Abhishek Sharma
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Abhishek Sharma has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Santiago Cogollos
Departamento de Comunicaciones, Universitat Politcnica de Valncia, Valencia, Spain
4 shared publications - Vicente Enrique Boria
Universitat Politècnica de València
4 shared publications - Marco Guglielmi
Universitat Politècnica de València
3 shared publications - Abdulrahman Widaa
Department of Electrical and Information Engineering, Kiel University, Kiel, Germany
1 shared publication - Angel Antonio San-Blas
Universidad Miguel Hernández de Elche
1 shared publication - Angela Coves
Departamento de Ingeniera de Comunicaciones-I3E, Universidad Miguel Hernndez de Elche, Elche, Spain
1 shared publication
Latest Publications
- Open Access
- 22 August 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 11, 91709-91723
Using Dielectric Rods to Reconfigure Combline Filters in Center Frequency and Bandwidth
This article describes the use of dielectric rods to reconfigure combline filters both with respect to center frequency and bandwidth. In this context, a new filter topology is developed in order to maximize the achievable reconfiguration range. The design of a prototype is discussed in detail, clearly demonstrating the feasibility of center frequency and bandwidth reconfiguration, with the same filter structure, while maintaining an equiripple return loss. In addition to theory, a combline filter prototype is also fabricated, tuned and measured in several configurations showing excellent agreement with simulations, thereby fully validating both the basic concept and the design procedure.
- 22 August 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 11, 91709-91723
Open AccessUsing Dielectric Rods to Reconfigure Combline Filters in Center Frequency and Bandwidth
This article describes the use of dielectric rods to reconfigure combline filters both with respect to center frequency and bandwidth. In this context, a new filter topology is developed in order to maximize the achievable reconfiguration range. The design of a prototype is discussed in detail, clearly demonstrating the feasibility of center frequency and bandwidth reconfiguration, with the same filter structure, while maintaining an equiripple return loss. In addition to theory, a combline filter prototype is also fabricated, tuned and measured in several configurations showing excellent agreement with simulations, thereby fully validating both the basic concept and the design procedure.
- Open Access
- 22 May 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 11, 52168-52184
Efficient Design Procedure for Combline Bandpass Filters With Advanced Electrical Responses
In this paper, a very efficient procedure for designing waveguide combline bandpass filters with an advanced electrical response is presented. The proposed technique is based on a segmentation strategy, which reduces the number of variables to be optimized by dividing the design process into simpler stages. The electrical response of an appropriate equivalent circuit model of the waveguide structure considered in each stage is used to generate the target curve needed in the optimization process. Moreover, the well-known Aggressive Space Mapping technique has been also implemented to improve the computational efficiency of the whole method. In order to validate the proposed design procedure, two high-order combline bandpass filters, with symmetric and asymmetric electrical responses including transmission zeros, have been successfully designed and simulated with full-wave analysis tools. Furthermore, as an experimental validation, a prototype of the symmetric filter has been manufactured, showing a good agreement between simulated and experimental data.
- 22 May 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 11, 52168-52184
Open AccessEfficient Design Procedure for Combline Bandpass Filters With Advanced Electrical Responses
In this paper, a very efficient procedure for designing waveguide combline bandpass filters with an advanced electrical response is presented. The proposed technique is based on a segmentation strategy, which reduces the number of variables to be optimized by dividing the design process into simpler stages. The electrical response of an appropriate equivalent circuit model of the waveguide structure considered in each stage is used to generate the target curve needed in the optimization process. Moreover, the well-known Aggressive Space Mapping technique has been also implemented to improve the computational efficiency of the whole method. In order to validate the proposed design procedure, two high-order combline bandpass filters, with symmetric and asymmetric electrical responses including transmission zeros, have been successfully designed and simulated with full-wave analysis tools. Furthermore, as an experimental validation, a prototype of the symmetric filter has been manufactured, showing a good agreement between simulated and experimental data.
