The Evaluation of Weldability for AZ31B-H24 and AZ91C-F Mg Alloys in Friction Stir Welding
Authors:
- 15 October 2006
- journal article
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 321-323, 1723-1728
Abstract
In the present study, an investigation has been carried out on the friction stir welding (FSW) of two magnesium alloys. Hot-rolled and Die-casting plates of AZ type magnesium alloys were successfully joined by friction stir welding. AZ31B-H24 and AZ91C-F plates with the thickness of 4mm were used, and the microstructural development in stir zone (SZ) was investigated using optical and scanning electron microscopes. Hardness of SZ in AZ31B-H24 alloy has been slightly decreased due to the coarse structure. On the other hand, Hardness of SZ in AZ91C-F alloy has been remarkably increased due to very fine recrystallized grain structure. The result of EPMA showed Al Solid solution hardening by Solid solution of β intermetallic compound to α-Mg. While tensile strength of the FSWelded AZ31B-H24 alloy showed about 80% values compare to Base metal, AZ91C-F showed about 68% values due to strongly affected by formation of the intermetallic compounds, β-Al12Mg17.Keywords
This publication has 4 references indexed in Scilit:
- Effect of micro-texture on fracture location in friction stir weld of Mg alloy AZ61 during tensile testScripta Materialia, 2003
- The Joint Characteristics of Friction Stir Welded AZ91D Magnesium AlloyMATERIALS TRANSACTIONS, 2003
- Application of friction stir welding to the car bodyWelding International, 2003
- Friction Stir Welding: an innovative seam technologyWelding International, 2003