Xue-Qing Dong
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Xue-Qing Dong has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
Haojie Lu
School of Energy and Power Engineering, Inner Mongolia University of Technology 1 , Hohhot 010051
1 shared publicationJianwen Wang
School of Energy and Power Engineering, Inner Mongolia University of Technology 1 , Hohhot 010051
1 shared publication- Jianwen Wang
College of Energy and Power Engineering, Inner Mongolia University of Technology, Hohhot, China
1 shared publication - Kefa Cen
Zhejiang University
1 shared publication - Kun Luo
State Key Laboratory of Clean Energy Utilization, Zhejiang University, Hangzhou 310027, China
1 shared publication - Kunzan Qiu
Zhejiang University
1 shared publication
Latest Publications
- 1 January 2025
- Published by AIP Publishing in Journal of Renewable and Sustainable Energy
- Vol. 17 (1)
Experimental study on the near wake recovery of horizontal axis wind turbines with blades of different trailing edge thickness
Based on the traditional sharp trailing edge airfoil, on the research that the rational change of trailing edge thickness of airfoil can improve the lift-drag ratio, this paper uses the method of symmetrical thickening of the trailing edge to trailing edge thickness of the airfoils at various parts of the small horizontal axis wind turbine blades independently designed using the NACA4415 airfoil. After scaling down, the blades are fabricated for wind tunnel tests. The experiment shows that compared with the sharp trailing edge blades, in the region at the same position where x/R = 2–4, the wake expansion and the change in turbulence intensity of the blade with a trailing edge thickness of 3%c are the most significant. The expansion ratio is approximately 3.3%, and the turbulence intensity is reduced by about 3% compared to that of the original blade. At the position where x/R = 4, the turbulence intensity is reduced by about 2.5% compared to that of the original blade. When tip speed ratio (TSR) = 5, the rotor power of the blade with 3%c trailing edge thickness has the maximum increase, which is 7.01% compared with the original blade. The blade with changed trailing edge thickness has more significant power generation efficiency when the TSR is high and can adapt to harsher environments in wind farms.
- 1 January 2025
- Published by AIP Publishing in Journal of Renewable and Sustainable Energy
- Vol. 17 (1)
Experimental study on the near wake recovery of horizontal axis wind turbines with blades of different trailing edge thickness
Based on the traditional sharp trailing edge airfoil, on the research that the rational change of trailing edge thickness of airfoil can improve the lift-drag ratio, this paper uses the method of symmetrical thickening of the trailing edge to trailing edge thickness of the airfoils at various parts of the small horizontal axis wind turbine blades independently designed using the NACA4415 airfoil. After scaling down, the blades are fabricated for wind tunnel tests. The experiment shows that compared with the sharp trailing edge blades, in the region at the same position where x/R = 2–4, the wake expansion and the change in turbulence intensity of the blade with a trailing edge thickness of 3%c are the most significant. The expansion ratio is approximately 3.3%, and the turbulence intensity is reduced by about 3% compared to that of the original blade. At the position where x/R = 4, the turbulence intensity is reduced by about 2.5% compared to that of the original blade. When tip speed ratio (TSR) = 5, the rotor power of the blade with 3%c trailing edge thickness has the maximum increase, which is 7.01% compared with the original blade. The blade with changed trailing edge thickness has more significant power generation efficiency when the TSR is high and can adapt to harsher environments in wind farms.
- Open Access
- 8 July 2015
- Published by Zhejiang University Press in Journal of Zhejiang University-SCIENCE A
- Vol. 16 (7) , 586-595
Time resolved particle image velocimetry experimental study of the near wake characteristics of a horizontal axis wind turbine
Wind tunnel experiments at a model scale have been carried out to investigate the flow characteristics in the near wake of a wind turbine. Time resolved particle image velocimetry (TRPIV) measurements are applied to visualize the wind turbine wake flow. The instantaneous vorticity, average velocities, turbulence kinetic energy, and Reynolds stresses in the near wake have been measured when the wind turbine is operated at tip speed ratios (TSRs) in the range of 3–5. It was found that wind turbine near the wake flow field can be divided into a velocity increased region, a velocity unchanged region, and a velocity deficit region in the radial direction, and the axial average velocities at different TSRs in the wake reach inflow velocity almost at the same radial location. The rotor wake turbulent kinetic energy appears in two peaks at approximately 0.3R and 0.9R regions in the radial direction. The Reynolds shear stress is less than the Reynolds normal stresses, the axial Reynolds normal stress is larger than the Reynolds shear stress and radial Reynolds normal stress in the blade root region, while the radial Reynolds normal stress is larger than the Reynolds shear stress and axial Reynolds normal stress in the blade tip region. The experimental data may also serve as a benchmark for validation of relevant computational fluid dynamics (CFD) models.
- 8 July 2015
- Published by Zhejiang University Press in Journal of Zhejiang University-SCIENCE A
- Vol. 16 (7) , 586-595
Open AccessTime resolved particle image velocimetry experimental study of the near wake characteristics of a horizontal axis wind turbine
Wind tunnel experiments at a model scale have been carried out to investigate the flow characteristics in the near wake of a wind turbine. Time resolved particle image velocimetry (TRPIV) measurements are applied to visualize the wind turbine wake flow. The instantaneous vorticity, average velocities, turbulence kinetic energy, and Reynolds stresses in the near wake have been measured when the wind turbine is operated at tip speed ratios (TSRs) in the range of 3–5. It was found that wind turbine near the wake flow field can be divided into a velocity increased region, a velocity unchanged region, and a velocity deficit region in the radial direction, and the axial average velocities at different TSRs in the wake reach inflow velocity almost at the same radial location. The rotor wake turbulent kinetic energy appears in two peaks at approximately 0.3R and 0.9R regions in the radial direction. The Reynolds shear stress is less than the Reynolds normal stresses, the axial Reynolds normal stress is larger than the Reynolds shear stress and radial Reynolds normal stress in the blade root region, while the radial Reynolds normal stress is larger than the Reynolds shear stress and axial Reynolds normal stress in the blade tip region. The experimental data may also serve as a benchmark for validation of relevant computational fluid dynamics (CFD) models.