Reconstruction of thermoacoustic emission sources induced by proton irradiation using numerical time reversal
Authors:
- 5 January 2023
- journal article
- research article
- Published by IOP Publishing in Physics in Medicine & Biology
- Vol. 68 (2) , 025003
Abstract
Objective. Mapping of dose delivery in proton beam therapy can potentially be performed by analyzing thermoacoustic emissions measured by ultrasound arrays. Here, a method is derived and demonstrated for spatial mapping of thermoacoustic sources using numerical time reversal, simulating re-transmission of measured emissions into the medium. Approach. Spatial distributions of thermoacoustic emission sources are shown to be approximated by the analytic-signal form of the time-reversed acoustic field, evaluated at the time of the initial proton pulse. Given calibration of the array sensitivity and knowledge of tissue properties, this approach approximately reconstructs the acoustic source amplitude, equal to the product of the time derivative of the radiation dose rate, mass density, and Grüneisen parameter. This approach was implemented using two models for acoustic fields of the array elements, one modeling elements as line sources and the other as rectangular radiators. Thermoacoustic source reconstructions employed previously reported measurements of emissions from proton energy deposition in tissue-mimicking phantoms. For a phantom incorporating a bone layer, reconstructions accounted for the higher sound speed in bone. Dependence of reconstruction quality on array aperture size and signal-to-noise ratio was consistent with previous acoustic simulation studies. Main results. Thermoacoustic source distributions were successfully reconstructed from acoustic emissions measured by a linear ultrasound array. Spatial resolution of reconstructions was significantly improved in the azimuthal (array) direction by incorporation of array element diffraction. Source localization agreed well with Monte Carlo simulations of energy deposition, and was improved by incorporating effects of inhomogeneous sound speed. Significance. The presented numerical time reversal approach reconstructs thermoacoustic sources from proton beam radiation, based on straightforward processing of acoustic emissions measured by ultrasound arrays. This approach may be useful for ranging and dosimetry of clinical proton beams, if acoustic emissions of sufficient amplitude and bandwidth can be generated by therapeutic proton sources.Keywords
Funding Information
- University of Cincinnati
- Instituto Nacional de Cancerología (CA 158439)
This publication has 47 references indexed in Scilit:
- Photoacoustic tomography in absorbing acoustic media using time reversalInverse Problems, 2010
- SRIM – The stopping and range of ions in matter (2010)Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms, 2010
- k-Wave: MATLAB toolbox for the simulation and reconstruction of photoacoustic wave fieldsJournal of Biomedical Optics, 2010
- High-Resolution Imaging of Sound Sources in Free Field Using a Numerical Time-Reversal SinkActa Acustica united with Acustica, 2009
- Application of inverse source concepts to photoacoustic tomographyInverse Problems, 2007
- Time Reversal and Its Application to Tomography with Diffracting SourcesPhysical Review Letters, 2004
- Focusing in transmit–receive mode through inhomogeneous media: The time reversal matched filter approachThe Journal of the Acoustical Society of America, 1995
- Time resolved properties of acoustic pulses generated in water and in soft tissue by pulsed proton beam irradiation—A possibility of doses distribution monitoring in proton radiation therapyMedical Physics, 1991
- Acoustic detection of high energy particle showers in waterNuclear Instruments and Methods, 1979
- Experimental studies of the acoustic signature of proton beams traversing fluid mediaNuclear Instruments and Methods, 1979