Modelling of pilot scale vertical roller mill operated in overflow mode
- 16 July 2019
- journal article
- research article
- Published by SAGE Publications in Mineral Processing and Extractive Metallurgy: Transactions of the Institutions of Mining and Metallurgy
- Vol. 130 (4) , 332-340
Abstract
Pilot scale grinding tests were performed for various materials by a mobile unit for modelling studies. Vertical roller mill was separated into the two section as grinding and separation. Grinding operation was defined by population balance model and breakage rate was correlated with specific grinding force, material index determined by compressed bed breakage tests and surface area of grinding table feed. For the modelling of separation section, obtained data were fitted to efficiency curve approach and model parameters were back calculated. Relationships of these parameters with operational conditions were investigated. As a first model parameter by pass fraction of was correlated with dust load of the separator feed. Then, by pass fraction was defined as a function of the dust load of the separator feed and material density. The ratio of air speed and rotor speed was correlated with corrected cut size and density effect was reflected to the model.Keywords
This publication has 11 references indexed in Scilit:
- Multi component modelling of an air classifierMinerals Engineering, 2016
- Selection and mathematical modelling of high efficiency air classifiersPowder Technology, 2014
- Application of population balance model to HPGR crushingMinerals Engineering, 2013
- A new method for determination of fine particle breakageMinerals Engineering, 2011
- Trends in comminution driven by energyAdvanced Powder Technology, 2011
- Breakage of coals in ring-roller mills Part I. The breakage properties of various coals and simulation model to predict steady-state mill performancePowder Technology, 1996
- An analysis of ball-and-race milling part III. Scale-up to industrial millsPowder Technology, 1982
- An analysis of ball-and-race milling part II. The babcock E 1.7 millPowder Technology, 1982
- Some Results on the Description of Size Reduction as a Rate Process in Various MillsIndustrial & Engineering Chemistry Process Design and Development, 1976
- The mathematical description of certain breakage mechanisms leading to the logarithmico-normal distributionJournal of the Franklin Institute, 1947