SCSara Chahid

Sara Chahid

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Sara Chahid has a total of 37 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Corrigendum: Ideal diamagnetic response at room temperature by graphene–n-heptane–permalloy system

    by Rajendra Dulal, Serafim Teknowijoyo, Sara Chahid, Vahan Nikoghosyan, Armen Gulian

    We revisit previously reported observations of apparent ideal diamagnetism in graphene–n-heptane–permalloy systems. While the initial measurements suggested a Meissner-like response, subsequent experiments revealed inconsistent behavior, including signal freezing and occasional paramagnetic responses. Similar signals were also observed in the absence of graphene, indicating that the effect is not intrinsic to the graphene layer. We show that the observed behavior can be explained by magnetic field redistribution associated with induced magnetization and inhomogeneities in the permalloy foil. In particular, the one-sided flux (Mallinson) effect provides a qualitative mechanism for suppression of the magnetic field at the sensor location, mimicking ideal diamagnetic screening. These results clarify the origin of the previously reported effect.

  • Wohlleben effect and quantum criticality in YBa1.4Sr0.6Cu3O6Se0.5 superconductor within a heterophase ceramic: Results for YBCO double-element substitution

    by V. Grinenko, A. Dudka, S. Nozaki, A. Muto, J. Clarke, J. Kilcrease, T. Hogan, V. Nikoghosyan, D. Napoletani, I. de Paiva, et al.

    A novel material is obtained by modifying pristine YBCO superconductor via simultaneous partial substitution of Sr for Ba and Se for O. The intended stoichiometry was [ ]SrxCu3[ ]Sex with [ ], 0.75 and 1; and [ ] yielded the most interesting results considered in detail. We confirmed that Se atoms indeed enter the superconductor lattice cell. The obtained polycrystalline material contains five phases, with the major phase ([ ][ ]wt.%) being [ ][ ]Cu3O6[ ]. The synthesized superconductor demonstrates unique properties, including (i) two superconducting transitions with [ ][ ]K and [ ][ ]K yielding the Wohlleben effect; (ii) strong-coupling d-wave superconductivity (with [ ] 5); (iii) Schottky anomaly in the heat capacity; and, most importantly, (iv) a very unusual anomaly in the heat capacity which can be associated with the quantum criticality typically observable at much higher fields. The fact that the quantum criticality is visible in weaker fields ([ ][ ]T) may open opportunities for exploration of the interplay between superconductivity and pair density waves by wide research community particularly when its pure phase is available. To facilitate this, the stability of single-phase [ ][ ]Cu3O6[ ] is analyzed using machine learning methods.


  • Phase-Slip Centers as Cooling Engines

    by Iris Mowgood, Serafim Teknowijoyo, Sara Chahid, Armen Gulian

    Based on time-dependent Ginzburg-Landau system of equations, Éliashberg’s kinetic equations and finite element modeling, we analyze phonon emiss


  • Flux-Quanta Injection for Nonreciprocal Current Control in a Two-Dimensional Noncentrosymmetric Superconducting Structure

    by Serafim Teknowijoyo, Sara Chahid, Armen Gulian

    We designed and experimentally demonstrated a four-terminal superconducting device, a “quadristor,” that can function as a nonlatching (reversible) superconducting switch from the diode regime to the resistive state by application of a control current much smaller than the main transport current. The device uses a vortex-based superconducting-diode mechanism that is switched back and forth via the injection of flux quanta through auxiliary current leads. Our finding opens a new research area in the field of superconducting electronics.


  • High-frequency diode effect in superconducting Nb3Sn microbridges

    by Sara Chahid, Serafim Teknowijoyo, Iris Mowgood, Armen Gulian

    The superconducting diode effect has recently been reported in a variety of systems and different symmetry-breaking mechanisms have been examined. However, the frequency range of these potentially important devices still remains obscure. We investigated superconducting microbridges of Nb3Sn in out-of-plane magnetic fields; optimum magnetic fields of ∼10 mT generate ∼10% diode efficiency, while higher fields of ∼15–20 mT quench the effect. The diode changes its polarity with magnetic field reversal. We documented superconductive diode rectification at frequencies up to 100 kHz, the highest reported as of today. Interestingly, the bridge resistance during diode operation reaches a value that is a factor of two smaller than in its normal state, which is compatible with the vortex-caused mechanism of resistivity. This is confirmed by finite-element modeling based on time-dependent Ginzburg-Landau equations. To explain experimental findings, no assumption of lattice thermal inequilibrium has been required. Dissimilar edges of the superconductor strip can be responsible for the inversion symmetry breaking by the vortex penetration barrier; visual evidence of this opportunity was revealed by scanning electron microscopy. Estimates are in favor of a much higher (GHz) range of frequencies for this type of diode.


