ANAleksandra Nadolska

Aleksandra Nadolska

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Aleksandra Nadolska has a total of 37 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Overcoming Contamination‐Induced Barriers: Ohmic Vertical Transport in Atomically Clean MoS 2 /Au Junctions

    by Rafał Dunal, Maxime Le Ster, Iaroslav Lutsyk, Michał Piskorski, Przemysław Przybysz, Paweł Dąbrowski, Paweł Krukowski, Witold Kozłowski, Aleksandra Nadolska, Wojciech Ryś, et al.

    The application of two‐dimensional (2D) semiconductors, such as monolayer MoS 2 , is limited by high contact resistance commonly attributed to interfacial barriers at metal contacts. Furthermore, the dependence of electrical conductivity on MoS 2 thickness remains unsettled, as both increasing and decreasing trends with layer number have been reported. Using conductive atomic force microscopy (CAFM), we measure local electrical transport in MoS 2 /Au junctions with contrasting interface cleanliness: pristine interfaces prepared under ultra‐high vacuum (UHV) and contaminated interfaces prepared by the widely used PDMS‐assisted transfer under ambient conditions. By comparing monolayer MoS 2 /Au junctions prepared under these contrasting conditions, we demonstrate that an atomically clean interface enables highly conductive, ohmic transport in the vertical CAFM geometry. Measurements on mono‐ and multilayer regions further show that interfacial contamination introduces a substantial transport barrier and can reverse the thickness dependence of electrical transport. We rationalize these findings using electrical transport simulations based on Kirchhoff's laws, identifying the interplay between MoS 2 /Au interfacial resistance and lateral current spreading within MoS 2 layers as the origin of the opposite thickness trends. Lastly, we show that local force‐mediated lamination on lightly contaminated contacts can recover pristine, ohmic contacts, offering a route toward nanoscale patterning.

  • Open Access

    Survey of Raman Spectroscopy and Fabry–Pérot Interference in Thin Flakes of 2H-MoS2, 1T-TaS2, 1T’-MoTe2, Td-WTe2, and α-MoO3

    by Michał Piskorski, Wojciech Ryś, Rafał Dunal, Maxime Le Ster, Patryk Krempiński, Łukasz Radecki, Aleksandra Nadolska, Klaudia Toczek, Przemysław Przybysz, Iaroslav Lutsyk, et al.


  • Open Access

    Heterostructure of graphene with a two-dimensional crystalline molybdenum trioxide (MoO3) layers

    by Paweł Krukowski, Michał Piskorski, Maciej Rogala, Paweł Dąbrowski, Iaroslav Lutsyk, Witold Kozłowski, Patryk Krempiński, Maxime Le Ster, Aleksandra Nadolska, Beata Łuszczyńska, et al.

    The heterostructure consisting of graphene and two-dimensional (2D) crystalline molybdenum trioxide (MoO3) layers was fabricated through a wet transfer method using a polymer to transfer the MoO3 layers from the mica crystal surface. Using a heating plate method, this crystalline MoO3 was initially grown on mica under normal atmospheric air conditions. Furthermore, the authors demonstrated that the only MoO3 phase forms on the molybdenum foil following annealing in air, as confirmed by X-ray photoelectron spectroscopy (XPS) study. The resulting graphene heterostructure was examined using optical and atomic force microscopy (AFM). The fabrication method introduced here offers a cost-effective alternative to the more costly and complex ultra-high vacuum techniques used for epitaxial layer fabrication. This graphene heterostructure holds potential as a conductive and transparent anode for the organic light-emitting diode (OLED) technology.


  • Open Access

    Characterisation of a graphene/NPB structure with Re2O7 as an interfacial layer for OLED application

    by Paweł Dąbrowski, Michał Piskorski, Patryk Krempiński, Maciej Rogala, Beata Łuszczyńska, Klaudia Toczek, Paweł Krukowski, Shankhanil Sarkar, Witold Kozłowski, Dorota A. Kowalczyk, et al.

    A graphene/NPB structure with Re2O7 as an interfacial layer in the context of its potential use in the design of an organic light-emitting diode (OLED) is investigated. The X-ray photoelectron spectroscopy (XPS) study shows the formation of the Re2O7 phase on a monolayer graphene on quartz during thermal deposition in ultra-high vacuum (UHV). The ultraviolet photoelectron spectroscopy (UPS) study shows an enhancement of the work function of the graphene heterostructure after deposition of the Re2O7 layer up to 5.4 eV. The hole injection barrier between the Re2O7/graphene heterostructure and the N-bis-(1-naphthyl)-N,N-diphenyl-(1,1-biphenyl)-4,4-diamine (NPB) layer was estimated to be 0.35 eV, which is very promising for a good OLED performance.

