Lipin Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Lipin Li has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
Jun Zhang
State Key Laboratory of Urban Water Resource and Environment (SKLUWRE), School of Environment, Harbin Institute of Technology, Harbin 150090, China
10 shared publicationsHui Li
College of Chemistry and Environmental Science, Hebei University, Key Laboratory of Analytical Science and Technology of Hebei Province, Baoding 071002, China
9 shared publicationsWei Zuo
State Key Laboratory of Urban Water Resource and Environment (SKLUWRE), School of Environment, Harbin Institute of Technology, Harbin 150090, China
7 shared publications- Yu Tian
National Engineering Research Center For Safe Disposal and Resources Recovery of Sludge, School of Environment, Harbin Institute of Technology, Harbin 150090, China
5 shared publications Li Sun
State Key Laboratory of Urban Water Resource and Environment (SKLUWRE), School of Environment, Harbin Institute of Technology, Harbin 150090, China
3 shared publicationsXinying Su
School of Food Engineering, Harbin University of Commerce, Harbin 150076, China
3 shared publications
Latest Publications
- 1 November 2019
- Published by Elsevier in Bioresource Technology
- Vol. 292, 122000
Optimization of nutrient removal of novel electrochemically active carriers by response surface methodology
- 1 November 2019
- Published by Elsevier in Bioresource Technology
- Vol. 292, 122000
Optimization of nutrient removal of novel electrochemically active carriers by response surface methodology
- 1 July 2019
- Published by Elsevier in Chemosphere
- Vol. 226, 883-890
Enhanced denitrifying phosphorus removal and mass balance in a worm reactor
- 1 July 2019
- Published by Elsevier in Chemosphere
- Vol. 226, 883-890
Enhanced denitrifying phosphorus removal and mass balance in a worm reactor
- Open Access
- 1 June 2019
- Published by Elsevier in Environment International
- Vol. 127, 615-624
A novel approach for fouling mitigation in anaerobic-anoxic-oxic membrane bioreactor (A2O-MBR) by integrating worm predation
- 1 June 2019
- Published by Elsevier in Environment International
- Vol. 127, 615-624
Open AccessA novel approach for fouling mitigation in anaerobic-anoxic-oxic membrane bioreactor (A2O-MBR) by integrating worm predation
- 1 March 2018
- Published by Elsevier in Bioresource Technology
- Vol. 251, 311-319
A novel membrane bioreactor inoculated with symbiotic sludge bacteria and algae: Performance and microbial community analysis
- 1 March 2018
- Published by Elsevier in Bioresource Technology
- Vol. 251, 311-319
A novel membrane bioreactor inoculated with symbiotic sludge bacteria and algae: Performance and microbial community analysis
- 1 April 2017
- Published by Elsevier in Journal of Environmental Sciences
- Vol. 54, 246-255
Shifts in microbial community structure and diversity in a MBR combined with worm reactors treating synthetic wastewater
- 1 April 2017
- Published by Elsevier in Journal of Environmental Sciences
- Vol. 54, 246-255
Shifts in microbial community structure and diversity in a MBR combined with worm reactors treating synthetic wastewater
- 30 August 2016
- Published by IWA Publishing in Water Science & Technology
- Vol. 74 (9) , 2202-2210
Improvement of an integrated system of membrane bioreactor and worm reactor by phosphorus removal using additional post-chemical treatment
A membrane bioreactor (MBR) coupled with a worm reactor (SSBWR) was designed as SSBWR-MBR for sewage treatment and excess sludge reduction. However, total phosphorus (TP) release caused by worm predation in the SSBWR could increase the effluent TP concentration in the SSBWR-MBR. To decrease the amount of TP excreted, chemical treatment reactor was connected after the SSBWR-MBR to remove the excess phosphorus (P). The effects of chemical treatment at different time intervals on the performance of the SSBWR-MBR were assessed. The results showed that a maximum TP removal efficiency of 21.5 ± 1.0% was achieved in the SSBWR-MBR after chemical treatment. More importantly, a higher sulfate concentration induced by chemical treatment could promote TP release in the SSBWR, which provided further TP removal from the SSBWR-MBR. Additionally, chemical oxygen demand (COD) removal efficiency of the SSBWR-MBR was increased by 1.3% after effective chemical treatment. In the SSBWR-MBR, the chemical treatment had little effects on NH3-N removal and sludge production. Eventually, chemical treatment also alleviated the membrane fouling in the SSBWR-MBR. In this work, the improvement on TP, COD removal and membrane fouling alleviation was achieved in the SSBWR-MBR using additional chemical treatment.
