SLShaoyu Lei

Shaoyu Lei

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Shaoyu Lei has a total of 27 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Wide-range TMR sensing with array-scaled low-frequency field resolution for strong near-field analog tracking

    by Chongming Li, Yuanzhen Liu, Qing Liu, Wen Lin, Shuhui Liu, Zhenhao Liu, Shaoyu Lei, Peisen Li, Bin Fang, Zhongming Zeng

    Strong near-field analog sensing requires magnetic sensors to accommodate large field excursions without saturation while retaining sufficient resolution for small low-frequency field variations. In tunneling magnetoresistance (TMR) sensors, extending the linear range through increased effective magnetic anisotropy reduces the field sensitivity and consequently penalizes the noise-equivalent field resolution. Here, we investigate this range–sensitivity–resolution coupling in perpendicular synthetic antiferromagnetic (p-SAF) TMR sensors. The CoFeB free-layer thickness is systematically varied from 1.6 to 2.2 nm to tune the effective anisotropy and establish the range–sensitivity relationship, yielding a hysteresis-free linear response over the experimentally accessible range of at least ±1000 Oe. We subsequently vary the number of series-connected magnetic tunnel junctions under otherwise comparable magnetic and electrical conditions to determine whether array scaling can recover the low-frequency detectivity penalty associated with wide-range operation. Increasing N from 200 to 2000 improves detectivity DB from 2.27 to 1.04μT/Hz at 10 Hz, while all arrays retain a verified linear-range lower bound of ±1000 Oe. The optimized array is finally evaluated in a magnetic-switch prototype as a representative strong near-field analog sensing platform, where continuous non-saturating response is maintained under a strongly varying magnetic field. Building on low-current sensor operation, a proposed ADC-free time-over-threshold readout architecture is further explored as a prospective system-level strategy for reducing data-conversion overhead. These results identify free-layer anisotropy and array size as complementary design variables for jointly controlling wide-range response and low-frequency field resolution, while highlighting their potential for low-power strong near-field analog sensing systems.

  • A Comprehensive Anisotropy Regulation Strategy for Performance Optimization of Tunneling Magnetoresistance Sensors

    by Shaoyu Lei, Dixiang Chen, Yuanzhen Liu, Shiyi Zhang, Jian Li, Mengchun Pan, Jiafei Hu, Qingfa Du, Bin Fang, Wen Lin, et al.

  • A Simulation Method for Response and Noise of Magnetic Tunnel Junctions

    by Shaoyu Lei, Shiyi Zhang, Yuanzhen Liu, Pan Mengchun, Hu Jiafei, Hu Yueguo, Peng Junping, Qiu Weicheng, Bin Fang, Lin Wen, et al.

    The performance and detectivity of Tunnel Magnetoresistance (TMR) sensors are fundamentally constrained by a significant interdependence between their response and noise characteristics. The physical mechanisms underlying this coupling, however, remain insufficiently understood. This study develops theoretical models integrating the Stoner–Wohlfarth (S–W) model for quasi-static magnetization reversal and the Landau–Lifshitz–Gilbert (LLG) equation for thermally driven magnetic moment fluctuations. These models reveal the intrinsic correlation between magnetic response and 1/f noise in magnetic tunnel junctions (MTJs). A simulation method is subsequently established to concurrently analyze static response metrics and transient noise sources. Experimental validation on elliptical MTJs shows that enhanced shape anisotropy extends the linear operating range by 40%, suppresses hysteresis by 60%, and improves zero-field sensitivity by 25%, albeit at the expense of peak sensitivity. Simulations further indicate that increasing shape anisotropy from 10 Oe to 50 Oe reduces noise extremes by 35% while shifting detectivity maxima toward zero-field regions. The coupling mechanism originates from the fact that both the noise and the sensitivity are governed by the thermal fluctuations of the magnetic moment around its stable state. This model provides a crucial design tool for the optimized design of Tunnel Magnetoresistance (TMR) magnetic sensors.


  • Open Access

    Non-orthogonal two-step annealing method for linearized magnetic tunnel junction sensors

    by Xinmiao Zhang, Mengchun Pan, Shaoyu Lei, Minhui Ji, Yueguo Hu, Jiafei Hu, Dixiang Chen, Junping Peng, Weicheng Qiu, Peisen Li

    The orthogonal two-step annealing process is an effective strategy to linearize the response of magnetic tunnel junctions for magnetic field sensors. However, the response after the orthogonal annealing is inevitably modulated by the Neel effect from the reference layer, which results in an unexpected shift of the linear interval and a disappointing sensitivity deterioration in the weak field. Here, a non-orthogonal two-step annealing method is proposed to suppress the shift by compensating for the Neel coupling field. Experimental results show that the curve shift of junctions annealed in the non-orthogonal direction of 120° is 47.6% lower than that in the orthogonal one, with a significant sensitivity promotion in the weak field and little hysteresis increment. A simple energy minimization model is introduced to explain the results. Based on the model, the suppression of the curve shift is fulfilled with the effective field compensation for the Neel coupling field, modulated by the non-orthogonal annealing. Finally, Wheatstone bridge devices are constructed, and the bridge with non-orthogonally annealed junctions is found to have an increased sensitivity of 46.8% in the major loop along the sensing axis. Additionally, the non-orthogonal annealing method is also effective in suppressing the cross sensitivity, which is important for further application to three-axis magnetic sensors.