Isabella De Bari
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Isabella De Bari has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
Anna Ciancolini
Consiglio per la Ricerca in Agricoltura e l’analisi dell’Economia Agraria (CREA)-Centro di Ricerca Ingegneria e Trasformazioni Agroalimentari, Monterotondo, Italy
1 shared publication- Antonio Villone1 shared publication
- Donatella Barisano
Italian National Agency for New Technologies, Energy and Sustainable Economic Development, Lungotevere Thaon di Revel, 76, 00196 Rome, Italy
1 shared publication - Egidio Viola
ENEA, Italian National Agency for New Technologies, Energy and Sustainable Economic Development, Trisaia Research Centre, S.S. 106 Jonica, 75026 Rotondella, Italy
1 shared publication Enrico Catizzone
1 shared publication- Federico Liuzzi
Laboratory for Techniques and Processes in Biorefineries, ENEA—Trisaia Research Centre, S.S. Jonica 106, Km 419+500, 75026 Rotondella, Italy
1 shared publication
Latest Publications
- Open Access
- 25 October 2026
- Published by Elsevier in SSRN Electronic Journal
Optimizing iron-doped dolomite catalyst for high-temperature water-gas shift
Iron-doped dolomite catalysts were investigated for high-temperature water–gas shift under biomass-derived syngas upgrading conditions. Natural dolomite was impregnated with 1–10 wt.% Fe, calcined at 950 °C, and characterized by XRD, SEM-EDX, ICP-OES, and H2-TPR. At 650 °C and CO/H2O = 1:3, calcined dolomite showed about 12% CO conversion, confirming the intrinsic activity of the CaO–MgO matrix. Fe addition generated a clear volcano-shaped activity trend, with a maximum CO conversion of 27–28% at 5 wt.% Fe, corresponding to an optimal Fe/(Ca+Mg) molar ratio of ≈0.07. The optimum composition exhibited homogeneous Fe distribution and distinctive Ca–Fe oxide environments, with XRD features compatible with the formation of a Ca2Fe2O5-like phase. Higher Fe contents promoted Fe-rich segregation and lower activity. Stable conversion during 180 min time-on-stream tests indicates satisfactory short-term stability under the investigated conditions. Furthermore, the optimal catalyst showed an apparent activation energy of 47.6 kJ/mol, lower than the value obtained for undoped dolomite, i.e. 54.9 kJ/mol. Product distribution profiles evidenced that during the initial reaction transient, the maximum H2 concentration coincided with the minimum CO2 concentration, consistent with temporary CO2 retention by the CaO-containing matrix. Post-reaction XRD and thermogravimetric analysis support substantial recarbonation of the spent materials, while TGA analyses indicate no significant coke accumulation. Overall, the results demonstrate that WGS activity is governed by an optimum balance between surface Fe concentration, Fe–support interaction and redox behaviour rather than by the total Fe loading, identifying Fe-modified dolomite as a promising multifunctional material for biomass-derived syngas upgrading.
- 25 October 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessOptimizing iron-doped dolomite catalyst for high-temperature water-gas shift
Iron-doped dolomite catalysts were investigated for high-temperature water–gas shift under biomass-derived syngas upgrading conditions. Natural dolomite was impregnated with 1–10 wt.% Fe, calcined at 950 °C, and characterized by XRD, SEM-EDX, ICP-OES, and H2-TPR. At 650 °C and CO/H2O = 1:3, calcined dolomite showed about 12% CO conversion, confirming the intrinsic activity of the CaO–MgO matrix. Fe addition generated a clear volcano-shaped activity trend, with a maximum CO conversion of 27–28% at 5 wt.% Fe, corresponding to an optimal Fe/(Ca+Mg) molar ratio of ≈0.07. The optimum composition exhibited homogeneous Fe distribution and distinctive Ca–Fe oxide environments, with XRD features compatible with the formation of a Ca2Fe2O5-like phase. Higher Fe contents promoted Fe-rich segregation and lower activity. Stable conversion during 180 min time-on-stream tests indicates satisfactory short-term stability under the investigated conditions. Furthermore, the optimal catalyst showed an apparent activation energy of 47.6 kJ/mol, lower than the value obtained for undoped dolomite, i.e. 54.9 kJ/mol. Product distribution profiles evidenced that during the initial reaction transient, the maximum H2 concentration coincided with the minimum CO2 concentration, consistent with temporary CO2 retention by the CaO-containing matrix. Post-reaction XRD and thermogravimetric analysis support substantial recarbonation of the spent materials, while TGA analyses indicate no significant coke accumulation. Overall, the results demonstrate that WGS activity is governed by an optimum balance between surface Fe concentration, Fe–support interaction and redox behaviour rather than by the total Fe loading, identifying Fe-modified dolomite as a promising multifunctional material for biomass-derived syngas upgrading.
