Mechanical Behavior of Deformation‐Induced α′‐Martensite and Flow Curve Modeling of a Cast CrMnNi TRIP‐Steel
- 19 April 2012
- journal article
- research article
- Published by Wiley in Steel Research International
- Vol. 83 (6) , 529-537
Abstract
For the modeling of the mechanical behavior of a two phase alloy with the rule of mixture (RM), the flow stress of both phases is needed. In order to obtain these information for the α′‐martensite in high alloyed TRIP‐steels, compression tests at cryogenic temperatures were performed to create a fully deformation‐induced martensitic microstructure. This martensitic material condition was subsequently tested under compressive loading at −60, 20, and 100°C and at strain rates of 10−3, 100, and 103 s−1 to determine the mechanical properties. The α′‐martensite possesses high strength and surprisingly good ductility up to 60% of compressive strain. Using the flow stress behavior of the α′‐martensite and that of the stable austenitic steel AISI 316L, the flow stress behavior of the high alloyed CrMnNi TRIP‐steel is modeled successfully using a special RM proposed by Narutani et al.Keywords
This publication has 27 references indexed in Scilit:
- Strain Rate Dependent Flow Stress and Energy Absorption Behaviour of Cast CrMnNi TRIP/TWIP SteelsSteel Research International, 2011
- Spontaneous and Deformation‐Induced Martensite in Austenitic Stainless Steels with Different StabilitySteel Research International, 2011
- Stress-Induced Martensitic Transformation Behaviors at Various Temperatures and Their TRIP Effects in SUS304 Metastable Austenitic Stainless SteelISIJ International, 2011
- Temperature Depending Influence of the Martensite Formation on the Mechanical Properties of High‐Alloyed Cr‐Mn‐Ni As‐Cast SteelsSteel Research International, 2010
- A model for deformation behavior and mechanically induced martensitic transformation of metastable austenitic steelActa Materialia, 2004
- On the Deformation Behaviour and Martensitic Transformations of Metastable Austenitic SteelsAdvanced Engineering Materials, 2004
- The morphology and crystallography of lath martensite in Fe-C alloysActa Materialia, 2003
- TRIP-Assisted Steels?ISIJ International, 2002
- High strength Fe–Mn–(Al, Si) TRIP/TWIP steels development — properties — applicationInternational Journal of Plasticity, 2000
- ber den Mechanismus der Stahlh rtungThe European Physical Journal A, 1930