiang
State Key Laboratory of Advanced Optical Communication Systems and Networks, Shanghai Jiao Tong University, Shanghai, China
2 shared publications- Kan Wu
State Key Laboratory of Photonics and Communications, Shanghai Institute for Advanced Communication and Data Science, School of Information Science and Electronic Engineering, Shanghai Jiao Tong University, Shanghai, China
2 shared publications
Latest Publications
- 31 March 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 44 (11) , 4491-4499
Robust Phase-Time-of-Flight Coherent LiDAR With Immunity to Random Initial Phase Variations
The ongoing technological advancements drive an ever-increasing demand for high-performance and cost-effective sensors, with light detection and ranging (LiDAR) being a primary focus. Phase-modulated continuous wave (PMCW) LiDAR has emerged as a competitive candidate owing to its coherent gain and interference robustness. Inspired by conventional time-of-flight (ToF) and PMCW schemes, this paper proposes and experimentally validates a robust phase-time-of-flight (PToF) coherent LiDAR with immunity to random initial phase variations. In the proposed architecture, a pulsed ranging signal is phase-modulated onto a continuous wave laser, and the echo is coherently detected with a local oscillator (LO) for precise ranging without quadrature coherent detection—retaining coherent detection advantages while maintaining low complexity comparable to direct ToF LiDAR. A triangular pulse modulation scheme optimized at integer multiples of the phase modulator's half-wave voltage is introduced to enable initial phase immunity. The system performance and its initial-phase-immunity property are rigorously evaluated through Cramér-Rao bound (CRB) derivations, Monte Carlo simulations and experimental validations. The experimental results demonstrate an achievable ranging precision of 7.3 mm, and a maximum deviation of 2.09 cm across all measured distances. Additionally, 3D imaging is realized via two-dimensional scanning. The proposed PToF LiDAR presents a viable pathway toward high-performance, cost-effective, and highly integrated LiDAR for practical applications.
- 31 March 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 44 (11) , 4491-4499
Robust Phase-Time-of-Flight Coherent LiDAR With Immunity to Random Initial Phase Variations
The ongoing technological advancements drive an ever-increasing demand for high-performance and cost-effective sensors, with light detection and ranging (LiDAR) being a primary focus. Phase-modulated continuous wave (PMCW) LiDAR has emerged as a competitive candidate owing to its coherent gain and interference robustness. Inspired by conventional time-of-flight (ToF) and PMCW schemes, this paper proposes and experimentally validates a robust phase-time-of-flight (PToF) coherent LiDAR with immunity to random initial phase variations. In the proposed architecture, a pulsed ranging signal is phase-modulated onto a continuous wave laser, and the echo is coherently detected with a local oscillator (LO) for precise ranging without quadrature coherent detection—retaining coherent detection advantages while maintaining low complexity comparable to direct ToF LiDAR. A triangular pulse modulation scheme optimized at integer multiples of the phase modulator's half-wave voltage is introduced to enable initial phase immunity. The system performance and its initial-phase-immunity property are rigorously evaluated through Cramér-Rao bound (CRB) derivations, Monte Carlo simulations and experimental validations. The experimental results demonstrate an achievable ranging precision of 7.3 mm, and a maximum deviation of 2.09 cm across all measured distances. Additionally, 3D imaging is realized via two-dimensional scanning. The proposed PToF LiDAR presents a viable pathway toward high-performance, cost-effective, and highly integrated LiDAR for practical applications.
- 7 August 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 37 (22) , 1289-1292
Theoretical Precision Limits of LiDAR in Turbulent Channels
Atmospheric turbulence channels represent a critical factor that must be considered when developing free-space laser applications. While extensive research has been conducted on optical wireless communication (OWC) in turbulent conditions, investigations into light detection and ranging (LiDAR) in turbulent channels remain relatively unexplored. In this letter, theoretical modeling and derivations are developed to characterize the ranging and velocity precision of LiDAR in turbulent channels. The derived Cramér-Rao lower bounds (CRLBs) in Gamma-Gamma channels are verified by Monte Carlo simulation. The CRLBs reveal that, under identical signal-to-noise ratio (SNR) conditions, the precision values at a Rytov variance of 0.3 and 0.6 are 1.56 and 2.37 times those at a Rytov variance of zero for the time-of-flight (ToF) LiDAR, respectively. In the frequency-modulated continuous wave (FMCW) LiDAR system, the corresponding precision value ratios are 1.15 and 1.29. These findings enable rigorous performance evaluation and optimized design of LiDAR systems operating in turbulent environments.
- 7 August 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 37 (22) , 1289-1292
Theoretical Precision Limits of LiDAR in Turbulent Channels
Atmospheric turbulence channels represent a critical factor that must be considered when developing free-space laser applications. While extensive research has been conducted on optical wireless communication (OWC) in turbulent conditions, investigations into light detection and ranging (LiDAR) in turbulent channels remain relatively unexplored. In this letter, theoretical modeling and derivations are developed to characterize the ranging and velocity precision of LiDAR in turbulent channels. The derived Cramér-Rao lower bounds (CRLBs) in Gamma-Gamma channels are verified by Monte Carlo simulation. The CRLBs reveal that, under identical signal-to-noise ratio (SNR) conditions, the precision values at a Rytov variance of 0.3 and 0.6 are 1.56 and 2.37 times those at a Rytov variance of zero for the time-of-flight (ToF) LiDAR, respectively. In the frequency-modulated continuous wave (FMCW) LiDAR system, the corresponding precision value ratios are 1.15 and 1.29. These findings enable rigorous performance evaluation and optimized design of LiDAR systems operating in turbulent environments.
