Stefania Faria
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Stefania Faria has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Nuno Leonor
Instituto de Telecomunicaes, Leiria, Portugal
4 shared publications - Rafael Ferreira Silva Caldeirinha
Instituto de Telecomunicações
4 shared publications - Carlos Alberto Ferreira Fernandes
Instituto de Telecomunicações, Instituto Superior Técnico, Universidade de Lisboa, 1049-001 Lisbon, Portugal
2 shared publications Mario Vala
Instituto de Telecomunicaes, Leiria, Portugal
2 shared publicationsCarlos Salema
Instituto de Telecomunicaes, Lisbon, Portugal
1 shared publication- Carlos Salema
Institute Superior Technico (Technical University of Lisbon), Lisbon, Portugal
1 shared publication
Latest Publications
- 2 November 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 22 (3) , 581-585
Measurement Trials and Modeling of Radio Propagation Through Small-Scale Fire Using Pinus pinaster Fuel Bed
This paper presents measurement results and initial physical modeling of the radiowave propagation phenomena in the presence of fire using Pinus Pinaster fuel heaps. To this extent, this paper reports on small-scale measurement trials carried out at 700 MHz on Pinus Pinaster fuel bed on fire and subsequent validation of simulation results of the propagation phenomena behavior based on the intertwined use of both Fire Dynamics Simulator and the Cold Plasma Model. Excess attenuation of up to 1.52 dB was observed in measured results, which is thought to be critical considering it is a small-scale fire scenario composed of a 1 x 1 m 2 with 0.6 kg of pine needles.
- 2 November 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 22 (3) , 581-585
Measurement Trials and Modeling of Radio Propagation Through Small-Scale Fire Using Pinus pinaster Fuel Bed
This paper presents measurement results and initial physical modeling of the radiowave propagation phenomena in the presence of fire using Pinus Pinaster fuel heaps. To this extent, this paper reports on small-scale measurement trials carried out at 700 MHz on Pinus Pinaster fuel bed on fire and subsequent validation of simulation results of the propagation phenomena behavior based on the intertwined use of both Fire Dynamics Simulator and the Cold Plasma Model. Excess attenuation of up to 1.52 dB was observed in measured results, which is thought to be critical considering it is a small-scale fire scenario composed of a 1 x 1 m 2 with 0.6 kg of pine needles.
- 24 June 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 70 (10) , 9706-9715
Site-Specific Radio Propagation Model for Macrocell Coverage at Sub-6 GHz Frequencies
This paper presents a radio propagation model for macrocell coverage predictions in built-up areas for sub-6 GHz frequency band. The proposed two ray model is the combination of various individual propagation models available in the literature, namely the Discrete Mixed Fourier Transform Split-Step Parabolic-Equation (DMFT-SSPE) to characterize reflection and diffraction phenomena due to the presence of buildings and terrain irregularities, the building-transmission model (BTM) to account for the signal attenuation through the nearby buildings and the International Telecommunication Union of Radio-communications (ITU-R) model for attenuation in vegetation to weight the excess attenuation caused by the surrounding vegetation. The performance of the proposed modeling approach was assessed against measurement results obtained from an extensive measurement campaign conducted in Rio de Janeiro, Brazil. The receiver (RX) antenna was assembled on an automotive van, and it was made to travel around the city recording the received signal level. Several drive tests were conducted, including different transmitter (TX) locations and scenarios, and at various frequencies foreseen for 5G systems, namely 750 MHz, 2.5 GHz and 3.5 GHz.
