Effect of Graphite and Bronze Fillers on PTFE Tribological Behavior: A Commercial Materials Evaluation
- 27 December 2019
- journal article
- research article
- Published by Taylor & Francis in Tribology Transactions
- Vol. 63 (2) , 356-370
Abstract
This work presents a tribological evaluation of the influence of graphite and bronze fillers of two commercial composites in a dry sliding pin-on-disc test, under the same contact severity ( parameter) and four testing conditions (varying both normal force and sliding velocity). Both fillers did significantly affect, in comparison to pure PTFE, the coefficient of friction (COF) and the mass loss. Sliding distance required to reach steady-state for COF was statistically equal for all three materials. COF experienced a relevant influence of both normal force and sliding velocity. The graphite filler acted as a solid lubricant and exhibited reductions in COF (∼ 27% on average) and in mass loss (∼4.2 times lower on average). The bronze filler, on the other hand, had a COF increase of up to 5% for conditions with lower normal force, but showed a significant reduction on the specific mass loss (∼5.3 times lower on average). Due to its higher thermal conductivity, the composite filled with graphite presented lower tribosystem temperatures in thermography evaluations. A good agreement of the temperature data was found considering a model that proposes the rate of heat generated by friction. With respect to wear of the composites, it was found evidence of adhesion (transfer films to the counterface) and abrasive (microploughing and microcutting) wear mechanisms, besides the identification of preferential wear.
Keywords
This publication has 43 references indexed in Scilit:
- Novel polytetrafluoroethylene (PTFE) composites with newly developed Tribaloy alloy additive for sliding bearingsWear, 2009
- Triboengineering properties of polytetrafluoroethylene modified by thermally expanded graphiteJournal of Friction and Wear, 2008
- Investigation of the Tribological Behavior of Polytetrafluoroethylene at Cryogenic TemperaturesTribology Transactions, 2008
- Sliding friction and wear behaviour of polytetrafluoroethylene and its composites under dry conditionsMaterials & Design (1980-2015), 2004
- The wear of filled polytetrafluoroethyleneWear, 1984
- Adhesive Wear of PolymersJournal of Lubrication Technology, 1977
- Multi-phase filled-plastics piston rings for non-lubricated compressors A comparison of the performance of filled ptfe and epoxy-bonded materials in dry gasesTribology International, 1973
- Friction and molecular structure: the behaviour of some thermoplasticsProceedings of the Royal Society of London. A. Mathematical and Physical Sciences, 1972
- The effect of carbon fibre reinforcement on the friction and wear of polymersJournal of Physics D: Applied Physics, 1968
- The role of filler geometrical shape in wear and friction of filled PTFEWear, 1962