Marcos López‐Aguilar
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Marcos López‐Aguilar has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
- Joaquín García-Álvarez
Laboratorio de Química Sintética Sostenible (QuimSinSos), Departamento de Química Orgánica e Inorgánica, (IUQOEM), Centro de Innovación en Química Avanzada (ORFEO-CINQA), Facultad de Química, Universidad de Oviedo, E33071 Oviedo, Spain
5 shared publications - Luciana Cicco
Dipartimento di Farmacia-Scienze del Farmaco, Università degli Studi di Bari Aldo Moro, Consorzio CINMPIS, via E. Orabona 4, 70125 Bari, Italy
4 shared publications - Carmen Concellón
Laboratorio de Química Sintética Sostenible (QuimSinSos) Departamento de Química Orgánica e Inorgánica, (IUQOEM) Centro de Innovación en Química Avanzada (ORFEO-CINQA) Facultad de Química Universidad de Oviedo E33071 Oviedo Spain
3 shared publications - Marina Ramos‐Martín
Universidad de Oviedo
3 shared publications - Nicolás Ríos-Lombardía
Laboratorio de Química Sintética Sostenible (QuimSinSos) Departamento de Química Orgánica e Inorgánica (IUQOEM) Facultad de Química Universidad de Oviedo Oviedo Spain
3 shared publications - Vicente del Amo
Laboratorio de Química Sintética Sostenible (QuimSinSos), Organic and Inorganic Chemistry Department, Instituto de Química Organometálica Enrique Moles, Universidad de Oviedo, Avenida Julián Clavería 8, 33006 Oviedo, Asturias, Spain
3 shared publications
Latest Publications
- Open Access
- 5 May 2026
- Published by Royal Society of Chemistry (RSC) in Green Chemistry
- Vol. 28 (26) , 10965-10975
Solvent-free/scalable mechanochemical-assisted addition of phosphine oxides to aldehydes: sustainable protocol for one-pot tandem P–C bond formation
Solvent-free mechanochemistry provides a sustainable and scalable route to α-hydroxyphosphine oxides via chemoselective P–C bond formation under air and at room temperature.
- 5 May 2026
- Published by Royal Society of Chemistry (RSC) in Green Chemistry
- Vol. 28 (26) , 10965-10975
Open AccessSolvent-free/scalable mechanochemical-assisted addition of phosphine oxides to aldehydes: sustainable protocol for one-pot tandem P–C bond formation
Solvent-free mechanochemistry provides a sustainable and scalable route to α-hydroxyphosphine oxides via chemoselective P–C bond formation under air and at room temperature.
- Open Access
- 23 December 2024
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 61 (17) , 3488-3491
Organocatalytic CS 2 insertion into epoxides in neat conditions: a straightforward approach for the efficient synthesis of Di- and tri-thiocarbonates
We reported the use of quaternary ammonium salts as organocatalysts for efficient di- and tri-thiocarbonate synthesis under neat conditions. Mechanistic studies highlight the role of hydrogen-bond interactions in this sustainable methodology.
- 23 December 2024
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 61 (17) , 3488-3491
Open AccessOrganocatalytic CS 2 insertion into epoxides in neat conditions: a straightforward approach for the efficient synthesis of Di- and tri-thiocarbonates
We reported the use of quaternary ammonium salts as organocatalysts for efficient di- and tri-thiocarbonate synthesis under neat conditions. Mechanistic studies highlight the role of hydrogen-bond interactions in this sustainable methodology.
- Open Access
- 29 April 2024
- Published by Wiley in ChemCatChem
- Vol. 16 (15) , e202400437
Synergistic One‐pot Tandem Combination of Cu and Proline Catalysis: Stereodivergent Synthesis of Chiral Aldols from Primary Alcohols
A new stereodivergent one‐pot tandem protocol, which granted diastereo‐ and enantioselective access to chiral aldols by starting from simple primary alcohols, is presented as a proof‐of‐concept. The synergistic combination of a chemoselective Cu(II)‐catalyzed oxidation of primary alcohols into the corresponding aldehydes (without the expected overoxidation into the corresponding carboxylic acids and using simple aerial O2 as co‐oxidant), followed by a concomitant organocatalyzed enantioselective aldol coupling promoted by the system (S)‐proline/HTBD‐BF4 [TBD=1,5,7‐triazabicyclo[4.4.0]dec‐5‐ene], was achieved after fine‐tuning and compatibilizing the conditions required for the successful performance of both catalytic systems. Here, we demonstrated that selection and pairing of both catalysts needs to be extremely judicious to avoid orthogonality, kinetic, concentration or reciprocal poisoning issues. Refinement of the overall tandem protocol allowed us to design a synergistic and stereodivergent protocol which affords comparable or even better diastereoselective results than the organocatalytic system by itself. Finally, the following key factors (from a sustainable point of view) should be highlighted: i) no external VOC solvents are needed during our one‐pot tandem synthetic protocol (by working under neat conditions); and ii) isolation/purification of any intermediate is not required, thus reducing the chemical waste and energy/time costs, simplifying the practical aspects of our synthetic methodology.
