S. D. Korovin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
S. D. Korovin has a total of 40 co-authors. Here are the top co-authors by number of shared publications:
- Vladislav V. Rostov
SB RAS
5 shared publications - Michael I. Yalandin
IEP UB RAS, Russia
4 shared publications - Gennadii Andreevich Mesyats
P. N. Lebedev Physical Institute of the Russian Academy of Sciences
3 shared publications E. Schamiloglu
2 shared publicationsK. A. Sharypov
Russian Academy of Sciences
2 shared publicationsS. A. Shunailov
Russian Academy of Sciences
2 shared publications
Latest Publications
- 16 October 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 34 (5) , 1771-1776
Degradation and Recovery of the Emission From a Graphite Cathode in Relation to the Repetition Frequency of Nanosecond Accelerating Pulses
A study has been performed on the emissive characteristics of a cold graphite cathode in a magnetically insulated coaxial diode under the action of nanosecond accelerating pulses at a pulse repetition frequency (PRF) of up to 3.5 kHz. Emission was observed to degrade at PRF < 1 kHz and recover at PRF ~3.5 kHz. Estimates of the temperature conditions in the region of an explosive electron emission (EEE) center have shown that the pulse interval t~1 ms suffices for this region to cool down to 300 K. The cooling occurs predominantly by heat conduction. For t~0.3 ms, the residual heat is substantial. It has been proposed that there exists a frequency limit for the cathode microrelief polishing effect. The results of an experiment on the study of the mechanism of cathode emission recovery with increasing PRF are presented. Micrographs of the cathode taken after aging, photographs of the cathode in operation, and analyses of the fractional composition of the material removed from the cathode suggest that heating of some regions of the cathode emitting edge to the melting point of graphite plays an important role in the recovery of emission. This counts in favor of the hypothesized dominant contribution of thermoelectronic emission to the initiation of EEE due to the residual heat remaining in regions that have not cooled off during the pulse interval
- 16 October 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 34 (5) , 1771-1776
Degradation and Recovery of the Emission From a Graphite Cathode in Relation to the Repetition Frequency of Nanosecond Accelerating Pulses
A study has been performed on the emissive characteristics of a cold graphite cathode in a magnetically insulated coaxial diode under the action of nanosecond accelerating pulses at a pulse repetition frequency (PRF) of up to 3.5 kHz. Emission was observed to degrade at PRF < 1 kHz and recover at PRF ~3.5 kHz. Estimates of the temperature conditions in the region of an explosive electron emission (EEE) center have shown that the pulse interval t~1 ms suffices for this region to cool down to 300 K. The cooling occurs predominantly by heat conduction. For t~0.3 ms, the residual heat is substantial. It has been proposed that there exists a frequency limit for the cathode microrelief polishing effect. The results of an experiment on the study of the mechanism of cathode emission recovery with increasing PRF are presented. Micrographs of the cathode taken after aging, photographs of the cathode in operation, and analyses of the fractional composition of the material removed from the cathode suggest that heating of some regions of the cathode emitting edge to the melting point of graphite plays an important role in the recovery of emission. This counts in favor of the hypothesized dominant contribution of thermoelectronic emission to the initiation of EEE due to the residual heat remaining in regions that have not cooled off during the pulse interval
- 1 January 2006
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 32 (1) , 18-22
Dynamics of subnanosecond electron beam formation in gas-filled and vacuum diodes
The dynamic characteristics of a subnanosecond pulsed electron beam formation in the accelerating gap of a gas-filled or evacuated diode have been studied at a time resolution ∼10−11 s. In the air-filled gap, the electron beam pulse with a current amplitude of several amperes is formed up to about one hundred picoseconds earlier than the analogous pulse under vacuum conditions, and the measured pulse duration (∼10−10 s) is close to the electron flight time across a diode gap in the continuous acceleration regime. It is shown that a nanosecond prepulse plays an important role by initiating the emission of electrons that are subsequently accelerated by the high-voltage pulse with a subnanosecond front.
- 1 January 2006
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 32 (1) , 18-22
Dynamics of subnanosecond electron beam formation in gas-filled and vacuum diodes
The dynamic characteristics of a subnanosecond pulsed electron beam formation in the accelerating gap of a gas-filled or evacuated diode have been studied at a time resolution ∼10−11 s. In the air-filled gap, the electron beam pulse with a current amplitude of several amperes is formed up to about one hundred picoseconds earlier than the analogous pulse under vacuum conditions, and the measured pulse duration (∼10−10 s) is close to the electron flight time across a diode gap in the continuous acceleration regime. It is shown that a nanosecond prepulse plays an important role by initiating the emission of electrons that are subsequently accelerated by the high-voltage pulse with a subnanosecond front.
- 1 November 2005
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 31 (11) , 982-985
Experimental investigation of electron beam in the squeezed state
The electron beam transported in a two-section drift tube of a SINUS-7 setup has been studied. A high-density electron beam in the “squeezed” state has been obtained with a relativistic factor γb below that corresponding to the limiting current (γ > Γ1/3).
