Christoph Lauer
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Christoph Lauer has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
- Klaus Georg Nickel
University of Tübingen
5 shared publications Carolin Fischer
Applications Laboratory NETZSCH-Gerätebau GmbH Wittelsbacherstraße 42 95100 Selb Germany
1 shared publicationChristoph Berthold
Division of Applied Mineralogy, Department of Geosciences Eberhard Karls University of Tübingen Wilhelmstraße 56 72074 Tübingen Germany
1 shared publication- Christoph Berthold
Applied Mineralogy, University of Tübingen, 72076 Tübingen, Germany
1 shared publication - Daria Kovaleva
Universität Stuttgart Institut für Leichtbau Entwerfen und Konstruieren Pfaffenwaldring 14 70569 Stuttgart
1 shared publication Doreen Rapp
Applications Laboratory NETZSCH-Gerätebau GmbH Wittelsbacherstraße 42 95100 Selb Germany
1 shared publication
Latest Publications
- Open Access
- 29 October 2019
- Published by Wiley in Advanced Engineering Materials
- Vol. 22 (4)
On the Relation of Amorphous Calcium Carbonate and the Macromechanical Properties of Sea Urchin Spines
Amorphous calcium carbonate (ACC) plays a crucial role in the formation of biogenic carbonates. It is widely accepted that ACC and organic macromolecules alter the fracture properties of Echinoderm calcite from the well‐defined cleavage planes of the raw material to conchoidal. However, the influence of ACC on the outstanding macromechanical properties of Echinoderm calcite is unknown. To address this question, full‐grown spines of the slate pencil urchin are shortly heated to 250 °C. Differential scanning calorimetry indicates that all ACC is crystallized at this temperature. Heated spines are compared with an untreated control group and no significant differences in compressive strength, bending strength, damage tolerance, and Young's modulus are detected. This highlights the weak influence of ≈6 wt% ACC on the macromechanical properties of Echinoderm calcite, which are likely established by its intricate and damage tolerant microstructure. When heating Echinoderm calcite, organics decompose, Mg calcite transforms, water is lost, and cracks and micropores form. All these processes are analyzed to exclude their influence on the mechanical properties, and it is imperative to consider them all. Only this way meaningful results can be achieved as these processes are temperature and dwelling time dependent and may even occur below 250 °C.
- 29 October 2019
- Published by Wiley in Advanced Engineering Materials
- Vol. 22 (4)
Open AccessOn the Relation of Amorphous Calcium Carbonate and the Macromechanical Properties of Sea Urchin Spines
Amorphous calcium carbonate (ACC) plays a crucial role in the formation of biogenic carbonates. It is widely accepted that ACC and organic macromolecules alter the fracture properties of Echinoderm calcite from the well‐defined cleavage planes of the raw material to conchoidal. However, the influence of ACC on the outstanding macromechanical properties of Echinoderm calcite is unknown. To address this question, full‐grown spines of the slate pencil urchin are shortly heated to 250 °C. Differential scanning calorimetry indicates that all ACC is crystallized at this temperature. Heated spines are compared with an untreated control group and no significant differences in compressive strength, bending strength, damage tolerance, and Young's modulus are detected. This highlights the weak influence of ≈6 wt% ACC on the macromechanical properties of Echinoderm calcite, which are likely established by its intricate and damage tolerant microstructure. When heating Echinoderm calcite, organics decompose, Mg calcite transforms, water is lost, and cracks and micropores form. All these processes are analyzed to exclude their influence on the mechanical properties, and it is imperative to consider them all. Only this way meaningful results can be achieved as these processes are temperature and dwelling time dependent and may even occur below 250 °C.
