Double inductively coupled plasma using Ar/O2 for biomedical implants sterilization and large polymer surfaces decontamination
Open Access
- 13 August 2025
- journal article
- Published by American Vacuum Society in Journal of Vacuum Science & Technology B
- Vol. 43 (5)
Abstract
Surface modification and sterilization of polymers used in medical implants are crucial to patient safety. The objective of this study is to demonstrate and discuss the feasibility of double inductively coupled plasma discharge (DICP) as a method of sterilizing microorganisms from large polymer surfaces. A numerical simulation of a DICP is performed using COMSOL Multiphysics (f = 13.56 MHz, 100 SCCM Ar/O2). An electrohydrodynamic model for radiofrequency coupling and transport behavior is investigated. A comparison with experimental results at the same discharge conditions is performed. Experimental and simulated data are found to agree well in terms of their absolute values and spatial evolution. The radial distribution of different reactive species, potential, power deposition, and resolution temperature is insighted into the two-dimensional through a simulation model. The effects of different parameters such as power (100–900 W) and argon/oxygen gas mixtures on the discharge are analyzed and discussed. Results show that with relatively low gas pressure (about 10 mTorr), symmetric DICP generates high plasma densities (1011–1012 cm−3). In addition, the oxygen atom density and the mixing ratio of the gas are the most important parameters to consider when sterilizing biomedical implants since both factors affect the removal rate significantly. Based on simulations, a homogenous decontamination of large-scale polymer surfaces in axial and radial directions is performed using symmetric double inductively coupled plasma. Finally, the inductively coupled plasma process was shown to effectively sterilize large polymer surfaces used in biomedical implants against different microorganisms, fungi and bacteria.Keywords
Funding Information
- Princess Nourah Bint Abdulrahman University (RPFAP-64- 1445)
This publication has 40 references indexed in Scilit:
- PECVD and PEALD on polymer substrates (part I): Fundamentals and analysis of plasma activation and thin film growthPlasma Processes and Polymers, 2023
- UHMWPE for biomedical applications: Performance and functionalizationEuropean Polymer Journal, 2020
- Inactivation of spores by nonthermal plasmasWorld Journal of Microbiology and Biotechnology, 2018
- Study of sterilization-treatment in pure and N- doped carbon thin films synthesized by inductively coupled plasma assisted pulsed-DC magnetron sputteringApplied Surface Science, 2017
- Inactivation of Bacteria and Biomolecules by Low‐Pressure Plasma DischargesPlasma Processes and Polymers, 2010
- The effects of pulsed inductively coupled plasma (PICP) on physical properties and biocompatibility of crosslinked gelatin filmsInternational Journal of Biological Macromolecules, 2010
- Plasma sterilization using the RF glow dischargeApplied Surface Science, 2009
- Decontamination of Surfaces by Low Pressure Plasma DischargesPlasma Processes and Polymers, 2006
- Plasma diagnostics in a double inductively coupled source (DICP) for plasma sterilisationSurface and Coatings Technology, 2003
- Low-temperature sterilization using gas plasmas: a review of the experiments and an analysis of the inactivation mechanismsInternational Journal of Pharmaceutics, 2001