Electrical discharge micro-texturing using compound tool electrodes for tribological and wettability applications
- 3 April 2022
- journal article
- research article
- Published by SAGE Publications in Surface Engineering
- Vol. 38 (4) , 448-464
Abstract
The present work consists of large-area surface texturing through die-sinking electrical discharge machining (EDM) using compound tool electrodes. The compound tools were machined through the wire electrical discharge machining (WEDM). The micro-textured surfaces incorporating array of nearly square/circular-shaped micro-dimples, rectangular micro-channels and square micro-pillars were analysed for their wetting properties. An increase in water contact angle (CA) indicated higher water repellence for textured surfaces with respect to the untextured ones. Further, improved frictional behaviour was elicited through tribological analysis via the ball-on-disc test, revealing a lower average coefficient of friction (CoF) compared to the untextured surface. The wear volume of textured surfaces (micro-channels and micro-pillars) exhibited a slightly higher value with respect to the untextured surface, which can be ascribed to the stress concentration from microfeatures. However, the micro-dimpled textured surface showed a relatively lower wear volume, presenting a suitable micro-texture for improved tribological characteristics.Keywords
This publication has 28 references indexed in Scilit:
- On Design and Tribological Behaviour of Laser Textured SurfacesProcedia CIRP, 2017
- Superhydrophobic surfaces for corrosion protection: a review of recent progresses and future directionsJournal of Coatings Technology and Research, 2015
- Recent development on surface texturing in enhancing tribological performance of bearing slidersSurface and Coatings Technology, 2015
- Improved friction and wear performance of micro dimpled ceramic-on-ceramic interface for hip joint arthroplastyCeramics International, 2015
- The effect of superhydrophobic wetting state on corrosion protection – The AKD exampleJournal of Colloid and Interface Science, 2013
- Experimental and numerical analysis of dry contact in the pin on disc testWear, 2013
- Experimental investigation of tribological performance of laser textured stainless steel ringsTribology International, 2011
- Effects of laser surface texturing on friction behavior of silicon nitride under lubrication with waterTribology International, 2011
- Micro electric discharge milling process performance: An experimental investigationInternational Journal of Machine Tools and Manufacture, 2010
- Electrical discharge texturingInternational Journal of Machine Tools and Manufacture, 1992