Chester Rous
Research Subjects
Research Interests
Chester Rous has a total of 1 co-authors. Here are the top co-authors by number of shared publications:
- Max van Beek
Resource & Recycling, Department of Engineering Structures, Faculty of Civil Engineering and Geosciences, Delft University of Technology, 2628 CN Delft, The Netherlands
1 shared publication
Latest Publications
- 17 December 2025
- Published by Multidiszciplinaris tudomanyok in Multidiszciplináris tudományok
- Vol. 15 (4) , 19-31
PCBA to PCBA, a depopulation comparison
In order to increase metal recovery from discarded printed circuit board assemblies, an additional preprocessing step where its electronic components are presorted before comminution and metallurgy is suggested. The first step in this process is depopulation where the electronic components are removed from the board. However, currently no practical apples to apples comparison has been performed. Therefore, six depopulation methods (both mechanical and thermal) were directly compared on both qualitative and quantitative indicators and evaluated using a multi-criteria analysis. The mechanical methods were faster less energy intensive than the thermal methods but produced lower quality products and had issues with scaling. Overall the best found method was using a pneumatic hammer due to its simplicity and effectiveness.
- 17 December 2025
- Published by Multidiszciplinaris tudomanyok in Multidiszciplináris tudományok
- Vol. 15 (4) , 19-31
PCBA to PCBA, a depopulation comparison
In order to increase metal recovery from discarded printed circuit board assemblies, an additional preprocessing step where its electronic components are presorted before comminution and metallurgy is suggested. The first step in this process is depopulation where the electronic components are removed from the board. However, currently no practical apples to apples comparison has been performed. Therefore, six depopulation methods (both mechanical and thermal) were directly compared on both qualitative and quantitative indicators and evaluated using a multi-criteria analysis. The mechanical methods were faster less energy intensive than the thermal methods but produced lower quality products and had issues with scaling. Overall the best found method was using a pneumatic hammer due to its simplicity and effectiveness.