Preliminary design and experimental verification of a triple swirler combustor
Authors:
- 10 March 2015
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering
- Vol. 229 (12) , 2258-2271
Abstract
A preliminary combustor design procedure based on triple swirler is presented, and then a triple swirler combustor with design fuel–air ratio of 0.033 is designed according to the design procedure and studied experimentally. The test results show that: the total pressure loss coefficient increases linearly from 0.021 to 0.04 as the inlet airflow velocity increases from 40 m/s to 70 m/s, while the flow drag coefficient decreases nonlinearly with the inlet airflow velocity increasing; there exists an optimal velocity, at which the ignition overall fuel–air ratio is minimal at each given inlet airflow temperature, and the increasing of inlet airflow temperature makes for combustor ignition; the lean blowout fuel–air ratio is no more than 0.005 for most cases at the inlet airflow temperature of 473 K; the combustion efficiency is high at low fuel–air ratio and increases with inlet airflow velocity and temperature increasing on the whole. Pattern factor (OTDF) ranges from 0.15 to 0.17 for all cases at the inlet airflow temperature of 473 K; the combustion performance validates that triple swirler is fit for the dome of high-temperature-rise combustor and the design rules of the triple swirler combustor mentioned in this paper are feasible.Keywords
This publication has 11 references indexed in Scilit:
- Design, Evaluation and Performance Analysis of Staged Low Emission CombustorsJournal of Engineering for Gas Turbines and Power, 2014
- Design, Evaluation and Performance Analysis of Staged Low Emission Combustors2012
- Engineering Aspects of Complex Gas Turbine Combustion Mixers Part I: High Delta-T2011
- Design Procedures and a Developed Computer Code for Single Annular Combustor Preliminary Design2009
- Variable Fuel Placement Injector Development2003
- Experimental study of velocity flow field for a multiple swirl spray combustor2002
- Experimental and Numerical Studies of the Velocity Field of a Triple Annular Swirler2002
- Development of a Variable Fuel Placement Airblast Atomiser2001
- The History of North American Small Gas Turbine Aircraft Engines1999
- Technology for the design of high temperature rise combustors1985