- 24 June 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 70 (10) , 9706-9715
Site-Specific Radio Propagation Model for Macrocell Coverage at Sub-6 GHz Frequencies
This paper presents a radio propagation model for macrocell coverage predictions in built-up areas for sub-6 GHz frequency band. The proposed two ray model is the combination of various individual propagation models available in the literature, namely the Discrete Mixed Fourier Transform Split-Step Parabolic-Equation (DMFT-SSPE) to characterize reflection and diffraction phenomena due to the presence of buildings and terrain irregularities, the building-transmission model (BTM) to account for the signal attenuation through the nearby buildings and the International Telecommunication Union of Radio-communications (ITU-R) model for attenuation in vegetation to weight the excess attenuation caused by the surrounding vegetation. The performance of the proposed modeling approach was assessed against measurement results obtained from an extensive measurement campaign conducted in Rio de Janeiro, Brazil. The receiver (RX) antenna was assembled on an automotive van, and it was made to travel around the city recording the received signal level. Several drive tests were conducted, including different transmitter (TX) locations and scenarios, and at various frequencies foreseen for 5G systems, namely 750 MHz, 2.5 GHz and 3.5 GHz.
- 2 June 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 21 (9) , 1777-1781
A Combined ITM and LITU-R Model for Enhanced Radio Coverage Predictions of Mission-Critical Communications in Mountainous Vegetated Terrains
This letter presents a combined model for appropriate radio coverage of mission-critical push-to-talk communications in mountainous vegetated terrains. The proposed model uses the irregular terrain model (ITM) with the detailed information of the ground topography to predict the excess loss caused by the terrain irregularities, along with the Lateral International Telecommunications Union of Radio model, to account for the excess loss caused by the presence of vegetation in the radio path. The performance of the proposed combined model was assessed against experimental results obtained from a measurement campaign conducted along unpaved paths and trails, usually taken by firefighters during firefighting procedures, in mountainous terrains with dense vegetation. The acquired experimental data was assessed against experimental results obtained from a measurement campaign conducted along unpaved paths and trails.
- 2 June 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 21 (9) , 1777-1781
A Combined ITM and LITU-R Model for Enhanced Radio Coverage Predictions of Mission-Critical Communications in Mountainous Vegetated Terrains
This letter presents a combined model for appropriate radio coverage of mission-critical push-to-talk communications in mountainous vegetated terrains. The proposed model uses the irregular terrain model (ITM) with the detailed information of the ground topography to predict the excess loss caused by the terrain irregularities, along with the Lateral International Telecommunications Union of Radio model, to account for the excess loss caused by the presence of vegetation in the radio path. The performance of the proposed combined model was assessed against experimental results obtained from a measurement campaign conducted along unpaved paths and trails, usually taken by firefighters during firefighting procedures, in mountainous terrains with dense vegetation. The acquired experimental data was assessed against experimental results obtained from a measurement campaign conducted along unpaved paths and trails.
- 27 March 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 53, 1-4
Measurement Trials of Radiowave Propagation Through Pinus Pinaster Fuel Bed Under Fire
This paper presents results of a measurement campaign conducted to evaluate the impact of forest fires on radiowave propagation. A total mass of 3.4 kg of Pinus Pinaster needles was used as fuel heap and it was uniformly placed in a triangular shape bed, above a metallic table. The ignition sources were two wool yarns soaked in diesel, allocated in two sides of the triangle, with different incident angles, in order to generate two independent fire fronts that will suffer a junction after some seconds. The excess loss introduced by fire was evaluated for a 5 GHz bandwidth, from 3 to 8 GHz. A multipath analysis is also presented in order to detect the variations on signal level, for the dominant components during transmission.
- 27 March 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 53, 1-4
Measurement Trials of Radiowave Propagation Through Pinus Pinaster Fuel Bed Under Fire
This paper presents results of a measurement campaign conducted to evaluate the impact of forest fires on radiowave propagation. A total mass of 3.4 kg of Pinus Pinaster needles was used as fuel heap and it was uniformly placed in a triangular shape bed, above a metallic table. The ignition sources were two wool yarns soaked in diesel, allocated in two sides of the triangle, with different incident angles, in order to generate two independent fire fronts that will suffer a junction after some seconds. The excess loss introduced by fire was evaluated for a 5 GHz bandwidth, from 3 to 8 GHz. A multipath analysis is also presented in order to detect the variations on signal level, for the dominant components during transmission.