Bochen Luo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Bochen Luo has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Xiaoling Xiong
State Key Laboratory of Alternate Electrical Power System with Renewable Energy Sources, North China Electric Power University (NCEPU), Beijing, China
4 shared publications - Frede Blaabjerg
Aalborg University
3 shared publications - Chengyong Zhao
State Key Laboratory of Alternate Electrical Power System with Renewable Energy Sources, North China Electric Power University (NCEPU), Beijing, China
1 shared publication - Longcan Li
School of Electrical and Electronic Engineering, North China Electric Power University, Beijing, China
1 shared publication - Meng Huang
Wuhan University
1 shared publication - Peng Cheng
China Institute of Energy and Transportation Integrated Development, North China Electric Power University, Beijing, China
1 shared publication
Latest Publications
- 13 September 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 40 (1) , 422-434
Impedance Reshaping Method Based on Compensating PLL Dynamic to Improve Active Power Transfer Capability of VSC Under Weak Grid
The vector current control scheme based on the phase-locked loop (PLL) is widely used in grid-connected voltage-source converters (VSCs). However, the power transfer capability of the VSC will first be limited by dynamic power limitation (DPL) and then by static power limitation (SPL). The SPL is determined by the steady-state operation of the system, such as steady-state algebraic equations. Simultaneously, the DPL mainly relies on control strategy and controller parameters, which is also called the small-signal stability boundary and will not exceed SPL. In this article, the SPL and DPL of the VSC with different outer control loops are investigated, i.e., active power and reactive power (PQ) outer control loops, or active power and ac voltage (PV) outer control loops. It is found that extra reactive power injected into the grid is beneficial for improving the SPL and DPL of the VSC, especially under weak grid conditions. To maximize the SPL within the power constraint of VSC, the optimal design method for power references is presented. Meanwhile, a comparative analysis for the SPL of VSC with PQ or PV control loops is given, and the application scenario of both control strategies is clarified. Furthermore, aiming at the main factor restricting the DPL, i.e., PLL influence, an impedance reshaping method based on compensating PLL dynamics is proposed to increase the DPL of VSC, resulting in the DPL of the VSC almost extended to SPL. Finally, simulation and experimental tests are also carried out, and the results validate the effectiveness of the proposed methods.
- 13 September 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 40 (1) , 422-434
Impedance Reshaping Method Based on Compensating PLL Dynamic to Improve Active Power Transfer Capability of VSC Under Weak Grid
The vector current control scheme based on the phase-locked loop (PLL) is widely used in grid-connected voltage-source converters (VSCs). However, the power transfer capability of the VSC will first be limited by dynamic power limitation (DPL) and then by static power limitation (SPL). The SPL is determined by the steady-state operation of the system, such as steady-state algebraic equations. Simultaneously, the DPL mainly relies on control strategy and controller parameters, which is also called the small-signal stability boundary and will not exceed SPL. In this article, the SPL and DPL of the VSC with different outer control loops are investigated, i.e., active power and reactive power (PQ) outer control loops, or active power and ac voltage (PV) outer control loops. It is found that extra reactive power injected into the grid is beneficial for improving the SPL and DPL of the VSC, especially under weak grid conditions. To maximize the SPL within the power constraint of VSC, the optimal design method for power references is presented. Meanwhile, a comparative analysis for the SPL of VSC with PQ or PV control loops is given, and the application scenario of both control strategies is clarified. Furthermore, aiming at the main factor restricting the DPL, i.e., PLL influence, an impedance reshaping method based on compensating PLL dynamics is proposed to increase the DPL of VSC, resulting in the DPL of the VSC almost extended to SPL. Finally, simulation and experimental tests are also carried out, and the results validate the effectiveness of the proposed methods.
- 19 August 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 39 (12) , 15858-15869
An Additional Damping Torque Method for Low-Frequency Stability Enhancement of Virtual Synchronous Generators
Low-frequency oscillations may occur in a virtual synchronous generator (VSG), resulting from an insufficient equivalent damping ration, which may be a serious stability issue for VSG. Thus, an additional damping ration is expected to be provided without affecting droop behaviors and the inertia response of VSG. To that end, an analytical approach based on combining a damping torque model and a small-signal model is developed to investigate the damping behaviors of the VSG. The relationship between the two models is brought to light, indicating that the damping torque model is suitable for qualitative analysis to give the contribution of different feedback loops to the system damping level. Subsequently, the latter is adopted for quantitative analysis to illustrate the damping ration of the system. Furthermore, an additional damping torque method is proposed, which can provide an extra damping ration for the system by increasing the equivalent positive damping torque and guaranteeing that the original droop characteristics and inertia are not compromised. Besides, the proposed control method is implemented by inserting an auxiliary branch into the power control loops of VSG. Experimental results verify the theoretical analysis and the effectiveness of the proposed additional damping method.
