Computational Fluid Dynamics Modeling of Gas–Liquid Cylindrical Cyclones, Geometrical Analysis
- 26 April 2018
- journal article
- research article
- Published by Wiley in Journal of Energy Resources Technology
- Vol. 140 (9)
Abstract
The gas–liquid cylindrical cyclone (GLCC) is a widely used alternative for gas–liquid conventional separation. Besides its maturity, the effect of some geometrical parameters over its performance is not fully understood. The main objective of this study is to use computational fluid dynamics (CFD) modeling in order to evaluate the effect of geometrical modifications in the reduction of liquid carry over (LCO) and gas carry under (GCU). Simulations for two-phase flow were carried out under zero net liquid flow, and the average liquid holdup was compared with Kanshio (Kanshio, S., 2015, “Multiphase Flow in Pipe Cyclonic Separator,” Ph.D. thesis, Cranfield University, Cranfield, UK) obtaining root-mean-square errors around 13% between CFD and experimental data. An experimental setup, in which LCO data were acquired, was built in order to validate a CFD model that includes both phases entering to the GLCC. An average discrepancy below 6% was obtained by comparing simulations with experimental data. Once the model was validated, five geometrical variables were tested with CFD. The considered variables correspond to the inlet configuration (location and inclination angle), the effect of dual inlet, and nozzle geometry (diameter and area reduction). Based on the results, the best configuration corresponds to an angle of 27 deg, inlet location 10 cm above the center, a dual inlet with 20 cm of spacing between both legs, a nozzle of 3.5 cm of diameter, and a volute inlet of 15% of pipe area. The combination of these options in the same geometry reduced LCO by 98% with respect to the original case of the experimental setup. Finally, the swirling decay was studied with CFD showing that liquid has a greater impact than the gas flowrate.Keywords
This publication has 20 references indexed in Scilit:
- Numerical investigation of swirling flow in cylindrical cyclonesChemical Engineering Research and Design, 2011
- The State-of-the-Art of Gas-Liquid Cylindrical Cyclone Control Technology: From Laboratory to FieldJournal of Energy Resources Technology, 2010
- Procedure for Estimation and Reporting of Uncertainty Due to Discretization in CFD ApplicationsJournal of Fluids Engineering, 2008
- Three-dimensional turbulent swirling flow in a cylinder: Experiments and computationsInternational Journal of Heat and Fluid Flow, 2007
- The Liquid/Liquid Sedimentation Process: From Droplet Coalescence to Technologically Enhanced Water/Oil Emulsion Gravity Separators: A ReviewJournal of Dispersion Science and Technology, 2006
- Local Velocity Measurements and Computational Fluid Dynamics (CFD) Simulations of Swirling Flow in a Cylindrical Cyclone SeparatorJournal of Energy Resources Technology, 2004
- The effects of geometry, fluid properties and pressure on the hydrodynamics of gas–liquid cylindrical cyclone separatorsInternational Journal of Multiphase Flow, 2000
- Flow Field Prediction and Bubble Trajectory Model in Gas-Liquid Cylindrical Cyclone (GLCC) SeparatorsJournal of Energy Resources Technology, 1999
- Aspect Ratio Modeling and Design Procedure for GLCC Compact SeparatorsJournal of Energy Resources Technology, 1999
- The rate of decay of swirl in turbulent pipe flowFlow Measurement and Instrumentation, 1998