- Open Access
- 20 April 2023
- Published by Institute of Technical and Scientific Research in International Journal of Technical Research & Science
- Vol. 8 (04)
DESIGN OF PID STRUCTURED TCSC CONTROLLER FOR SMALL SIGNAL STABILITY IMPROVEMENT USING GRAY WOLF OPTIMIZATION ALGORITHM
- 20 April 2023
- Published by Institute of Technical and Scientific Research in International Journal of Technical Research & Science
- Vol. 8 (04)
Open AccessDESIGN OF PID STRUCTURED TCSC CONTROLLER FOR SMALL SIGNAL STABILITY IMPROVEMENT USING GRAY WOLF OPTIMIZATION ALGORITHM
- 12 April 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Technology Letters
- Vol. 33 (6) , 827-830
Bandwidth-Reconfigurable Coaxial Bandpass Filter With Multioctave Tuning Using a Single Element
A bandwidth (BW) tunable coaxial-loaded waveguide filter is presented in this letter based on a novel concept using a single tuning element. The operation principle relies on the rotation of coaxial resonators with respect to fixed irises in order to change the inter-resonator (IR) coupling strengths that control the BW. This mechanism features multioctave tuning while maintaining a fixed operating frequency and a stable unloaded quality factor with only one rotary post. Furthermore, the filter can be switched off by using the same tuning mechanism. A prototype is manufactured and measured to verify the proposed filter. The measured results demonstrate multioctave BW tunability from 12 to 83 MHz (tuning ratio $>$ 6.9:1), promoting the technique for multistandard communication systems and applications.
- 12 April 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Technology Letters
- Vol. 33 (6) , 827-830
Bandwidth-Reconfigurable Coaxial Bandpass Filter With Multioctave Tuning Using a Single Element
A bandwidth (BW) tunable coaxial-loaded waveguide filter is presented in this letter based on a novel concept using a single tuning element. The operation principle relies on the rotation of coaxial resonators with respect to fixed irises in order to change the inter-resonator (IR) coupling strengths that control the BW. This mechanism features multioctave tuning while maintaining a fixed operating frequency and a stable unloaded quality factor with only one rotary post. Furthermore, the filter can be switched off by using the same tuning mechanism. A prototype is manufactured and measured to verify the proposed filter. The measured results demonstrate multioctave BW tunability from 12 to 83 MHz (tuning ratio $>$ 6.9:1), promoting the technique for multistandard communication systems and applications.
- Open Access
- 6 February 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 71 (7) , 3051-3064
Remote Reconfiguration of Microwave Filters Using Dielectric Tuners
The objective of this article is to explore the use of dielectrics to reconfigure remotely microwave filters in rectangular waveguide. To start, we study experimentally the phase shift that is achievable using dielectric tuning elements in a rectangular waveguide. We then compare the results obtained with the performance of standard metallic tuning cylinders and screws. Next, the passive intermodulation (PIM) behavior of dielectric tuning elements is investigated experimentally. The PIM results obtained using dielectrics are then compared with the ones of metallic tuning elements. After that, the measured results for a filter tuned with a number of different dielectric tuning elements are discussed to identify the required relation between cavity size, dielectric constant, and tuner diameter. As a proof of concept, we then design, manufacture, and test two filters, one in WR75 and the other in WR90. Both simulated and measured results are then presented clearly demonstrating that the structures discussed can indeed be reconfigured (or tuned) both in terms of filter center frequency and bandwidth. Finally, computer-driven linear actuators are connected to the dielectric tuners, and the remote tuning capability is successfully demonstrated.
- 6 February 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 71 (7) , 3051-3064
Open AccessRemote Reconfiguration of Microwave Filters Using Dielectric Tuners
The objective of this article is to explore the use of dielectrics to reconfigure remotely microwave filters in rectangular waveguide. To start, we study experimentally the phase shift that is achievable using dielectric tuning elements in a rectangular waveguide. We then compare the results obtained with the performance of standard metallic tuning cylinders and screws. Next, the passive intermodulation (PIM) behavior of dielectric tuning elements is investigated experimentally. The PIM results obtained using dielectrics are then compared with the ones of metallic tuning elements. After that, the measured results for a filter tuned with a number of different dielectric tuning elements are discussed to identify the required relation between cavity size, dielectric constant, and tuner diameter. As a proof of concept, we then design, manufacture, and test two filters, one in WR75 and the other in WR90. Both simulated and measured results are then presented clearly demonstrating that the structures discussed can indeed be reconfigured (or tuned) both in terms of filter center frequency and bandwidth. Finally, computer-driven linear actuators are connected to the dielectric tuners, and the remote tuning capability is successfully demonstrated.
- 25 August 2016
- Published by Springer Nature
- p. 245-251
Novel All-Optical Encoding and Decoding Scheme for Code Preservation
- 25 August 2016
- Published by Springer Nature
- p. 245-251
Novel All-Optical Encoding and Decoding Scheme for Code Preservation