G.т. Mustapayeva
Research Subjects
G.т. Mustapayeva has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Akkenzhe Bussurmanova
Pedagogy Faculty, Yessenov University, 32 Microdistrict, Aktau 130003, Kazakhstan
2 shared publications - Anar Akkenzheyeva
Engineering Faculty, Yessenov University, 32 Microdistrict, Aktau 130003, Kazakhstan
2 shared publications - Murshida Aimova
Pedagogy Faculty, Yessenov University, 32 Microdistrict, Aktau 130003, Kazakhstan
2 shared publications - Uzilkhan Yensegenova
Faculty of Chemistry and Chemical Technology, Al-Farabi Kazakh National University, Al-Farabi Ave. 71, Almaty 050040, Kazakhstan
2 shared publications - A.I. Koishina
CASPIAN UNIVERSITY OF TECHNOLOGIES AND ENGINEERING NAMED AFTER Sh.YESSENOV
1 shared publication - Aigul Gusmanova
Department of Geology and Petrochemical Engineering, Yessenov University, Aktau 130000, Kazakhstan
1 shared publication
Latest Publications
- 30 June 2024
- Published by Oil Research and Engineering Center of the National Engineering Academy of the Republic of Kazakhstan in Neft i Gaz
- No. 3,p. 175-186
Investigation of modification of petroleum bitumen with fine rubber crumb
Currently, in the world, due to the constant desire for recycling, many countries are considering the possibility of using rubber waste on roads. Bitumen modification for roads in Kazakhstan is considered one of the most suitable and popular approaches. This article presents the results of research on the modification of bitumen with rubber chips obtained from rubber waste. The document describes in detail the details of using rubber chips as bitumen modifiers, with particular emphasis on how they can potentially be used to improve bitumen performance and road durability. A wet process is used to produce rubber-bitumen binders. The wet process modifies the asphalt binder directly by pre-mixing with rubber crumbs at elevated temperatures, it leads to the fact that the material turns out to be the most stable, with increased elasticity and viscosity at high temperatures. The main physical and mechanical characteristics of the modified bitumen were determined after standard tests: penetration and plasticity, softening temperatures. The morphology of the modified bitumen was studied using scanning electron microscopy. The results confirm that bitumen modified with a rubber crumb with the addition of SBS meets the requirements for a polymer-bitumen binder of Kazakhstani standards and, according to its physico-chemical characteristics, is suitable for the production of modified bitumen.
- 30 June 2024
- Published by Oil Research and Engineering Center of the National Engineering Academy of the Republic of Kazakhstan in Neft i Gaz
- No. 3,p. 175-186
Investigation of modification of petroleum bitumen with fine rubber crumb
Currently, in the world, due to the constant desire for recycling, many countries are considering the possibility of using rubber waste on roads. Bitumen modification for roads in Kazakhstan is considered one of the most suitable and popular approaches. This article presents the results of research on the modification of bitumen with rubber chips obtained from rubber waste. The document describes in detail the details of using rubber chips as bitumen modifiers, with particular emphasis on how they can potentially be used to improve bitumen performance and road durability. A wet process is used to produce rubber-bitumen binders. The wet process modifies the asphalt binder directly by pre-mixing with rubber crumbs at elevated temperatures, it leads to the fact that the material turns out to be the most stable, with increased elasticity and viscosity at high temperatures. The main physical and mechanical characteristics of the modified bitumen were determined after standard tests: penetration and plasticity, softening temperatures. The morphology of the modified bitumen was studied using scanning electron microscopy. The results confirm that bitumen modified with a rubber crumb with the addition of SBS meets the requirements for a polymer-bitumen binder of Kazakhstani standards and, according to its physico-chemical characteristics, is suitable for the production of modified bitumen.