- 29 April 2024
- Published by Wiley in ChemCatChem
- Vol. 16 (15) , e202400437
Open AccessSynergistic One‐pot Tandem Combination of Cu and Proline Catalysis: Stereodivergent Synthesis of Chiral Aldols from Primary Alcohols
A new stereodivergent one‐pot tandem protocol, which granted diastereo‐ and enantioselective access to chiral aldols by starting from simple primary alcohols, is presented as a proof‐of‐concept. The synergistic combination of a chemoselective Cu(II)‐catalyzed oxidation of primary alcohols into the corresponding aldehydes (without the expected overoxidation into the corresponding carboxylic acids and using simple aerial O2 as co‐oxidant), followed by a concomitant organocatalyzed enantioselective aldol coupling promoted by the system (S)‐proline/HTBD‐BF4 [TBD=1,5,7‐triazabicyclo[4.4.0]dec‐5‐ene], was achieved after fine‐tuning and compatibilizing the conditions required for the successful performance of both catalytic systems. Here, we demonstrated that selection and pairing of both catalysts needs to be extremely judicious to avoid orthogonality, kinetic, concentration or reciprocal poisoning issues. Refinement of the overall tandem protocol allowed us to design a synergistic and stereodivergent protocol which affords comparable or even better diastereoselective results than the organocatalytic system by itself. Finally, the following key factors (from a sustainable point of view) should be highlighted: i) no external VOC solvents are needed during our one‐pot tandem synthetic protocol (by working under neat conditions); and ii) isolation/purification of any intermediate is not required, thus reducing the chemical waste and energy/time costs, simplifying the practical aspects of our synthetic methodology.
- Open Access
- 13 October 2022
- Published by Wiley in ChemistryOpen
- Vol. 11 (10) , e202200160
Selective Aerobic Oxidation of Alcohols in Low Melting Mixtures and Water and Use for Telescoped One‐Pot Hybrid Reactions
An efficient, selective and sustainable protocol was developed for the CuCl2/TEMPO/TMEDA‐catalyzed aerobic oxidation of activated alcohols to the corresponding carbonyl compounds using water or the environmentally friendly low melting mixture (LMM) d‐fructose‐urea as the reaction medium. Such oxidation reactions proceed under mild (room temperature or 40 °C) and aerobic conditions, with the carbonyl derivatives isolated in up to 98 % yield and within 4 h reaction time when using the above‐mentioned LMM. The potential application of this methodology is demonstrated by setting up useful telescoped, one‐pot two‐step hybrid transformations for the direct conversion of primary alcohols either into secondary alcohols or into valuable nitroalkenes, by combining oxidation processes with nucleophilic additions promoted by highly polarized organometallic compounds (Grignard and organolithium reagents) or with nitroaldol (Henry) reactions, respectively.
- 13 October 2022
- Published by Wiley in ChemistryOpen
- Vol. 11 (10) , e202200160
Open AccessSelective Aerobic Oxidation of Alcohols in Low Melting Mixtures and Water and Use for Telescoped One‐Pot Hybrid Reactions
An efficient, selective and sustainable protocol was developed for the CuCl2/TEMPO/TMEDA‐catalyzed aerobic oxidation of activated alcohols to the corresponding carbonyl compounds using water or the environmentally friendly low melting mixture (LMM) d‐fructose‐urea as the reaction medium. Such oxidation reactions proceed under mild (room temperature or 40 °C) and aerobic conditions, with the carbonyl derivatives isolated in up to 98 % yield and within 4 h reaction time when using the above‐mentioned LMM. The potential application of this methodology is demonstrated by setting up useful telescoped, one‐pot two‐step hybrid transformations for the direct conversion of primary alcohols either into secondary alcohols or into valuable nitroalkenes, by combining oxidation processes with nucleophilic additions promoted by highly polarized organometallic compounds (Grignard and organolithium reagents) or with nitroaldol (Henry) reactions, respectively.