Synthetic aperture flow imaging using dual stage beamforming: Simulations and experiments
- 1 April 2013
- journal article
- research article
- Published by Acoustical Society of America (ASA) in The Journal of the Acoustical Society of America
- Vol. 133 (4) , 2014-2024
Abstract
A method for synthetic aperture flow imaging using dual stage beamforming has been developed. The main motivation is to increase the frame rate and still maintain a beamforming quality sufficient for flow estimation that is possible to implement in a commercial scanner. This method can generate continuous high frame rate flow images with lower calculation demands than the full synthetic aperture flow imaging. The performance of the approach was investigated using Field II simulations and measurements with the experimental scanner SARUS. A laminar flow with a parabolic profile was generated by a flow rig system. The flow data were acquired by a commercial 7 MHz linear array transducer. Four emissions were transmitted sequentially and repeated 12 times corresponding to 48 emissions. Flow with a peak velocity of 0.12 m/s was measured, the relative standard deviation was 6.4%, and the bias was 7.6% (2.1% and 3.2% for the simulations). A parameter study revealed that emission spacing, number of cross-correlation functions used for averaging, and the length of the velocity searching range influence the performance. Compared to the full synthetic aperture flow imaging the total number of beamformed samples are reduced by a factor of 64 times, and the frame rate is much higher than the conventional method for the same velocity estimation accuracy.Keywords
This publication has 11 references indexed in Scilit:
- Sequential beamforming for synthetic aperture imagingUltrasonics, 2013
- Synthetic aperture ultrasound imagingUltrasonics, 2006
- Estimation of Velocity Vectors in Synthetic Aperture Ultrasound ImagingIEEE Transactions on Medical Imaging, 2006
- In-vivo synthetic aperture flow imaging in medical ultrasoundIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2003
- Ultrafast compound imaging for 2-D motion vector estimation: application to transient elastographyIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2002
- 2D and 3D high frame rate imaging with limited diffraction beamsIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 1997
- Calculation of pressure fields from arbitrarily shaped, apodized, and excited ultrasound transducersIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 1992
- Flow velocity profile via time-domain correlation: error analysis and computer simulationIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 1990
- Ultrasonic backscatter from flowing whole blood. I: Dependence on shear rate and hematocritThe Journal of the Acoustical Society of America, 1988
- Beam patterns from pulsed ultrasonic transducers using linear systems theoryThe Journal of the Acoustical Society of America, 1981