Monica Luisa Chaves de Andrade Afonso
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Monica Luisa Chaves de Andrade Afonso has a total of 54 co-authors. Here are the top co-authors by number of shared publications:
- Manuel Almeida
LEPABE, Department of Mechanical Engineering, Faculty of Engineering, University of Porto, R. Dr. Roberto Frias, s/n, 4200-465 Porto, Portugal
10 shared publications - Rafaela. A. L. Silva
Centro de Ciências e Tecnologias Nucleares, Instituto Superior Técnico, Universidade de Lisboa, E.N. 10, P-2695-066 Bobadela LRS, Portugal
6 shared publications - Rui Teives Henriques
Instituto de Telecomunicações, Polo de Lisboa, Campus IST, Av. Rovisco Pais, 1049‐001 Lisbon, Portugal
6 shared publications - Isabel Cordeiro Santos
Centro de Ciências e Tecnologias Nucleares (C2TN), Instituto Superior Técnico, Universidade de Lisboa, 2695-066 Bobadela, Portugal
5 shared publications - Manuel Matos
Instituto de Telecomunicações, Polo de Lisboa, P1049-001 Lisboa, Portugal
5 shared publications - Elsa Branco Lopes
C2TN—Center for Nuclear Sciences and Technologies, Department of Nuclear Sciences and Engineering, Instituto Superior Técnico, University of Lisbon, 2695-066 Bobadela-LRS, Portugal
4 shared publications
Latest Publications
- Open Access
- 13 June 2017
- Published by MDPI AG in Magnetochemistry
- Vol. 3 (2) , 22
The Solid Solutions (Per)2[PtxAu(1−x)(mnt)2]; Alloying Para- and Diamagnetic Anions in Two-Chain Compounds
The α-(Per)2[M(mnt)2] compounds with M = Pt and Au are isostructural two-chain solids that in addition to partially oxidized conducting perylene chains also contain anionic chains that can be either paramagnetic in the case of M = Pt or diamagnetic for M = Au. The electrical transport and magnetic properties of the solid solutions (Per)2[Ptx-Au(1−x)(mnt)2] were investigated. The incorporation of paramagnetic [Pt(mnt)2] impurities in the diamagnetic chains, and the effect of breaking the paramagnetic chains with diamagnetic centers for the low and high Pt range of concentrations were respectively probed. In the low Pt concentration range, there is a fast decrease of the metal-to-insulator transition from 12.4 K in the pure Au compound to 9.7 K for x = 0.1 comparable to the 8.1 K in the pure Pt compound. In the range x = 0.50−0.95, only β-phase crystals could be obtained. The spin-Peierls transition of the pure Pt compound, simultaneous with metal-to-insulator (Peierls) transition is still present for 2% of diamagnetic impurities (x = 0.98) with transition temperature barely affected. Single crystal X-ray diffraction data obtained a high-quality structural refinement of the α-phase of the Au and Pt compounds. The β-phase structure was found to be composed of ordered layers with segregated donors and anion stacks, which alternate with disordered layers. The semiconducting properties of the β-phase are due to the disorder localization effects.
- 13 June 2017
- Published by MDPI AG in Magnetochemistry
- Vol. 3 (2) , 22
Open AccessThe Solid Solutions (Per)2[PtxAu(1−x)(mnt)2]; Alloying Para- and Diamagnetic Anions in Two-Chain Compounds
The α-(Per)2[M(mnt)2] compounds with M = Pt and Au are isostructural two-chain solids that in addition to partially oxidized conducting perylene chains also contain anionic chains that can be either paramagnetic in the case of M = Pt or diamagnetic for M = Au. The electrical transport and magnetic properties of the solid solutions (Per)2[Ptx-Au(1−x)(mnt)2] were investigated. The incorporation of paramagnetic [Pt(mnt)2] impurities in the diamagnetic chains, and the effect of breaking the paramagnetic chains with diamagnetic centers for the low and high Pt range of concentrations were respectively probed. In the low Pt concentration range, there is a fast decrease of the metal-to-insulator transition from 12.4 K in the pure Au compound to 9.7 K for x = 0.1 comparable to the 8.1 K in the pure Pt compound. In the range x = 0.50−0.95, only β-phase crystals could be obtained. The spin-Peierls transition of the pure Pt compound, simultaneous with metal-to-insulator (Peierls) transition is still present for 2% of diamagnetic impurities (x = 0.98) with transition temperature barely affected. Single crystal X-ray diffraction data obtained a high-quality structural refinement of the α-phase of the Au and Pt compounds. The β-phase structure was found to be composed of ordered layers with segregated donors and anion stacks, which alternate with disordered layers. The semiconducting properties of the β-phase are due to the disorder localization effects.