- 19 August 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 39 (12) , 15858-15869
An Additional Damping Torque Method for Low-Frequency Stability Enhancement of Virtual Synchronous Generators
Low-frequency oscillations may occur in a virtual synchronous generator (VSG), resulting from an insufficient equivalent damping ration, which may be a serious stability issue for VSG. Thus, an additional damping ration is expected to be provided without affecting droop behaviors and the inertia response of VSG. To that end, an analytical approach based on combining a damping torque model and a small-signal model is developed to investigate the damping behaviors of the VSG. The relationship between the two models is brought to light, indicating that the damping torque model is suitable for qualitative analysis to give the contribution of different feedback loops to the system damping level. Subsequently, the latter is adopted for quantitative analysis to illustrate the damping ration of the system. Furthermore, an additional damping torque method is proposed, which can provide an extra damping ration for the system by increasing the equivalent positive damping torque and guaranteeing that the original droop characteristics and inertia are not compromised. Besides, the proposed control method is implemented by inserting an auxiliary branch into the power control loops of VSG. Experimental results verify the theoretical analysis and the effectiveness of the proposed additional damping method.
- 22 December 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 39 (4) , 4006-4016
Impedance Reshaping Method of DFIG System Based on Compensating Rotor Current Dynamic to Eliminate PLL Influence
The phase-locked loop (PLL) used in the doubly-fed induction generator (DFIG) can cause frequency-coupling phenomena, which will give negative-resistance characteristics of the DFIG at a low frequency, resulting in stability issues under weak-grid operation. Based on the multi-input multi-output impedance model of the DFIG system, it is found that the frequency-coupling phenomena are mainly introduced by the transfer function matrix related to the rotor current dynamic. This article presents an improved impedance reshaping method based on compensating the rotor current dynamic to reduce the influence of PLL, in which the rotor current dynamic is compensated before being introduced to the PI controller. Thus, the frequency-coupling effect can be almost eliminated, and the stability of the DFIG is improved a lot. Furthermore, a simplified compensation method is proposed, which can easily be implemented. The robustness analysis is performed to illustrate the availability of the proposed methods when the system operating conditions and parameters vary. Finally, control-hardware-in-the-loop experiments are also carried out, and the results validate the effectiveness of the proposed methods.
- 22 December 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 39 (4) , 4006-4016
Impedance Reshaping Method of DFIG System Based on Compensating Rotor Current Dynamic to Eliminate PLL Influence
The phase-locked loop (PLL) used in the doubly-fed induction generator (DFIG) can cause frequency-coupling phenomena, which will give negative-resistance characteristics of the DFIG at a low frequency, resulting in stability issues under weak-grid operation. Based on the multi-input multi-output impedance model of the DFIG system, it is found that the frequency-coupling phenomena are mainly introduced by the transfer function matrix related to the rotor current dynamic. This article presents an improved impedance reshaping method based on compensating the rotor current dynamic to reduce the influence of PLL, in which the rotor current dynamic is compensated before being introduced to the PI controller. Thus, the frequency-coupling effect can be almost eliminated, and the stability of the DFIG is improved a lot. Furthermore, a simplified compensation method is proposed, which can easily be implemented. The robustness analysis is performed to illustrate the availability of the proposed methods when the system operating conditions and parameters vary. Finally, control-hardware-in-the-loop experiments are also carried out, and the results validate the effectiveness of the proposed methods.
- 31 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 38 (6) , 6945-6955
Analysis and Suppression Strategy of Synchronous Frequency Resonance for Grid-Connected Converters With Power-Synchronous Control Method
The power-synchronization control (PSC) method of grid-connected converters, which is based on the active power orientation, is a promising solution for high-penetration renewable power generation systems. Unfortunately, synchronous frequency resonance (SFR) is inevitably found in PSC-controlled converters, especially when connected to inductive networks, which seriously damages the stability of the system. The relatively small equivalent resistance of the inductive network is regarded as the main cause of SFR, and a virtual resistor (VR) is usually employed to dampen this kind of oscillation. However, another important reason for SFR is the nonminimum phase effect of the loop gains, which is discussed in this article. Considering the dynamics of the grid equivalent inductance, the small-signal model of PSC-controlled converter is established. By this, the mechanism of SFR and the nonminimum phase effect are revealed. Furthermore, a conjugate poles elimination control method based on auxiliary branches introduced into the power control loops is proposed to suppress SFR, which can also broaden the control bandwidth compared with the VR method. Finally, the theoretical analysis is verified by simulations and hardware-in-loop experimental results.
- 31 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 38 (6) , 6945-6955
Analysis and Suppression Strategy of Synchronous Frequency Resonance for Grid-Connected Converters With Power-Synchronous Control Method
The power-synchronization control (PSC) method of grid-connected converters, which is based on the active power orientation, is a promising solution for high-penetration renewable power generation systems. Unfortunately, synchronous frequency resonance (SFR) is inevitably found in PSC-controlled converters, especially when connected to inductive networks, which seriously damages the stability of the system. The relatively small equivalent resistance of the inductive network is regarded as the main cause of SFR, and a virtual resistor (VR) is usually employed to dampen this kind of oscillation. However, another important reason for SFR is the nonminimum phase effect of the loop gains, which is discussed in this article. Considering the dynamics of the grid equivalent inductance, the small-signal model of PSC-controlled converter is established. By this, the mechanism of SFR and the nonminimum phase effect are revealed. Furthermore, a conjugate poles elimination control method based on auxiliary branches introduced into the power control loops is proposed to suppress SFR, which can also broaden the control bandwidth compared with the VR method. Finally, the theoretical analysis is verified by simulations and hardware-in-loop experimental results.