- Open Access
- 25 April 2022
- Published by Frontiers Media SA in Frontiers in Energy Research
- Vol. 10
Inulin Content in Chipped Roots of Cardoon Stored at Different Initial Moisture Contents After Six-Month Storage
Inulin is accumulated as a reserve carbohydrate in the roots and tubers of many plants belonging to the Asteraceae family. At present, most of the inulin for nutraceutical purposes is produced from Jerusalem artichoke (Helianthus tuberosus L.) and Chicory (Cichorium intybus L.), and cardoon is proved to synthetize and store a high quantity of inulin in roots. Inulin in the roots of cardoon reaches the maximum content before the beginning of flowers formation in May. Due to the limited favorable period for harvesting the roots, storage plays a key role in the supply chain. The complete drying of cardoon roots before the storage has been proved to prevent the degradation of inulin up to 6 months of storage. Because drying is a costly operation, in the present study, energy-saving and the effect on percentage inulin content in cardoon roots dried at different moisture contents before storage were assessed. From 48.2% inulin retrievable at the beginning of the investigated period (100% dry matter), after 1 month of storage, about 2% reduction was recorded on average in H0 and H12.5 treatments, while about 10% reduction was shown (with no statistical differences) in treatments at higher moisture contents (TQ, H50, and H25). These values remained constant until the end of storage, except for TQ treatment, where inulin content decreased progressively up to 38.7% w/w. From an economic point of view, limiting the drying time and storing roots at a moisture content higher than 0% leads to an income loss of 2,000–3,000 €/t of roots. Therefore, full drying is the most cost-effective solution in the optic of producing the highest possible amount of inulin and could be avoided just in the case of immediate roots extraction and processing in a few days.
- 25 April 2022
- Published by Frontiers Media SA in Frontiers in Energy Research
- Vol. 10
Open AccessInulin Content in Chipped Roots of Cardoon Stored at Different Initial Moisture Contents After Six-Month Storage
Inulin is accumulated as a reserve carbohydrate in the roots and tubers of many plants belonging to the Asteraceae family. At present, most of the inulin for nutraceutical purposes is produced from Jerusalem artichoke (Helianthus tuberosus L.) and Chicory (Cichorium intybus L.), and cardoon is proved to synthetize and store a high quantity of inulin in roots. Inulin in the roots of cardoon reaches the maximum content before the beginning of flowers formation in May. Due to the limited favorable period for harvesting the roots, storage plays a key role in the supply chain. The complete drying of cardoon roots before the storage has been proved to prevent the degradation of inulin up to 6 months of storage. Because drying is a costly operation, in the present study, energy-saving and the effect on percentage inulin content in cardoon roots dried at different moisture contents before storage were assessed. From 48.2% inulin retrievable at the beginning of the investigated period (100% dry matter), after 1 month of storage, about 2% reduction was recorded on average in H0 and H12.5 treatments, while about 10% reduction was shown (with no statistical differences) in treatments at higher moisture contents (TQ, H50, and H25). These values remained constant until the end of storage, except for TQ treatment, where inulin content decreased progressively up to 38.7% w/w. From an economic point of view, limiting the drying time and storing roots at a moisture content higher than 0% leads to an income loss of 2,000–3,000 €/t of roots. Therefore, full drying is the most cost-effective solution in the optic of producing the highest possible amount of inulin and could be avoided just in the case of immediate roots extraction and processing in a few days.