- 28 October 2016
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 120 (16) , 165502
Inkjet printed organic electrochemical transistors with highly conducting polymer electrolytes
Organic Electrochemical Transistors (OECTs) were fabricated with two kinds of highly conducting polymer electrolytes, one with cations of small dimensions (Li+) and the other with cations of large dimensions (1-ethyl-3-methylimidazolium, EMI+). All OECTs exhibit transconductance values in the millisiemens range. Those with the larger EMI+ cations reach higher transconductance values and the saturated region of their I(V) characteristics extends to drain negative voltages of the order of −2 V without breakdown. These OECTs aim at potential applications for which it is relevant to use a solid polymer electrolyte instead of an aqueous electrolyte, namely, for integration in complex devices or in sensors and transducers where the electrolyte film may act as a membrane to prevent direct contact of the active material (PEDOT:PSS) with the biological media. The choice of electrolytes with cations of disparate sizes aims at assessing the nature (Faradaic or capacitive) of the processes occurring at the electrolyte/channel interface. The results obtained are consistent with a Faradaic-based operation mechanism.
- 28 October 2016
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 120 (16) , 165502
Inkjet printed organic electrochemical transistors with highly conducting polymer electrolytes
Organic Electrochemical Transistors (OECTs) were fabricated with two kinds of highly conducting polymer electrolytes, one with cations of small dimensions (Li+) and the other with cations of large dimensions (1-ethyl-3-methylimidazolium, EMI+). All OECTs exhibit transconductance values in the millisiemens range. Those with the larger EMI+ cations reach higher transconductance values and the saturated region of their I(V) characteristics extends to drain negative voltages of the order of −2 V without breakdown. These OECTs aim at potential applications for which it is relevant to use a solid polymer electrolyte instead of an aqueous electrolyte, namely, for integration in complex devices or in sensors and transducers where the electrolyte film may act as a membrane to prevent direct contact of the active material (PEDOT:PSS) with the biological media. The choice of electrolytes with cations of disparate sizes aims at assessing the nature (Faradaic or capacitive) of the processes occurring at the electrolyte/channel interface. The results obtained are consistent with a Faradaic-based operation mechanism.
- 20 October 2015
- Published by Universidade de São Paulo. Agência de Bibliotecas e Coleções Digitais
Caracterização do aço inoxidável austenítico UNS S31254 em meio de NaCI 0,11 mol L-1 visando seu emprego em implantes ortopédicos
Foi feita a caracterização eletroquímica do aço inoxidável austenítico UNS S31254 em meio de NaCl 0,11 mol L-1 na ausência e presença de soro albumina bovina (BSA) visando seu emprego em implantes ortopédicos....
- 20 October 2015
- Published by Universidade de São Paulo. Agência de Bibliotecas e Coleções Digitais
Caracterização do aço inoxidável austenítico UNS S31254 em meio de NaCI 0,11 mol L-1 visando seu emprego em implantes ortopédicos
Foi feita a caracterização eletroquímica do aço inoxidável austenítico UNS S31254 em meio de NaCl 0,11 mol L-1 na ausência e presença de soro albumina bovina (BSA) visando seu emprego em implantes ortopédicos....
