A Rapid Method of Measuring the Glass Transition Temperature Using a Novel Dynamic Mechanical Analysis Method
- 20 February 2013
- journal article
- research article
- Published by Taylor & Francis in The Journal of Adhesion
- Vol. 89 (10) , 785-806
Abstract
This paper describes a method of measuring the glass transition temperature, by dynamic mechanical analysis, in which the glass transition temperature can be obtained by determining the temperature at which the peak value of damping is observed. The novelty of the method reported here is to use a fast heating technique with a feedback circuit that maintains the specimen at resonance. By doing the test in about a minute, polymer cure is not altered significantly by the heating cycle.Keywords
This publication has 20 references indexed in Scilit:
- Nondestructive Testing2011
- Vibration Damping of Adhesively Bonded Joints2011
- An Introduction to Polymer Physics2002
- Low temperature transitions in fibre reinforced polymersComposites Part A: Applied Science and Manufacturing, 2001
- The effect of immersion in sea water on the dynamic properties of fibre-reinforced flexibilised epoxy compositesComposite Structures, 1995
- Factors which affect the glass transition and damping capability of polymersPolymers for Advanced Technologies, 1991
- Determination of the damping properties of structures by transient testing using zoom-FFTJournal of Physics E: Scientific Instruments, 1985
- A Vibration Technique for Non-Destructive Testing of Fibre Composite StructuresJournal of Composite Materials, 1979
- Effects of Shear Damage on the Torsional Behaviour of Carbon Fibre Reinforced PlasticsJournal of Composite Materials, 1973
- The role of Ga2O3 in the preparation of Y2O3:Eu3+ phosphor from the oxidesJournal of Materials Science, 1972