- 30 August 2016
- Published by IWA Publishing in Water Science & Technology
- Vol. 74 (9) , 2202-2210
Improvement of an integrated system of membrane bioreactor and worm reactor by phosphorus removal using additional post-chemical treatment
A membrane bioreactor (MBR) coupled with a worm reactor (SSBWR) was designed as SSBWR-MBR for sewage treatment and excess sludge reduction. However, total phosphorus (TP) release caused by worm predation in the SSBWR could increase the effluent TP concentration in the SSBWR-MBR. To decrease the amount of TP excreted, chemical treatment reactor was connected after the SSBWR-MBR to remove the excess phosphorus (P). The effects of chemical treatment at different time intervals on the performance of the SSBWR-MBR were assessed. The results showed that a maximum TP removal efficiency of 21.5 ± 1.0% was achieved in the SSBWR-MBR after chemical treatment. More importantly, a higher sulfate concentration induced by chemical treatment could promote TP release in the SSBWR, which provided further TP removal from the SSBWR-MBR. Additionally, chemical oxygen demand (COD) removal efficiency of the SSBWR-MBR was increased by 1.3% after effective chemical treatment. In the SSBWR-MBR, the chemical treatment had little effects on NH3-N removal and sludge production. Eventually, chemical treatment also alleviated the membrane fouling in the SSBWR-MBR. In this work, the improvement on TP, COD removal and membrane fouling alleviation was achieved in the SSBWR-MBR using additional chemical treatment.
- 1 April 2016
- Published by Elsevier in Bioresource Technology
- Vol. 205, 104-110
Electricity generation from food wastes and characteristics of organic matters in microbial fuel cell
- 1 April 2016
- Published by Elsevier in Bioresource Technology
- Vol. 205, 104-110
Electricity generation from food wastes and characteristics of organic matters in microbial fuel cell
- 9 February 2016
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 24 (6) , 5106-5117
Simultaneous nitrification and denitrification in a novel membrane bioelectrochemical reactor with low membrane fouling tendency
Microbial fuel cells (MFCs) can use nitrate as a cathodic electron acceptor for electrochemical denitrification, yet there is little knowledge about how to apply them into current wastewater treatment process to achieve efficient nitrogen removal. In this study, two dual-chamber MFCs were integrated with an aerobic membrane bioreactor to construct a novel membrane bioelectrochemical reactor (MBER) for simultaneous nitrification and denitrification under specific aeration. The effects of chemical oxygen demand (COD) loading rate, COD/N ratio, hydraulic retention time (HRT), and external resistance on the system performance were investigated. High effluent quality was obtained in the MBER in terms of COD and ammonium. During the operation, denitrification simultaneously occurred with nitrification at the bio-cathode of the MBER, achieving a maximal nitrogen removal efficiency of 84.3 %. A maximum power density of 1.8 W/m3 and a current density of 8.5 A/m3 were achieved with a coulombic efficiency of 12.1 %. Furthermore, compared to the control system, the MBER exhibited lower membrane fouling tendency due to mixed liquor volatile suspended solids (MLVSSs) and extracellular polymeric substance (EPS) reductions, EPSp/EPSc ratio decrease, and particle size increase of the sludge. These results suggest that the MBER holds potential for efficient nitrogen removal, electricity production, and membrane fouling mitigation.
- 9 February 2016
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 24 (6) , 5106-5117
Simultaneous nitrification and denitrification in a novel membrane bioelectrochemical reactor with low membrane fouling tendency
Microbial fuel cells (MFCs) can use nitrate as a cathodic electron acceptor for electrochemical denitrification, yet there is little knowledge about how to apply them into current wastewater treatment process to achieve efficient nitrogen removal. In this study, two dual-chamber MFCs were integrated with an aerobic membrane bioreactor to construct a novel membrane bioelectrochemical reactor (MBER) for simultaneous nitrification and denitrification under specific aeration. The effects of chemical oxygen demand (COD) loading rate, COD/N ratio, hydraulic retention time (HRT), and external resistance on the system performance were investigated. High effluent quality was obtained in the MBER in terms of COD and ammonium. During the operation, denitrification simultaneously occurred with nitrification at the bio-cathode of the MBER, achieving a maximal nitrogen removal efficiency of 84.3 %. A maximum power density of 1.8 W/m3 and a current density of 8.5 A/m3 were achieved with a coulombic efficiency of 12.1 %. Furthermore, compared to the control system, the MBER exhibited lower membrane fouling tendency due to mixed liquor volatile suspended solids (MLVSSs) and extracellular polymeric substance (EPS) reductions, EPSp/EPSc ratio decrease, and particle size increase of the sludge. These results suggest that the MBER holds potential for efficient nitrogen removal, electricity production, and membrane fouling mitigation.
- 1 February 2015
- Published by Elsevier in Biosensors and Bioelectronics
- Vol. 64, 189-195
In-situ integration of microbial fuel cell with hollow-fiber membrane bioreactor for wastewater treatment and membrane fouling mitigation
- 1 February 2015
- Published by Elsevier in Biosensors and Bioelectronics
- Vol. 64, 189-195
In-situ integration of microbial fuel cell with hollow-fiber membrane bioreactor for wastewater treatment and membrane fouling mitigation