- 1 June 2015
- Published by Elsevier in Materials Letters
- Vol. 148, 71-75
Surface characterization, electrochemical behaviour and cytotoxicity of UNS S31254 stainless steel for orthopaedic applications
- 1 June 2015
- Published by Elsevier in Materials Letters
- Vol. 148, 71-75
Surface characterization, electrochemical behaviour and cytotoxicity of UNS S31254 stainless steel for orthopaedic applications
- 1 February 2015
- Published by Elsevier in Inorganica Chimica Acta
- Vol. 426, 160-164
Dimerisation of Fe bisdithiolene complexes: An electrochemical study
- 1 February 2015
- Published by Elsevier in Inorganica Chimica Acta
- Vol. 426, 160-164
Dimerisation of Fe bisdithiolene complexes: An electrochemical study
- 10 May 2013
- Published by Wiley in European Journal of Inorganic Chemistry
- Vol. 2013 (18) , 3133-3136
An Electropolymerisable Pyridine‐Functionalised Gold Bis(dithiolene) Complex
A new pyridine‐substituted dithiolene complex, PPh4[Au(4‐pdddt)2] (3), was prepared and characterised. Cyclic voltammetry shows three redox processes corresponding to the interconversion between dianionic, monoanionic, neutral and cationic states, as often presented by this type of bis(dithiolene) complexes. However, the last oxidation process in this compound leads to a polymerised species obtained as an electrodeposited film. By potentiostatic electrodeposition, thin films of either the neutral gold complex, [Au(4‐pdddt)2] (4), or the polymerised cationic species can be obtained. Both films absorb strongly in the NIR region and have properties consistent with the incorporation of the intact metal bis(dithiolene) complex. A mechanism for polymerisation through formation of S–S interligand bonds is proposed.
- 10 May 2013
- Published by Wiley in European Journal of Inorganic Chemistry
- Vol. 2013 (18) , 3133-3136
An Electropolymerisable Pyridine‐Functionalised Gold Bis(dithiolene) Complex
A new pyridine‐substituted dithiolene complex, PPh4[Au(4‐pdddt)2] (3), was prepared and characterised. Cyclic voltammetry shows three redox processes corresponding to the interconversion between dianionic, monoanionic, neutral and cationic states, as often presented by this type of bis(dithiolene) complexes. However, the last oxidation process in this compound leads to a polymerised species obtained as an electrodeposited film. By potentiostatic electrodeposition, thin films of either the neutral gold complex, [Au(4‐pdddt)2] (4), or the polymerised cationic species can be obtained. Both films absorb strongly in the NIR region and have properties consistent with the incorporation of the intact metal bis(dithiolene) complex. A mechanism for polymerisation through formation of S–S interligand bonds is proposed.
- 1 March 2013
- Published by Wiley in European Journal of Inorganic Chemistry
- Vol. 2013 (13) , 2440-2446
α‐Dithiophene‐tetrathiafulvalene – a Detailed Study of an Electronic Donor and Its Derivatives
- 1 March 2013
- Published by Wiley in European Journal of Inorganic Chemistry
- Vol. 2013 (13) , 2440-2446
α‐Dithiophene‐tetrathiafulvalene – a Detailed Study of an Electronic Donor and Its Derivatives
- 1 August 2012
- Published by Elsevier in Polyhedron
- Vol. 44 (1) , 228-237
Synthesis, structure and physical properties of transition metal bis 4-cyanobenzene-1,2-dithiolate complexes [M(cbdt)2]z− (M=Zn, Co, Cu, Au, Ni, Pd, z=0, 1, 2)
- 1 August 2012
- Published by Elsevier in Polyhedron
- Vol. 44 (1) , 228-237
Synthesis, structure and physical properties of transition metal bis 4-cyanobenzene-1,2-dithiolate complexes [M(cbdt)2]z− (M=Zn, Co, Cu, Au, Ni, Pd, z=0, 1, 2)
- 15 March 2012
- Published by Wiley in physica status solidi (c)
- Vol. 9 (5) , 1123-1126
Electrocrystallisation of (perylene)2[M(mnt)2] salts
- 15 March 2012
- Published by Wiley in physica status solidi (c)
- Vol. 9 (5) , 1123-1126
Electrocrystallisation of (perylene)2[M(mnt)2] salts