FYFang Yuan

Fang Yuan

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Fang Yuan has a total of 7 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Movement Law of Overlying Strata and Abutment Pressure Redistribution Characteristic Based on Rigid Block

    by Fang Yuan, Jianxin Tang, Lingrui Kong

    Roof movement induced by coal excavation is the immediate cause of rock pressure redistribution and strata behavior. The rigid block in PFC3D was used to generate a multijointed rock mass, and the PFC3D–FLAC3D coupling model was used to study the movement law of the highly developed structural plane of the overlying strata. Strata movement and abutment pressure redistribution characteristics were obtained. The numerical simulation results showed that the multijointed rock mass model reproduced a rock mass with highly developed structural planes. After coal seam mining, the immediate roof caved and filled the goaf, forming an irregular and regular caved zone. The immediate roof shear slipped along the coal wall. The fracture of the basic roof formed a fractured zone, and the maximum height of the fractured zone first increased and then decreased, exhibiting continuous slow subsidence. The fluctuation of the front abutment pressure was reduced, and the abutment pressure in the goaf jumps was discontinuous. The abutment pressure in the goaf was high in the middle and low on both sides. After the initial fracture of the basic roof, the stress concentration of some rock blocks in the goaf exceeded the in-situ stress, and the average abutment pressure increased with the working face advancing length. With the coal wall of the working face gradually moving away from the goaf, the abutment pressure of the goaf first increased and then remained unchanged; the porosity first decreased sharply and then declined slowly; the coordination number of particles rose sharply and then increased slowly, indicating that the goaf gradually stabilized. Similar simulation results indicated that the variation law of abutment pressure, caving characteristics of the immediate roof, and continuous slow subsidence of the basic roof were the same as those of the numerical simulation.


  • Open Access

    Bayesian Estimation of Resistance Factor for Bored Piles Based on Load Test Database

    by Zhijun Xu, Ranran Zhang, Liang Fan, Xing Han, Fang Yuan, DU Ming-Fang

    The quality of in situ data is key to calculating resistance factor of bored piles. However, it is difficult to summarize accuracy data due to various uncertainties in engineering. This paper employs the Bayesian method and mathematical statistics theory to put forward an estimation method for updating in situ data. A testing database (33 tests in noncohesive soils and 53 tests in cohesive soils) of bored piles is summarized. The model factor of bored piles is quantified as the ratio of the measured capacity to the calculated capacity. The proposed method is used to classify summarized data into three categories, which are “good data,” “general data,” and “bad data.” The “bad data” are discarded because of bad contribution to calculation, and Bayesian theory is incorporated into updating the model factor statistics. Three methods are used to calculate the reliability index and resistance factor of bored piles, and the results show that the reliability index and resistance factor are sensitive to the quality of data. Finally, the available values of resistance factors are proposed based on resistance factor design for bridge design specification, which can offer references to revision relevant specifications. The proposed method can be used to update other geotechnical data.