Ashura Katunzi-Kilewela
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Ashura Katunzi-Kilewela has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
Leonard Mp Rweyemamu
2 shared publicationsOscar Kibazohi
2 shared publications- Roman Mmanda Fortunatus
Adolphe Merkle Institute, University of Fribourg, Chemin des Verdiers 4, 1700 Fribourg, Switzerland
2 shared publications - Derrick S. Dlamini
Department of Civil & Environmental Engineering, University of California; California NanoSystems Institute, University of California
1 shared publication - Edgar Christian Mapunda
Chemistry Department, University of Dar es salaam
1 shared publication - John Michael Tesha1 shared publication
Latest Publications
- 18 December 2023
- Published by Society of Petroleum Engineers (SPE) in SPE Journal
- Vol. 29 (04) , 1974-1988
An Investigation on the Impact of Submicron-Sized Bubbles on the Fragmentation of Methane Clathrates Using Molecular Dynamics Simulation
Summary: The formation of submicron-sized bubbles is frequently associated with the fragmentation of methane clathrate. A bubble refers to a pocket or a round particle of one substance trapped inside another. In most cases, these spherical pockets are made of gas trapped inside of a liquid. Usually, bubbles can lie underneath the surface of the liquid until the surface tension breaks and the gas escapes back into the atmosphere. Therefore, understanding the fluid dynamics behavior of the clathrate phase shift and enhancing the production efficiency of natural gas requires knowledge of the impact of submicron-sized bubbles on the clathrate fragmentation. In this scenario, molecular dynamics simulation (MDS) models were carried out to investigate the methane clathrate fragmentation rate with and without preexisting submicron-sized bubbles. The findings demonstrate layer-by-layer fragmentation of the methane clathrate cluster in the liquid phase. Furthermore, this mechanism shows temperature and submicron-sized bubble existence independent of simulation settings or conditions. However, because of the stability of the supersaturated methane solution for a long period, methane clathrate fragmentation does not always result in the formation of submicron-sized bubbles. It was observed that between the bubble (submicron-size) of methane and the cluster surface of methane clathrate, there is a steep slope of methane concentration. This results in the liquid phase efficiently decreasing the methane concentration and improving the migration of natural gas in different directions, hence the driving force increases for methane clathrate fragmentation. Our discoveries in this research show that the existence of submicron-sized bubbles near the surface of the methane clathrate can speed up the rate of intrinsic decomposition while decreasing the activation energy of methane clathrate fragmentation. The mass flow rate toward submicron-sized bubbles linearly correlates with the methane clathrate fragmentation rate. The mass flow rate is governed by the size of the submicron-sized bubbles and the spacing between the methane clathrate submicron-sized bubbles. Our results contribute to the in-depth knowledge of the fragmentation technique in the liquid phase for methane clathrates, which is critical in optimizing and designing effective gas clathrate development methods.
- 18 December 2023
- Published by Society of Petroleum Engineers (SPE) in SPE Journal
- Vol. 29 (04) , 1974-1988
An Investigation on the Impact of Submicron-Sized Bubbles on the Fragmentation of Methane Clathrates Using Molecular Dynamics Simulation
Summary: The formation of submicron-sized bubbles is frequently associated with the fragmentation of methane clathrate. A bubble refers to a pocket or a round particle of one substance trapped inside another. In most cases, these spherical pockets are made of gas trapped inside of a liquid. Usually, bubbles can lie underneath the surface of the liquid until the surface tension breaks and the gas escapes back into the atmosphere. Therefore, understanding the fluid dynamics behavior of the clathrate phase shift and enhancing the production efficiency of natural gas requires knowledge of the impact of submicron-sized bubbles on the clathrate fragmentation. In this scenario, molecular dynamics simulation (MDS) models were carried out to investigate the methane clathrate fragmentation rate with and without preexisting submicron-sized bubbles. The findings demonstrate layer-by-layer fragmentation of the methane clathrate cluster in the liquid phase. Furthermore, this mechanism shows temperature and submicron-sized bubble existence independent of simulation settings or conditions. However, because of the stability of the supersaturated methane solution for a long period, methane clathrate fragmentation does not always result in the formation of submicron-sized bubbles. It was observed that between the bubble (submicron-size) of methane and the cluster surface of methane clathrate, there is a steep slope of methane concentration. This results in the liquid phase efficiently decreasing the methane concentration and improving the migration of natural gas in different directions, hence the driving force increases for methane clathrate fragmentation. Our discoveries in this research show that the existence of submicron-sized bubbles near the surface of the methane clathrate can speed up the rate of intrinsic decomposition while decreasing the activation energy of methane clathrate fragmentation. The mass flow rate toward submicron-sized bubbles linearly correlates with the methane clathrate fragmentation rate. The mass flow rate is governed by the size of the submicron-sized bubbles and the spacing between the methane clathrate submicron-sized bubbles. Our results contribute to the in-depth knowledge of the fragmentation technique in the liquid phase for methane clathrates, which is critical in optimizing and designing effective gas clathrate development methods.