  • Open Access

    Gravitational wave sensors based on superconducting transducers

    by Armen Gulian, Joe Foreman, Vahan Nikoghosyan, Louis Sica, Pablo Abramian-Barco, Jeff Tollaksen, Gurgen Melkonyan, Iris Mowgood, Chris Burdette, Rajendra Dulal, et al.

    Following the initial success of LIGO, new advances in gravitational wave (GW) detector systems are planned to reach fruition during the next decades. These systems are interferometric and large. Here we suggest different, more compact detectors of GW radiation with competitive sensitivity. These nonresonant detectors are not interferometric. They use superconducting Cooper pairs in a magnetic field to transform mechanical motion induced by GW into detectable magnetic flux. The detectors can be oriented relative to the source of GW, so as to maximize the signal output and help determine the direction of nontransient sources. In this design an incident GW rotates infinitesimally a system of massive barbells and superconducting frames attached to them. This last rotation relative to a strong magnetic field generates a signal of superconducting currents. The suggested arrangement of superconducting signal sources facilitates rejection of noise due to stray electromagnetic fields. In addition to signal analysis, we provide estimates of mechanical noise of the detector, taking into account temperature and elastic properties of the loops and barbells. We analyze at which parameters of the system a competitive strain sensitivity could be achieved. We have tested the basic idea of the detector in the laboratory and reached the theoretical Johnson-Nyquist noise limit with multiturn coils of normal metal. Realization of full-blown superconducting detectors can serve as viable alternatives to interferometric devices.


  • Open Access

    Possible superconductivity above 40 K in rhenium-doped strontium ruthenates indicated by Fourier-transform infrared spectroscopy

    by Yurii Aleshchenko, Boris Gorshunov, Elena Zhukova, Andrey Muratov, Alexander Dudka, Rajendra Dulal, Serafim Teknowijoyo, Sara Chahid, Vahan Nikoghosyan, Armen Gulian

    Strontium ruthenates have a lot of similarities with copper oxide superconductors and are a very interesting object for investigation of mechanisms and conditions which lead to high-temperature superconductivity. We report here on multiple experimental indications of superconductivity with the onset above 40K in strontium ruthenate doped by rhenium and selenium with chlorine used as a flux. The main experimental evidence comes from FTIR spectroscopy of this material followed by the ac and dc magnetization, as well as its heat capacity and magnetoresistance. Structural and morphological studies reveal the heterophase nature of this polycrystalline material as well as changes of lattice parameters relative to the original phases. Experimental data provide evidence of higher critical temperature on the surface compared to that in the bulk of the sample.


  • Open Access

    MoS2/Cu/TiO2 nanoparticles: synthesis, characterization and effect on photocatalytic decomposition of methylene blue in water under visible light

    by Desireé M. de Los Santos, Sara Chahid, Rodrigo Alcántara, Javier Navas, Teresa Aguilar, Juan Jesús Gallardo, Roberto Gómez-Villarejo, Iván Carrillo-Berdugo, Concha Fernández-Lorenzo

    Photodegradation processes are of great interest in a range of applications, one of which is the photodecomposition of pollutants. For this reason, analysing nanoparticles that improve the efficiency of these processes under solar radiation are very necessary. Thus, in this study, TiO2 was doped with Mo and Cu using low-temperature hydrolysis as the method of synthesis. Pure TiO2 and x%MoS2/Cu/TiO2 nanoparticles were prepared, where x is the theoretical quantity of MoS2 added (0.0%, 1.0%, 5.5%, 10.0%), setting the nominal quantity of Cu at 0.5 wt.%. The samples obtained were characterised by X-Ray Diffraction, Raman spectroscopy, x-ray electron spectroscopy (XPS) and UV-Vis spectroscopy in diffuse reflectance mode (DR-UV-Vis). The results suggest that the TiO2 structure was doped with the Mo6+ and Cu2+ ions in the position of the Ti4+. The x%MoS2/Cu/TiO2 samples presented lower band gap energy values and greater optical absorption in the visible region than the pure TiO2 sample. Lastly, the photocatalytic activity of the samples was assessed by means of the photodegradation of methylene blue under visible light. The results show that when the quantity of Mo in the co-doped samples increased (x%MoS2/Cu/TiO2) there were significant increases of up to 93% in the photocatalytic activity.