Effects of milling time on hardness and electrical conductivity of in situ Cu–NbC composite produced by mechanical alloying
Authors:
- H. ZuhailawatiHZH. Zuhailawati
- Y. MahaniYMY. Mahani
- 1 May 2009
- journal article
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 476 (1-2) , 142-146
Abstract
No abstract availableKeywords
This publication has 14 references indexed in Scilit:
- Synthesis of copper–niobium carbide composite powder by in situ processingJournal of Alloys and Compounds, 2008
- Properties of copper matrix reinforced with various size and amount of Al2O3 particlesJournal of Materials Processing Technology, 2008
- XRD, XPS and SEM characterisation of Cu–NbC nanocomposite produced by mechanical alloyingMaterials Chemistry and Physics, 2008
- In-situ production of Fe–TiC compositeMaterials Letters, 2007
- Correlation between milling parameters and microstructure characteristics of nanocrystalline copper powder prepared via a high energy planetary ball millJournal of Alloys and Compounds, 2007
- Dependency of physical and mechanical properties of mechanical alloyed Al–Al2O3 composite on milling timeMaterials & Design (1980-2015), 2007
- Production of copper–niobium carbide nanocomposite powders via mechanical alloyingMaterials Science and Engineering: A, 2005
- Structural evolution of the Ti–Si–C system during mechanical alloyingJournal of Alloys and Compounds, 2005
- Cu–Nb alloys prepared by mechanical alloying and subsequent heat treatmentJournal of Alloys and Compounds, 2004
- Supersaturated solid solution of niobium in copper by mechanical alloyingJournal of Alloys and Compounds, 2003