  • Open Access

    Electrostimulation and Nanomanipulation of Two-Dimensional MoO3-x Layers Grown on Graphite

    by Aleksandra Nadolska, Dorota A. Kowalczyk, Iaroslav Lutsyk, Michał Piskorski, Paweł Krukowski, Paweł Dąbrowski, Maxime Le Ster, Witold Kozłowski, Rafał Dunal, Przemysław Przybysz, et al.

    Molybdenum trioxide shows many attractive properties, such as a wide electronic band gap and a high relative permittivity. Monolayers of this material are particularly important, as they offer new avenues in optoelectronic devices, e.g., to alter the properties of graphene electrodes. Nanoscale electrical characterization is essential for potential applications of monolayer molybdenum trioxide. We present a conductive atomic force microscopy study of an epitaxially grown 2D molybdenum oxide layer on a graphene-like substrate, such as highly oriented pyrolytic graphite (HOPG). Monolayers were also investigated using X-ray photoelectron spectroscopy, atomic force microscopy (semi-contact and contact mode), Kelvin probe force microscopy, and lateral force microscopy. We demonstrate mobility of the unpinned island under slight mechanical stress as well as shaping and detachment of the material with applied electrical stimulation. Non-stoichiometric MoO3-x monolayers show heterogeneous behavior in terms of electrical conductivity, which can be related to the crystalline domains and defects in the structure. Different regions show various I–V characteristics, which are correlated with their susceptibility to electrodegradation. In this work, we cover the existing gap regarding nanomanipulation and electrical nanocharacterization of the MoO3 monolayer.


  • Graphene on quartz modified with rhenium oxide as a semitransparent electrode for organic electronics

    by Jacek Ulański, Aleksandra Nadolska, Ruslana Udovytska, Krzysztof Matuszek, Wojciech Ryś, Dorota A. Kowalczyk, Witold Kozłowski, Klaudia Toczek, Rafał Dunal, Paweł Dąbrowski, et al.

    The presented research shows that commercially available graphene on quartz modified with rhenium oxide meets the requirements for its use as a conductive and transparent anode in optoelectronic devices. The cluster growth of rhenium oxide enables an increase in the work function of graphene by 1.3 eV up to 5.2 eV, which guarantees an appropriate adjustment to the energy levels of organic semiconductors used in organic light-emitting diode devices.


  • Open Access

    Two-Dimensional Crystals as a Buffer Layer for High Work Function Applications: The Case of Monolayer MoO3

    by Dorota A. Kowalczyk, Maciej Rogala, Karol Szałowski, Domagoj Belić, Paweł Dąbrowski, Paweł Krukowski, Iaroslav Lutsyk, Michał Piskorski, Aleksandra Nadolska, Patryk Krempiński, et al.

    We propose that the crystallinity of two-dimensional (2D) materials is a crucial factor for achieving highly effective work function (WF) modification. A crystalline 2D MoO3 monolayer enhances substrate WF up to 6.4 eV for thicknesses as low as 0.7 nm. Such a high WF makes 2D MoO3 a great candidate for tuning properties of anode materials and for the future design of organic electronic devices, where accurate evaluation of the WF is crucial. We provide a detailed investigation of WF of 2D α-MoO3 directly grown on highly ordered pyrolytic graphite, by means of Kelvin probe force microscopy (KPFM) and ultraviolet photoemission spectroscopy (UPS). This study underlines the importance of a controlled environment and the resulting crystallinity to achieve high WF in MoO3. UPS is proved to be suitable for determining higher WF attributed to 2D islands on a substrate with lower WF, yet only in particular cases of sufficient coverage. KPFM remains a method of choice for nanoscale investigations, especially when conducted under ultrahigh vacuum conditions. Our experimental results are supported by density functional theory calculations of electrostatic potential, which indicate that oxygen vacancies result in anisotropy of WF at the sides of the MoO3 monolayer. These novel insights into the electronic properties of 2D-MoO3 are promising for the design of electronic devices with high WF monolayer films, preserving the transparency and flexibility of the systems.