Hardness of Nanostructured Al-Zn, Al-Mg and Al-Zn-Mg Alloys Obtained by High-Pressure Torsion
- 15 January 2006
- journal article
- Published by Trans Tech Publications, Ltd. in Defect and Diffusion Forum
- Vol. 249, 155-160
Abstract
Microstructure and hardness of ternary Al–Zn–Mg alloys were studied both in as cast state and after high pressure torsion (HPT) with 5 torsions (shear strain about 6). The size of (Al) grains and of reinforcing second phase precipitates decreases drastically after HPT reaching nanometer range. During HPT, the Zn- and Mg-rich supersaturated (Al) solid solution decomposes and reaches the equilibrium state corresponding to the room temperature. In the as cast state the hardness of the supersaturated solid solutions increases with increasing Zn and Mg content due to the solid-solution hardening. However, after HPT the work hardening and Hall-Petch hardening due to the decreasing grain size competes with softening due to the decomposition of a supersaturated solid solution. In the net effect, the severe plastic deformation results in softening of ternary Al–Zn– Mg alloys.Keywords
This publication has 15 references indexed in Scilit:
- Formation of Nanostructure during High-Pressure Torsion of Al-Zn, Al-Mg and Al-Zn-Mg AlloysDefect and Diffusion Forum, 2005
- Influence of ECAP on precipitate distributions in a spray-cast aluminum alloyActa Materialia, 2005
- Formation of nanograined structure and decomposition of supersaturated solid solution during high pressure torsion of Al–Zn and Al–Mg alloysActa Materialia, 2004
- Materials science: Nanomaterial advantageNature, 2002
- Diffusion in Ultrafine-Grained Al-Mg AlloysDefect and Diffusion Forum, 2001
- The Role of Grain Boundary Diffusion in Discontinuous ReactionsDefect and Diffusion Forum, 2001
- Impurity Diffusion in AluminumPhysical Review B, 1970
- Sur la nature des défauts ponctuels crées par le croisement des dislocationsActa Metallurgica, 1961
- X-ray line broadening from filed aluminium and wolframActa Metallurgica, 1953
- The Deformation and Ageing of Mild Steel: III Discussion of ResultsProceedings of the Physical Society. Section B, 1951