Effect of Pre-reduction of Manganese Ore by Hydrogen on Its Smelting Behavior and Interaction with Stable Oxides
Open Access
- 11 July 2025
- journal article
- research article
- Published by Springer Nature in Journal of Sustainable Metallurgy
- Vol. 11 (3) , 2980-3000
Abstract
The conventional ferromanganese production process is driven by coal/coke utilization and constitutes a substantial source of greenhouse gas emissions. Hydrogen-based pre-reduction process stands out for its substantial carbon reduction capabilities and established technological maturity. Regarding this, a process called HAlMan is proposed, where the manganese ore is pre-reduced with hydrogen and then fed in the smelting furnace for complete reduction with aluminum. As the pre-reduced ore becomes the charge material (feed) it becomes quite necessary to understand how the pre-reduced ore behaves when it meets other stable oxides and refractories for that matter. The present work studies the interaction of Nchwaning Manganese ore with Al2O3, SiO2 and MgO substrates before and after reduction with hydrogen, using sessile drop wettability approach. The formed slag droplet on the substrate were cut through center and the cross-sectional analysis for diffusion depth and microstructure was done using SEM, EDS and mapping. In addition, FactSage thermodynamic software was used to correlate and understand the experimental observation and possible phase formed at elevated temperatures. The study found that both pre-reduction and substrate types significantly influence softening and smelting behavior of ore particles. Pre-reduced ore melted at 1350 °C with a wetting angle of 24.32° on SiO2 and 1544 °C with 13.62° on Al2O3. While the unreduced ore melted at 1285 °C with of 32.15° on SiO2 and at 1485 °C with 16.12° on Al2O3. No complete melting was observed on MgO substrate in either case. Giving an idea that MgO could be a better refractory for smelting of pre-reduced ore. The addition of Al2O3 to the pre-reduced and unreduced Nchwaning ore has opposing effect as studied using FactSage. The melting temperature of pre-reduced decreases while that of unreduced ore increases on Al2O3 addition. This shows that the aluminothermic reduction of pre-reduced ore is better as the dissolution of Al2O3 would decrease the overall melting temperature during operation in HAlMan process. Graphical AbstractKeywords
Funding Information
- HORIZON EUROPE Reforming and enhancing the European Research and Innovation system (101091936)
- NTNU Norwegian University of Science and Technology
This publication has 39 references indexed in Scilit:
- Thermodynamic modeling of the Mn–Si–O systemPhysics and Chemistry of Minerals, 2024
- Thermally activated structural transformations in manganese oxide nanoparticles under air and argon atmospheresJournal of Materials Science, 2020
- Reaction Behaviors of Al-Killed Medium-Manganese Steel with Different RefractoriesMetallurgical and Materials Transactions B, 2018
- Cradle-to-gate life cycle assessment of global manganese alloy productionThe International Journal of Life Cycle Assessment, 2016
- Microscopic Study of Carbon Surfaces Interacting with High Carbon Ferromanganese SlagMetallurgical and Materials Transactions B, 2014
- Melting and Reduction of Manganese Sinter with Fluxes2012
- Ore Melting and Reduction in Silicomanganese ProductionMetallurgical and Materials Transactions B, 2010
- Kinetics and Mechanism of the Simultaneous Carbothermic Reduction of FeO and MnO from High-Carbon Ferromanganese SlagMetallurgical and Materials Transactions B, 2009
- Reduction Kinetics of MnO from High-Carbon Ferromanganese Slags by Carbonaceous Materials in Ar and CO AtmospheresMetallurgical and Materials Transactions B, 2008
- Dynamic and equilibrium interfacial phenomena in liquid steel-slag systemsMetallurgical and Materials Transactions B, 2000