Saleh Khorasani
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Saleh Khorasani has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
Samad Jafarmadar
Mechanical Engineering Department, Faculty of Engineering Urmia University Urmia Iran
3 shared publications- Samad Jafarmadar
Department of Mechanical Engineering, Urmia University, Urmia, Iran
2 shared publications - Abdolrahman Dadvand
Faculty of Mechanical Engineering, Urmia University of Technology, Urmia, Iran
1 shared publication Aghel Heydarpour
1 shared publication- Akbar Arsalanloo
Sustainable Management of Natural Resources and Environment Research Group, Faculty of Environment and Labor Safety Ton Duc Thang University Ho Chi Minh City Vietnam
1 shared publication Amin Moosavi
1 shared publication
Latest Publications
- 1 October 2026
- Published by Wiley in Heat Transfer
Heat Transfer, Pressure Drop, Flow Structure, and Exergy Destruction Through Inclined Corrugated Tube With Air Injection
Gas–liquid two‐phase flow is one of the most complex types of flow in fluid dynamics. This kind of flow is highly sensitive, and changes in the flow pattern can result even from minor geometrical variations, making it important to conduct experimental investigations in which the effects of geometric changes are studied. Circumferentially corrugated tubes are of widespread interest in the thermal industry, where the occurrence of gas/liquid two‐phase flow is inevitable. This research presents experimental results on how air injection affects an enhanced tube installed at an incline. The tube had uniform circumferential corrugations. Three inclination angles were studied: 15°, 30°, and 45°. A constant heat flux was applied to the tube, and the flow direction was upward. Four different water superficial Re numbers (5580, 11160, 16740, and 22320) were tested for each inclination angle. In addition, four air superficial Re numbers of (138, 420, 690, and 975) were examined for each water flow rate. The results showed that, within the scope of the study, the flow regime in the corrugated tube was predominantly wavy‐slug flow. Increasing the tube inclination from 15° to 45° led to approximately a 32% rise in the Nusselt number and a 62% rise in pressure drop. These increases were observed at a 45° inclination with air and water superficial Re of 975 and 22320, respectively. Also, the maximum Nu number ratio (Nu tp /Nu sp ) was found to be 26% (heat transfer augmentation) and was seen at the tube with 45° and at the Re sg of 975 Re sl 22320. The maximum dimensionless exergy destruction value occurred at the 45° inclination, specifically at a water Re sl of 55820 and an air Re sg of 975, where it reached 0.00063.
- 1 October 2026
- Published by Wiley in Heat Transfer
Heat Transfer, Pressure Drop, Flow Structure, and Exergy Destruction Through Inclined Corrugated Tube With Air Injection
Gas–liquid two‐phase flow is one of the most complex types of flow in fluid dynamics. This kind of flow is highly sensitive, and changes in the flow pattern can result even from minor geometrical variations, making it important to conduct experimental investigations in which the effects of geometric changes are studied. Circumferentially corrugated tubes are of widespread interest in the thermal industry, where the occurrence of gas/liquid two‐phase flow is inevitable. This research presents experimental results on how air injection affects an enhanced tube installed at an incline. The tube had uniform circumferential corrugations. Three inclination angles were studied: 15°, 30°, and 45°. A constant heat flux was applied to the tube, and the flow direction was upward. Four different water superficial Re numbers (5580, 11160, 16740, and 22320) were tested for each inclination angle. In addition, four air superficial Re numbers of (138, 420, 690, and 975) were examined for each water flow rate. The results showed that, within the scope of the study, the flow regime in the corrugated tube was predominantly wavy‐slug flow. Increasing the tube inclination from 15° to 45° led to approximately a 32% rise in the Nusselt number and a 62% rise in pressure drop. These increases were observed at a 45° inclination with air and water superficial Re of 975 and 22320, respectively. Also, the maximum Nu number ratio (Nu tp /Nu sp ) was found to be 26% (heat transfer augmentation) and was seen at the tube with 45° and at the Re sg of 975 Re sl 22320. The maximum dimensionless exergy destruction value occurred at the 45° inclination, specifically at a water Re sl of 55820 and an air Re sg of 975, where it reached 0.00063.
- Open Access
- 1 September 2022
- Published by Elsevier in Alexandria Engineering Journal
- Vol. 61 (9) , 6769-6783
Experimental investigation on the thermo-hydraulic performance of air–water two-phase flow inside a horizontal circumferentially corrugated tube
- 1 September 2022
- Published by Elsevier in Alexandria Engineering Journal
- Vol. 61 (9) , 6769-6783
Open AccessExperimental investigation on the thermo-hydraulic performance of air–water two-phase flow inside a horizontal circumferentially corrugated tube
- 26 April 2021
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 147 (6) , 4339-4353
Performance evaluation of horizontal straight tube equipped with twisted tape turbulator, with air–water two-phase flow as working fluid
- 26 April 2021
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 147 (6) , 4339-4353
Performance evaluation of horizontal straight tube equipped with twisted tape turbulator, with air–water two-phase flow as working fluid
- 5 February 2021
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 147 (2) , 1727-1738
Numerical analysis on heat transfer of a pyramid-shaped photovoltaic panel
- 5 February 2021
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 147 (2) , 1727-1738
Numerical analysis on heat transfer of a pyramid-shaped photovoltaic panel
- 1 July 2019
- Published by Elsevier in Applied Thermal Engineering
- Vol. 157, 113621
Experimental investigation on the thermal and entropic behavior of a vertical helical tube with none-boiling upward air-water two-phase flow
- 1 July 2019
- Published by Elsevier in Applied Thermal Engineering
- Vol. 157, 113621
Experimental investigation on the thermal and entropic behavior of a vertical helical tube with none-boiling upward air-water two-phase flow
- 1 March 2019
- Published by Elsevier in Applied Thermal Engineering
- Vol. 150, 80-87
A comprehensive second law analysis of coil side air injection in the shell and coiled tube heat exchanger: An experimental study
- 1 March 2019
- Published by Elsevier in Applied Thermal Engineering
- Vol. 150, 80-87
A comprehensive second law analysis of coil side air injection in the shell and coiled tube heat exchanger: An experimental study
- 1 January 2019
- Published by Elsevier in Applied Thermal Engineering
- Vol. 147, 983-990
Experimental investigations on the effect of geometrical properties of helical wire turbulators on thermal performance of a helically coiled tube
- 1 January 2019
- Published by Elsevier in Applied Thermal Engineering
- Vol. 147, 983-990
Experimental investigations on the effect of geometrical properties of helical wire turbulators on thermal performance of a helically coiled tube