Microstructural Evolution and Mechanical Properties of 2219 Aluminum Alloy Deposited by Wire and Arc Additive Manufacturing
Authors:
- 4 May 2022
- journal article
- research article
- Published by Wiley in Advanced Engineering Materials
- Vol. 24 (9)
Abstract
Thin‐walled specimens of 2219 aluminum alloy are fabricated at different deposition speeds using the wire + arc additive manufacturing (WAAM) method. The effects of deposition speed on the microstructure, growth rate of columnar grains, and tensile strength of WAAM‐printed Al–Cu alloys are investigated. The fraction of columnar grains decreases from 86.7% to 12.2%, and the average grain size decreases from 147 to 65.3 μm as the deposition speed increased. Also, the fraction of θ phase gradually decreases as the deposition speed increased. Specifically, the growth rate of columnar grains varies from 1.02 × 10−3 to 2.05 × 10−3 m s−1, which possesses two orders of magnitude higher than the growth rate of equiaxed grains. With increasing the loading stress, the cracks first form on the dendritic θ phases located at the grain boundaries, reducing the effective loading area. With the deposition speed increased, the typical dimple‐like structures are presented at the fracture surfaces, attributing to a decrease in Cu content at the grain boundaries and the producing of the spot‐like θ phase inside the matrix. The specimen with a deposition speed of 250 mm min−1 possesses a tensile strength around 274 MPa, and the corresponding elongation reaches to 12.6%.Keywords
Funding Information
- Natural Science Foundation of China (52175299, U1960102)
This publication has 21 references indexed in Scilit:
- Mechanical properties of 2219-Al components produced by additive manufacturing with TIGThe International Journal of Advanced Manufacturing Technology, 2015
- Fundamentals of Solidification in Aluminum CastingsInternational Journal of Metalcasting, 2014
- Beryllium as a grain refiner in titanium alloysJournal of Alloys and Compounds, 2009
- Effects of process variables and size-scale on solidification microstructure in beam-based fabrication of bulky 3D structuresMaterials Science and Engineering: A, 2009
- Effect of clustering on particle pushing and solidification behaviour in TiB2 reinforced aluminium PMMCsComposites Part A: Applied Science and Manufacturing, 2005
- Rapid prototyping of 4043 Al-alloy parts by VP-GTAWJournal of Materials Processing Technology, 2004
- Microstructures of laser-deposited Ti–6Al–4VMaterials & Design (1980-2015), 2004
- Microstructure and texture evolution during solidification processing of Ti–6Al–4VJournal of Materials Processing Technology, 2003
- Recent development in aluminium alloys for aerospace applicationsMaterials Science and Engineering: A, 2000
- Theory of microstructural development during rapid solidificationActa Metallurgica, 1986