- 1 November 2005
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 31 (11) , 982-985
Experimental investigation of electron beam in the squeezed state
The electron beam transported in a two-section drift tube of a SINUS-7 setup has been studied. A high-density electron beam in the “squeezed” state has been obtained with a relativistic factor γb below that corresponding to the limiting current (γ > Γ1/3).
- 15 August 2005
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 33 (4) , 1220-1225
Nanosecond hybrid Modulator for the fast-repetitive driving of X-band, gigawatt-power microwave source
Results of tests of a fast-repetitive nanosecond modulator with a peak output power of 3 GW are presented. It comprises of a type S-5N charging driver, a power compressor based on a pulsed forming line, and a gas spark gap. The modulator has been designed for the formation of high-current electron beams and high-power microwave generation in a pulsed-repetitive regime. Excitation of 10-GHz microwave pulses /spl sim/1 ns long in a relativistic backward-wave oscillator with an elongated periodic slow-wave system has been studied. Optimization of the regime of interaction between electromagnetic fields and particles provided an average power of microwave radiation in the burst-repetitive mode (1 s; /spl sim/700 Hz) of up to 2.5 kW at a focusing magnetic field (/spl sim/0.6 T) below the cyclotron resonance region. The peak output power of the oscillator exceeded 2 GW.
- 15 August 2005
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 33 (4) , 1220-1225
Nanosecond hybrid Modulator for the fast-repetitive driving of X-band, gigawatt-power microwave source
Results of tests of a fast-repetitive nanosecond modulator with a peak output power of 3 GW are presented. It comprises of a type S-5N charging driver, a power compressor based on a pulsed forming line, and a gas spark gap. The modulator has been designed for the formation of high-current electron beams and high-power microwave generation in a pulsed-repetitive regime. Excitation of 10-GHz microwave pulses /spl sim/1 ns long in a relativistic backward-wave oscillator with an elongated periodic slow-wave system has been studied. Optimization of the regime of interaction between electromagnetic fields and particles provided an average power of microwave radiation in the burst-repetitive mode (1 s; /spl sim/700 Hz) of up to 2.5 kW at a focusing magnetic field (/spl sim/0.6 T) below the cyclotron resonance region. The peak output power of the oscillator exceeded 2 GW.
- 1 June 2005
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 31 (6) , 488-490
Regeneration of graphite explosive-emission cathodes operating at high repetition rates of nanosecond accelerating pulses
We have experimentally studied the possibility of increasing the working life of explosive-emission cathodes operating at high repetition frequencies (several kilohertz) of nanosecond accelerating voltage pulses. Micrographs of the cathode surface upon training, photographs of the operating cathode, and analyses of the material carried away from the cathode showed that a substantial role in the cathode degradation is played by heating of some regions of the emissive edge up to a temperature of graphite melting.
- 1 June 2005
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 31 (6) , 488-490
Regeneration of graphite explosive-emission cathodes operating at high repetition rates of nanosecond accelerating pulses
We have experimentally studied the possibility of increasing the working life of explosive-emission cathodes operating at high repetition frequencies (several kilohertz) of nanosecond accelerating voltage pulses. Micrographs of the cathode surface upon training, photographs of the operating cathode, and analyses of the material carried away from the cathode showed that a substantial role in the cathode degradation is played by heating of some regions of the emissive edge up to a temperature of graphite melting.
- 22 January 2003
- Published by Institute of Electrical and Electronics Engineers (IEEE)
Progress on pulse lengthening of a relativistic backward wave oscillator
Summary form only given, as follows. Laser interferometry has been used to diagnose plasma formation and evolution in the slow wave structure (SWS) of a relativistic backward wave oscillator (BWO) during the course of microwave generation. The results indicated that plasma from the cutoff neck inlet contributed to the termination of the high power microwave pulse. In an effort to mitigate this pulse shortening effect we have replaced the cutoff neck with a Bragg reflector. As part of these studies we have observed the cross-excitation instability because of the particularly shallow-ripple SWS used. We will present results from recent experiments performed with the long pulse relativistic BWO, including the implementation of a hybrid-hard tube BWO.
- 22 January 2003
- Published by Institute of Electrical and Electronics Engineers (IEEE)
Progress on pulse lengthening of a relativistic backward wave oscillator
Summary form only given, as follows. Laser interferometry has been used to diagnose plasma formation and evolution in the slow wave structure (SWS) of a relativistic backward wave oscillator (BWO) during the course of microwave generation. The results indicated that plasma from the cutoff neck inlet contributed to the termination of the high power microwave pulse. In an effort to mitigate this pulse shortening effect we have replaced the cutoff neck with a Bragg reflector. As part of these studies we have observed the cross-excitation instability because of the particularly shallow-ripple SWS used. We will present results from recent experiments performed with the long pulse relativistic BWO, including the implementation of a hybrid-hard tube BWO.
- 1 June 1996
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 24 (3) , 852-858
Enhanced frequency agility of high-power relativistic backward wave oscillators
- 1 June 1996
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 24 (3) , 852-858
Enhanced frequency agility of high-power relativistic backward wave oscillators