Single asperity tribochemical wear of silicon by atomic force microscopy
- 31 January 2009
- journal article
- Published by Springer Nature in Journal of Materials Research
- Vol. 24 (1) , 173-178
Abstract
Measurements of single asperity wear on oxidized silicon surface in aqueous potassium hydroxide (KOH) using atomic force microscopy (AFM), where the single crystal silicon tip was used both to tribologically load and image the surface, is presented. AFM was also operating in the lateral (frictional) force mode to investigate the pH dependence of kinetic friction between the tip and the SiO2 surface. It was shown that the Si tip wear amount strongly depended on the solution pH value and was at a maximum at around pH 10. It was also found that the Si removal volume in mol was approximately equal to that of SiO2 irrespective of the solution pH value. This equality implies that the formation of the Si–O–Si bridge between one Si atom of the tip and one SiO2 molecule of the specimen at the wear interface. The surface of the Si tip is then oxidized. Finally, the bond rupture by the tip movement will occur, the dimeric silica (OH)3Si–O–Si(OH)3, including the Si–O–Si bridge, is dissolved in the KOH solution. The frictional signal is also sensitive to the pH values of the solution and peaked at around pH 10. These results indicate that the removal behavior of the Si tip and SiO2 surface would be affected by the frictional force between the Si and the SiO2, because of an increased liquid temperature and a compressive stress in Si and SiO2 networks. Strong influence is observed by the pH of the ambient solution confirming the important role of the OH− in the wear mechanism. Pressure dependence of the microwear behavior under aqueous electrolyte solutions has also been investigated. A microscopic removal mechanism, which is determined by interplay of the diffusion of water in Si and SiO2, is presented.Keywords
This publication has 14 references indexed in Scilit:
- Tribochemical wear of sodium trisilicate glass at the nanometer size scaleJournal of Applied Physics, 2006
- Single asperity tribochemical wear of silicon nitride studied by atomic force microscopyJournal of Applied Physics, 2002
- AFM Studies on the Difference in Wear Behavior Between Si and SiO[sub 2] in KOH SolutionJournal of the Electrochemical Society, 2000
- The influence of pH on friction between oxide surfacesin electrolytes, studied with lateral force microscopy:application as a nanochemical imaging techniqueTribology Letters, 1997
- Sensitivity of Frictional Forces to pH on a Nanometer Scale: A Lateral Force Microscopy StudyLangmuir, 1995
- The atomic-scale removal mechanism during chemo-mechanical polishing of Si(100) and Si(111)Surface Science, 1995
- Chemomechanical polishing of silicon: Surface termination and mechanism of removalApplied Physics Letters, 1994
- Application of Chemical Mechanical Polishing to the Fabrication of VLSI Circuit InterconnectionsJournal of the Electrochemical Society, 1991
- Effect of Stress on Water Diffusion in Silica GlassJournal of the American Ceramic Society, 1984
- Stress Corrosion of Silica GlassJournal of the American Ceramic Society, 1981