- 29 April 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 74 (00189456) , 1-11
Arbitrary Waveform Frequency Modulated Continuous Wave LiDAR System
With advantages of high-precision 3D imaging and simultaneous measurement of target distance and velocity, frequency modulated continuous wave (FMCW) LiDAR has great potential in the fields of autonomous driving, military and aerospace. However, frequency-modulated (FM) nonlinearity significantly deteriorates its ranging accuracy and has become a problem that cannot be neglected. This paper proposes an arbitrary waveform FMCW (AW-FMCW) system, in which the distance of target is extracted precisely irrespective of the FM waveform employed. In proposed AW-FMCW system, the correlation between the phase of coherent signal and the FM waveform of tunable laser is rigorously deduced and analyzed. The distance of target is extracted utilizing minimum mean square error (MMSE) estimation. The low-bandwidth short-distance (LBSD) approximation is proposed to simplify the process of the estimation and quadrature coherent detection is employed to acquire the phase signal. The performance in terms of the measured distance and the precision of AW-FMCW system is theorized in detail and validated by Monte-Carlo simulations and experiments. In the experiments, three different FM waveforms are utilized for ranging of targets at six different distances, and 0.279 mm ranging precision and 1.35×10-4 relative precision are realized at 2.06 m target detection.
- 29 April 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 74 (00189456) , 1-11
Arbitrary Waveform Frequency Modulated Continuous Wave LiDAR System
With advantages of high-precision 3D imaging and simultaneous measurement of target distance and velocity, frequency modulated continuous wave (FMCW) LiDAR has great potential in the fields of autonomous driving, military and aerospace. However, frequency-modulated (FM) nonlinearity significantly deteriorates its ranging accuracy and has become a problem that cannot be neglected. This paper proposes an arbitrary waveform FMCW (AW-FMCW) system, in which the distance of target is extracted precisely irrespective of the FM waveform employed. In proposed AW-FMCW system, the correlation between the phase of coherent signal and the FM waveform of tunable laser is rigorously deduced and analyzed. The distance of target is extracted utilizing minimum mean square error (MMSE) estimation. The low-bandwidth short-distance (LBSD) approximation is proposed to simplify the process of the estimation and quadrature coherent detection is employed to acquire the phase signal. The performance in terms of the measured distance and the precision of AW-FMCW system is theorized in detail and validated by Monte-Carlo simulations and experiments. In the experiments, three different FM waveforms are utilized for ranging of targets at six different distances, and 0.279 mm ranging precision and 1.35×10-4 relative precision are realized at 2.06 m target detection.
- Open Access
- 4 December 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 12 (6) , 1
Corrections to “Highly Reconfigurable Microwave Photonic Waveform Generation Based on Time-Wavelength Interleaving” [Dec 20 Art. no. 5502512]
- 4 December 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 12 (6) , 1
Open AccessCorrections to “Highly Reconfigurable Microwave Photonic Waveform Generation Based on Time-Wavelength Interleaving” [Dec 20 Art. no. 5502512]
- Open Access
- 21 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 12 (6) , 1-12
Highly Reconfigurable Microwave Photonic Waveform Generation Based on Time-Wavelength Interleaving
A photonic method of highly reconfigurable microwave waveform generation based on time-wavelength interleaving has been proposed and experimentally demonstrated. By modulating multi-wavelength laser sources with Mach-Zehnder modulators (MZMs), multiple Nyquist pulses corresponding to different wavelengths are generated and overlapped with each other in the time domain. A dispersion compensation fiber (DCF) is used to separate these pulses due to the wavelength dependent delay. These pulses add together after photodetection and form desired waveforms. By controlling the wavelengths and powers of multiple laser sources, we can obtain various desired waveforms with tunable repetition rates and duty cycles. Experimentally, 9 waveforms including square, triangle, sawtooth, reversed-sawtooth and trapezoid with tunable repetition rates from 3 GHz to 6 GHz and duty cycles from 20.9% to 58.4% are obtained. This work demonstrates the great potential of incoherent time-domain synthesis for highly versatile arbitrary waveform generation.
- 21 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 12 (6) , 1-12
Open AccessHighly Reconfigurable Microwave Photonic Waveform Generation Based on Time-Wavelength Interleaving
A photonic method of highly reconfigurable microwave waveform generation based on time-wavelength interleaving has been proposed and experimentally demonstrated. By modulating multi-wavelength laser sources with Mach-Zehnder modulators (MZMs), multiple Nyquist pulses corresponding to different wavelengths are generated and overlapped with each other in the time domain. A dispersion compensation fiber (DCF) is used to separate these pulses due to the wavelength dependent delay. These pulses add together after photodetection and form desired waveforms. By controlling the wavelengths and powers of multiple laser sources, we can obtain various desired waveforms with tunable repetition rates and duty cycles. Experimentally, 9 waveforms including square, triangle, sawtooth, reversed-sawtooth and trapezoid with tunable repetition rates from 3 GHz to 6 GHz and duty cycles from 20.9% to 58.4% are obtained. This work demonstrates the great potential of incoherent time-domain synthesis for highly versatile arbitrary waveform generation.