An Efficient SSHI Interface With Increased Input Range for Piezoelectric Energy Harvesting Under Variable Conditions
Open Access
- 10 August 2016
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 51 (11) , 2729-2742
Abstract
Piezoelectric vibration energy harvesters have been widely researched and are increasingly employed for powering wireless sensor nodes. The synchronized switch harvesting on inductor (SSHI) circuit is one of the most efficient interfaces for piezoelectric vibration energy harvesters. However, the traditional incarnation of this circuit suffers from a significant startup issue that limits operation in low and variable amplitude vibration environments. This paper addresses this start-up issue for the SSHI rectifier by proposing a new architecture with SSHI startup circuitry. The startup circuitry monitors if the SSHI circuit is operating correctly and re-starts the SSHI interface if required. The proposed circuit is comprehensively analyzed and experimentally validated through tests conducted by integrating a commercial piezoelectric vibration energy harvester with the new interface circuit designed in a 0.35-μm HV CMOS process. Compared to conventional SSHI rectifiers, the proposed circuit significantly decreases the required minimum input excitation amplitude before energy can be harvested, making it possible to extract energy over an increased excitation range.Keywords
Funding Information
- Engineering and Physical Sciences Research Council (EP/K000314/1, EP/L010917/1)
This publication has 23 references indexed in Scilit:
- A Nanopower Synchronous Charge Extractor IC for Low-Voltage Piezoelectric Energy Harvesting With Residual Charge InversionIEEE Transactions on Power Electronics, 2015
- A Micro Inertial Energy Harvesting Platform With Self-Supplied Power Management Circuit for Autonomous Wireless Sensor NodesIEEE Journal of Solid-State Circuits, 2014
- An Autonomous Piezoelectric Energy Harvesting IC Based on a Synchronous Multi-Shot TechniqueIEEE Journal of Solid-State Circuits, 2014
- A Self-Powered High-Efficiency Rectifier With Automatic Resetting of Transducer Capacitance in Piezoelectric Energy Harvesting SystemsIEEE Transactions on Very Large Scale Integration (VLSI) Systems, 2014
- Development of high performance piezoelectric d33 mode MEMS vibration energy harvester based on PMN-PT single crystal thick filmSensors and Actuators A: Physical, 2014
- Micropower Design of a Fully Autonomous Energy Harvesting Circuit for Arrays of Piezoelectric TransducersIEEE Transactions on Power Electronics, 2013
- A Fully Autonomous Integrated Interface Circuit for Piezoelectric HarvestersIEEE Journal of Solid-State Circuits, 2012
- Low-Power Design of a Self-powered Piezoelectric Energy Harvesting System With Maximum Power Point TrackingIEEE Transactions on Power Electronics, 2012
- An Efficient Piezoelectric Energy Harvesting Interface Circuit Using a Bias-Flip Rectifier and Shared InductorIEEE Journal of Solid-State Circuits, 2009
- Efficiency Enhancement of a Piezoelectric Energy Harvesting Device in Pulsed Operation by Synchronous Charge InversionJournal of Intelligent Material Systems and Structures, 2005