- Open Access
- 1 June 2022
- Published by Elsevier in Applied Food Research
- Vol. 2 (1)
Sensory profile, consumer acceptability and preference mapping of cassava-chia seeds composite porridges
- 1 June 2022
- Published by Elsevier in Applied Food Research
- Vol. 2 (1)
Open AccessSensory profile, consumer acceptability and preference mapping of cassava-chia seeds composite porridges
- Open Access
- 29 December 2021
- Published by SAGE Publications in Food Science and Technology International
- Vol. 29 (3) , 217-227
Proximate composition, pasting and functional properties of composite flour blends from cassava and chia seeds flour
The study established the proximate composition, pasting, and functional properties of cassava flour (CF) blended with chia seeds flour (CSF). Composite flour was prepared by blending CF with CSF in the ratios of 95:05, 90:10, 85:15, 80:20, and 75:25 with CF and CSF used as controls, respectively. The effect of blending significantly (p < 0.05) increased protein, fat, fibre, and ash contents as CSF increased. On other hand, moisture and carbohydrate contents decreased significantly. Pasting properties of composite flour blends decreased significantly (p < 0.05) as the incorporation of CSF increased and a noticeable change was observed for composite flour (75:25) except for peak time and pasting temperature. Functional properties of water absorption capacity (WAC) of CSF were significantly different with CF and composite flour blends. Oil absorption capacity (OAC) of CF and CSF were significantly different, while the composite flour blends had varied OAC due to the inclusion of the different amounts of CSF. The swelling capacity (SC) of CF and CSF were not significantly different, but composite flour blends were significantly different from both CSF and CF. The least gelation concentration (LGC) and bulk density (BD) increased significantly as chia seeds increased. Increased concentration of chia CSF in the composite flour blends showed to alter the functional properties. This study recommends composite flour 75:25 for processing semiliquid products like porridge due to reduced pasting properties values that may be associated with increased energy density compared to CF.
- 29 December 2021
- Published by SAGE Publications in Food Science and Technology International
- Vol. 29 (3) , 217-227
Open AccessProximate composition, pasting and functional properties of composite flour blends from cassava and chia seeds flour
The study established the proximate composition, pasting, and functional properties of cassava flour (CF) blended with chia seeds flour (CSF). Composite flour was prepared by blending CF with CSF in the ratios of 95:05, 90:10, 85:15, 80:20, and 75:25 with CF and CSF used as controls, respectively. The effect of blending significantly (p < 0.05) increased protein, fat, fibre, and ash contents as CSF increased. On other hand, moisture and carbohydrate contents decreased significantly. Pasting properties of composite flour blends decreased significantly (p < 0.05) as the incorporation of CSF increased and a noticeable change was observed for composite flour (75:25) except for peak time and pasting temperature. Functional properties of water absorption capacity (WAC) of CSF were significantly different with CF and composite flour blends. Oil absorption capacity (OAC) of CF and CSF were significantly different, while the composite flour blends had varied OAC due to the inclusion of the different amounts of CSF. The swelling capacity (SC) of CF and CSF were not significantly different, but composite flour blends were significantly different from both CSF and CF. The least gelation concentration (LGC) and bulk density (BD) increased significantly as chia seeds increased. Increased concentration of chia CSF in the composite flour blends showed to alter the functional properties. This study recommends composite flour 75:25 for processing semiliquid products like porridge due to reduced pasting properties values that may be associated with increased energy density compared to CF.