Jorge Rodríguez Muro
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jorge Rodríguez Muro has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Inés Durán
Universidad Politecnica de Madrid Instituto de Energia Solar
2 shared publications - Patricia Cancho García
Universidad Politecnica de Madrid Instituto de Energia Solar
2 shared publications - Simon Aurel Svatek
Universidad Politécnica de Madrid
2 shared publications - Antonio Martí
Universidad Politécnica de Madrid
1 shared publication - Carlos Bueno-Blanco
Instituto de Energía Solar, Universidad Politécnica de Madrid, Avenida Complutense 30, Madrid 28040, Spain
1 shared publication Der-Yuh Lin
National Changhua University of Education
1 shared publication
Latest Publications
- Open Access
- 11 November 2026
- Published by IOP Publishing in 2D Materials
Maximising photocurrent in ultrathin Nb-doped MoS2 Schottky solar cells
In ultrathin transition-metal dichalcogenide (TMDC) Schottky solar cells, photocurrent is difficult to control when rectifying-junction formation and hole extraction cannot be optimised independently. Here we separate these functions in Nb-doped MoS2 devices and show that the photogenerated current can be predicted to first order from its optical limit. Using dry van der Waals assembly, we contact p-MoS2 through a heavily doped p+-MoS2/Au hole-extraction layer while independently defining the rectifying interface with Cr or Ag. Scanning photocurrent microscopy localizes the response to the metal/p-MoS2 overlap, and EQE combined with transfer-matrix modelling shows that the spectral photocurrent follows absorptance in the MoS2 layer of the full optical stack. In a before-and-after test on the same device, adding h-BN increases the modelled absorbed-photon limit and the measured photovoltaic output, consistent with h-BN modifying MoS2 absorptance through thin-film interference in the multilayer stack. Across Ag-contacted devices, the experimental photogenerated current density scales with the stack-specific optical-limit current density and is described by an effective AM1.5G-weighted collection factor of approximately 0.86. A representative device reaches 3.0% power conversion efficiency under AM1.5G illumination. These results provide a practical way to predict and improve photocurrent in ultrathin TMDC Schottky photovoltaics from measurable stack parameters.
- 11 November 2026
- Published by IOP Publishing in 2D Materials
Open AccessMaximising photocurrent in ultrathin Nb-doped MoS2 Schottky solar cells
In ultrathin transition-metal dichalcogenide (TMDC) Schottky solar cells, photocurrent is difficult to control when rectifying-junction formation and hole extraction cannot be optimised independently. Here we separate these functions in Nb-doped MoS2 devices and show that the photogenerated current can be predicted to first order from its optical limit. Using dry van der Waals assembly, we contact p-MoS2 through a heavily doped p+-MoS2/Au hole-extraction layer while independently defining the rectifying interface with Cr or Ag. Scanning photocurrent microscopy localizes the response to the metal/p-MoS2 overlap, and EQE combined with transfer-matrix modelling shows that the spectral photocurrent follows absorptance in the MoS2 layer of the full optical stack. In a before-and-after test on the same device, adding h-BN increases the modelled absorbed-photon limit and the measured photovoltaic output, consistent with h-BN modifying MoS2 absorptance through thin-film interference in the multilayer stack. Across Ag-contacted devices, the experimental photogenerated current density scales with the stack-specific optical-limit current density and is described by an effective AM1.5G-weighted collection factor of approximately 0.86. A representative device reaches 3.0% power conversion efficiency under AM1.5G illumination. These results provide a practical way to predict and improve photocurrent in ultrathin TMDC Schottky photovoltaics from measurable stack parameters.
- Open Access
- 5 February 2025
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 8 (6) , 3500-3508
High Conductivity and Thermoelectric Power Factor in p-Type MoS2 Nanosheets
Transition metal dichalcogenides, particularly Nb-doped MoS2, present unique electronic and thermoelectric properties that make them promising candidates for a variety of applications, including photovoltaic cells and thermoelectric devices. Here, we investigate the influence of controlled substitutional doping on the electrical conductivity and thermoelectric performance of MoS2 as a function of crystal thickness. We report an exceptional bulk conductivity of up to 360 ± 30 S cm-1 and a peak power factor of 370 ± 80 μW m-1 K-2 at room temperature. Our findings reveal that the interplay between doping concentration and thickness can decouple the Seebeck coefficient from electrical conductivity, overcoming the typical trade-off observed in conventional materials. This research highlights the role of surface effects and depletion regions in p-type transition metal dichalcogenides, providing a pathway for developing efficient bipolar thermoelectric devices. The stability and tunability of p-type doping in MoS2 also suggest potential applications in microscale cooling, thermal sensors, and photovoltaic systems.
- 5 February 2025
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 8 (6) , 3500-3508
Open AccessHigh Conductivity and Thermoelectric Power Factor in p-Type MoS2 Nanosheets
Transition metal dichalcogenides, particularly Nb-doped MoS2, present unique electronic and thermoelectric properties that make them promising candidates for a variety of applications, including photovoltaic cells and thermoelectric devices. Here, we investigate the influence of controlled substitutional doping on the electrical conductivity and thermoelectric performance of MoS2 as a function of crystal thickness. We report an exceptional bulk conductivity of up to 360 ± 30 S cm-1 and a peak power factor of 370 ± 80 μW m-1 K-2 at room temperature. Our findings reveal that the interplay between doping concentration and thickness can decouple the Seebeck coefficient from electrical conductivity, overcoming the typical trade-off observed in conventional materials. This research highlights the role of surface effects and depletion regions in p-type transition metal dichalcogenides, providing a pathway for developing efficient bipolar thermoelectric devices. The stability and tunability of p-type doping in MoS2 also suggest potential applications in microscale cooling, thermal sensors, and photovoltaic systems.