Pavol Butvin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Pavol Butvin has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Beata Butvinova
Institute of Physics, Slovak Academy of Sciences, Dúbravská cesta 9, 845 11 Bratislava, Slovakia
5 shared publications - Peter Svec
Institute of Physics, Slovak Academy of Sciences, 845 11 Bratislava, Slovakia
4 shared publications - Marek Kuzminski
Institute of Physics, Polish Academy of Sciences, Aleja Lotnikow 32/46, PL-02668 Warsaw, Poland
3 shared publications - Anna Slawska-Waniewska
Institute of Physics, Polish Academy of Sciences, al. Lotnikow 32/46, PL-02668 Warsaw, Poland
2 shared publications Gabriel Vlasák
2 shared publicationsJozef Sitek
2 shared publications
Latest Publications
- 1 August 2018
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1996 (1) , 020004
Magnetic properties of multi-layered metallic ribbons
The method of planar flow casting has been used for preparation of single-, bi- and tri-layered ribbons of the two different or the same composition to attain multi-layered ribbons suitable for an application. Prepared bilayer was composed of positively and negatively magnetostrictive layers Fe77.5Si7.5B15/Co72.5Si12.5B15. Other aim was to suppress potentially undesired surface effects of differences between ribbon surfaces and volume. We prepared the ribbons with composition Co47Fe21Mo6.5B21Si4.5 as single layer and trilayer with the thickness ratio more than 3:1. Structural, chemical and magnetic properties in amorphous (as-cast) and crystalline state were investigated. The composition was chosen to obtain low saturation magnetostriction. Nanocrystallization improved soft magnetic properties namely for trilayer. Work proved that reduction of large surface/volume ratio enables to reduce undesired effects of shrinking surfaces that squeeze the small volume of a single ribbon more efficiently.
- 1 August 2018
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1996 (1) , 020004
Magnetic properties of multi-layered metallic ribbons
The method of planar flow casting has been used for preparation of single-, bi- and tri-layered ribbons of the two different or the same composition to attain multi-layered ribbons suitable for an application. Prepared bilayer was composed of positively and negatively magnetostrictive layers Fe77.5Si7.5B15/Co72.5Si12.5B15. Other aim was to suppress potentially undesired surface effects of differences between ribbon surfaces and volume. We prepared the ribbons with composition Co47Fe21Mo6.5B21Si4.5 as single layer and trilayer with the thickness ratio more than 3:1. Structural, chemical and magnetic properties in amorphous (as-cast) and crystalline state were investigated. The composition was chosen to obtain low saturation magnetostriction. Nanocrystallization improved soft magnetic properties namely for trilayer. Work proved that reduction of large surface/volume ratio enables to reduce undesired effects of shrinking surfaces that squeeze the small volume of a single ribbon more efficiently.
- 22 March 2012
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 48 (4) , 1340-1343
Indication of Intrinsic Macroscopic Forces Affecting Magnetic Properties of Fe-Nb/Mo-Cu-B-Si Ribbons
Si-rich (at.% Si >; 12) Fe-Nb/Mo-Cu-B-Si nanocrystalline ribbons are already successfully used in industry. Still the impact of intrinsic macroscopic stresses on magnetic anisotropy is not known in enough detail. Domain structure, hysteresis loops and surface chemistry have been studied in the as-annealed (nanocrystalline) state as well as the response to surface removal by etching. Creep-induced anisotropy established during annealing was found to be the essential source of the observed anisotropy. Apparently smooth gradient of transversal to longitudinal creep-induced anisotropy was identified from air-side center across the ribbon width as well as across the ribbon thickness. The relative rise of transversal anisotropy due to surface removal points to different surface etching efficiency. Raman spectroscopy confirmed the presence of ferrous oxides on both the ribbon surfaces. The existence of a defined oxide layer generating the macroscopic stress was not indicated.
- 22 March 2012
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 48 (4) , 1340-1343
Indication of Intrinsic Macroscopic Forces Affecting Magnetic Properties of Fe-Nb/Mo-Cu-B-Si Ribbons
Si-rich (at.% Si >; 12) Fe-Nb/Mo-Cu-B-Si nanocrystalline ribbons are already successfully used in industry. Still the impact of intrinsic macroscopic stresses on magnetic anisotropy is not known in enough detail. Domain structure, hysteresis loops and surface chemistry have been studied in the as-annealed (nanocrystalline) state as well as the response to surface removal by etching. Creep-induced anisotropy established during annealing was found to be the essential source of the observed anisotropy. Apparently smooth gradient of transversal to longitudinal creep-induced anisotropy was identified from air-side center across the ribbon width as well as across the ribbon thickness. The relative rise of transversal anisotropy due to surface removal points to different surface etching efficiency. Raman spectroscopy confirmed the presence of ferrous oxides on both the ribbon surfaces. The existence of a defined oxide layer generating the macroscopic stress was not indicated.
- 1 September 2010
- Published by Walter de Gruyter GmbH in Journal of Electrical Engineering
- Vol. 61 (5) , 264-270
Application Potential of Nanocrystalline Ribbons Still Pending
Application Potential of Nanocrystalline Ribbons Still Pending Nanocrystalline soft-magnetic ribbons promised a wide-spread practical use when introduced at the beginning of nineties. After 20 years of extensive research there are still unclear material problems which are thought to be the principal reason why these materials show but marginal use. Poorly controllable magnetic anisotropy due to spontaneous intrinsic macroscopic stress that comes from an inevitable heterogeneity of the ribbon materials is pointed to in this work. Certain stress-based mechanisms are shown to induce the unintended anisotropy in the already familiar Finemets as well as in the newer Hitperms. Hysteresis loops, domain structure and power loss is used to reveal the anisotropy consequences and particular connected but still unanswered questions are pinpointed.
- 1 September 2010
- Published by Walter de Gruyter GmbH in Journal of Electrical Engineering
- Vol. 61 (5) , 264-270
Application Potential of Nanocrystalline Ribbons Still Pending
Application Potential of Nanocrystalline Ribbons Still Pending Nanocrystalline soft-magnetic ribbons promised a wide-spread practical use when introduced at the beginning of nineties. After 20 years of extensive research there are still unclear material problems which are thought to be the principal reason why these materials show but marginal use. Poorly controllable magnetic anisotropy due to spontaneous intrinsic macroscopic stress that comes from an inevitable heterogeneity of the ribbon materials is pointed to in this work. Certain stress-based mechanisms are shown to induce the unintended anisotropy in the already familiar Finemets as well as in the newer Hitperms. Hysteresis loops, domain structure and power loss is used to reveal the anisotropy consequences and particular connected but still unanswered questions are pinpointed.
- 1 July 2010
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 322 (14) , 2047-2050
Magnetic measurements of Fe–Ni–Nb–B and Fe–Co–Mo–Cu–B in the vicinity of the Curie temperature
- 1 July 2010
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 322 (14) , 2047-2050
Magnetic measurements of Fe–Ni–Nb–B and Fe–Co–Mo–Cu–B in the vicinity of the Curie temperature
- 1 March 2008
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 320 (6) , 1133-1140
Magnetic properties and macroscopic heterogeneity of FeCoNbB Hitperms
- 1 March 2008
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 320 (6) , 1133-1140
Magnetic properties and macroscopic heterogeneity of FeCoNbB Hitperms
- 1 September 2006
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 304 (2) , e697-e699
External influence on magnetic properties of Fe-based nanocrystalline alloys
- 1 September 2006
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 304 (2) , e697-e699
External influence on magnetic properties of Fe-based nanocrystalline alloys