- 19 December 2018
- Published by IOP Publishing in Bioinspiration & Biomimetics
- Vol. 14 (1) , 016018
Strength, elasticity and the limits of energy dissipation in two related sea urchin spines with biomimetic potential
The calcitic spines of the sea urchins Heterocentrotus mamillatus and H. trigonarius are promising role models for lightweight applications, bone tissue scaffolds and energy dissipating processes due to their highly porous and organized structure. Therefore, mechanical properties including Young's Modulus, strength, failure behaviour and energy dissipation efficiency have been investigated in depth with uniaxial compression experiments, 3-point bending tests and resonance frequency damping analysis. It was found that despite a very similar structure, H. trigonarius has a significantly lower porosity than H. mamillatus leading to a higher strength and Young's Moduli, but limited ability to dissipate energy. In order to show reliable energy dissipation during failure in uniaxial compression, a transition porosity of 0.55-0.6 needs to be exceeded. The most effective structure for this purpose is a homogeneous, foam-like structure confined by a thin and dense shell that increases initial strength and was found in numerous spines of H. mamillatus. Sharp porosity changes induced by dense growth layers or prominent wedges of the spines' radiating building principle act as structural weaknesses, along which large flakes can be spalled, reducing the energy dissipation efficiency considerably. The high strength and Young's Modulus at the biologically necessary high porosity levels of the spines is useful for Heterocentrotus and their construction therefore remains to be a good example of biomimetics. However, the energy dissipative failure behaviour may be regarded as a mere side effect of the structure.
- 19 December 2018
- Published by IOP Publishing in Bioinspiration & Biomimetics
- Vol. 14 (1) , 016018
Strength, elasticity and the limits of energy dissipation in two related sea urchin spines with biomimetic potential
The calcitic spines of the sea urchins Heterocentrotus mamillatus and H. trigonarius are promising role models for lightweight applications, bone tissue scaffolds and energy dissipating processes due to their highly porous and organized structure. Therefore, mechanical properties including Young's Modulus, strength, failure behaviour and energy dissipation efficiency have been investigated in depth with uniaxial compression experiments, 3-point bending tests and resonance frequency damping analysis. It was found that despite a very similar structure, H. trigonarius has a significantly lower porosity than H. mamillatus leading to a higher strength and Young's Moduli, but limited ability to dissipate energy. In order to show reliable energy dissipation during failure in uniaxial compression, a transition porosity of 0.55-0.6 needs to be exceeded. The most effective structure for this purpose is a homogeneous, foam-like structure confined by a thin and dense shell that increases initial strength and was found in numerous spines of H. mamillatus. Sharp porosity changes induced by dense growth layers or prominent wedges of the spines' radiating building principle act as structural weaknesses, along which large flakes can be spalled, reducing the energy dissipation efficiency considerably. The high strength and Young's Modulus at the biologically necessary high porosity levels of the spines is useful for Heterocentrotus and their construction therefore remains to be a good example of biomimetics. However, the energy dissipative failure behaviour may be regarded as a mere side effect of the structure.
- 1 September 2018
- Published by Elsevier in Acta Biomaterialia
- Vol. 77, 322-332
Strength-size relationships in two porous biological materials
- 1 September 2018
- Published by Elsevier in Acta Biomaterialia
- Vol. 77, 322-332
Strength-size relationships in two porous biological materials
- 4 November 2017
- Published by Springer Nature in Zoomorphology
- Vol. 137 (1) , 139-154
Morphology and porosity of the spines of the sea urchin Heterocentrotus mamillatus and their implications on the mechanical performance
- 4 November 2017
- Published by Springer Nature in Zoomorphology
- Vol. 137 (1) , 139-154
Morphology and porosity of the spines of the sea urchin Heterocentrotus mamillatus and their implications on the mechanical performance
- 20 December 2016
- Published by Springer Nature
- p. 109-133
Plants and Animals as Source of Inspiration for Energy Dissipation in Load Bearing Systems and Facades
- 20 December 2016
- Published by Springer Nature
- p. 109-133
Plants and Animals as Source of Inspiration for Energy Dissipation in Load Bearing Systems and Facades