HKHiroko Kuwata

Hiroko Kuwata

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Hiroko Kuwata has a total of 7 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Improved synthesis enables assessment of the electrochemical window of monocarborate solid state electrolytes

    by Oscar Tutusaus, Hiroko Kuwata, Michael J. Counihan, Rana Mohtadi

    We synthesized Li and Na monocarborate salts with minimal protic impurities and reassessed their electrochemical windows. Na salts display higher efficiency for metal deposition/stripping and are more oxidatively stable than Li salts. This strong cation effect is rationalized in terms of differences in charge density between Li+ and Na+ cations.


  • Open Access

    Destabilized Passivation Layer on Magnesium-Based Intermetallics as Potential Anode Active Materials for Magnesium Ion Batteries

    by Masaki Matsui, Hiroko Kuwata, Daisuke Mori, Nobuyuki Imanishi, Minoru Mizuhata

    Passivation of magnesium metal anode is one of the critical challenges for the development of magnesium batteries. Here we investigated the passivation process of an intermetallic anode: Mg3Bi2 synthesized by solid-state and thin film process. The Mg3Bi2 composite electrode shows excellent reversibility in magnesium bis(trifluoromethansulfonylamide) dissolved in acetonitrile, while Mg3Sb2, which has same crystal structure and similar chemical properties, is electrochemically inactive. We also fabricated the Mg3Bi2 thin film electrodes, which show reversibility with low overpotential not only in the acetonitrile solution but also glyme-based solutions. Surface layer corresponding to the decomposed TFSA anion is slightly suppressed in the case of the Mg3Bi2 thin film electrode, compared with Mg metal. Comparative study of hydrolysis process of the Mg3Bi2 and the Mg3Sb2 suggests that the both intermetallic anodes are not completely passivated. The bond valence sum mapping of the Mg3Bi2 indicates that the fast Mg2+ diffusion pathway between 2d tetrahedral sites is formed. The electrochemical properties of the Mg3Bi2 anode is mainly due to the less passivation surface with the fast Mg2+ diffusion pathways.


  • In Operando FTIR Spectroscopy for Lithium-Ion Batteries

    by Masaki Matsui, Hiroko Kuwata, Nobuyuki Imanishi

    Introduction Lithium-ion batteries have been staying at the center of the advanced battery technologies after the first production by SONY in 1991. Recent R&D activities for the advanced lithium-ion battery are focusing on vehicle applications such as hybrid electrical vehicles (HEV), plug-in hybrid electrical vehicles (PHEV) and electric vehicles (EV). Compared with the consumer electronic devices such as mobile phones or laptop computers, the average lifetime of a vehicle is much longer, hence the lithium-ion batteries for vehicle application requires much linger cycle life and calendar life. Since diagnostic studies of the batteries are crucial for the improvement of the cycle life and the calendar life of the batteries, vigorous analytical studies were carried out to understand the degradation mode of the lithium-ion batteries. Electrochemical in situ spectroscopies are powerful analytical techniques for the degradation study of the batteries. However since the in situ spectroscopy cell always has to have some special design, sometimes the operation mode of the in situcell is different from that of the practical battery system. In situ FTIR spectroscopy is one of the popular analytical techniques to characterize the surface film of the electrodes. Especially the technique is very useful for studying the decomposition process of the electrolyte solutions. One of the biggest challenges in the in situ FTIR spectroscopy of lithium-ion battery materials is preparation of the thin film electrode to obtain enough reflection of the infrared beam [1]. Furthermore, in the case of the internal reflection geometry, the thin film electrode has to face to the window material; as a consequence high rate charging-discharging process is not applicable for the in situcell. In the present work, we designed a new in situ FTIR cell based on a diamond-ATR optical system. A common battery testing conditions were applicable during the in situ FTIR measurements and various common battery materials such as LiCoO2 and graphite can be used as composite electrode form, containing electron conductive materials and binder, without any special treatment. Therefore here we introduce the new measurement technique as “in operandoFTIR spectroscopy” for lithium ion batteries. Results and Discussions All the spectra were taken at single beam mode and Subtractively normalized interfacial FTIR spectra were calculated. Fig. 1 shows in operando FTIR spectra for LiCoO2 composite electrode operated at C/3 constant current charging-discharging process (top) associated with the charging-discharging profile (bottom). Significant spectrum changes were observed at the beginning of the charging process and at the end of the discharging process. We suspect this spectrum change is initiated by the semiconductor-metal transition of LiCoO2. The spectra were relatively stable in the middle of the charging or discharging process. Another spectrum changes were observed at the end of charging process. It suggests the electrolyte decomposition occurs at high electrode potential above 4.3 V vs. Li. More in operandoFTIR measurement results for various electrode materials will be presented in the meeting. Reference [1] M. Matsui, K. Dokko and K. Kanamura, Journal of The Electrochemical Society, 157 (2010) A121-A129