The Effect of Clay Content on PMMA-Clay Nanocomposite Foams
Authors:
Open Access
- 1 March 2005
- journal article
- research article
- Published by SAGE Publications in Cellular Polymers
- Vol. 24 (2) , 49-70
Abstract
In this study the CO2sorption at 45 °C in PMMA nanocomposite films containing 2 wt.% of nanoclay has been measured using an in-situ gravimetric technique. The films examined were prepared by compression moulding material obtained by dry-blend and solvent co-precipitation techniques. The CO2diffusion coefficients were found to be higher for the dry-blended nanocomposite due to the larger agglomerations of the organoclay agglomerations, which prevented the polymer chains from fully wetting and intercalating the clay particles. The Tg-p profile for PMMA nanocomposite containing 2 wt.% nanoclay in the presence of CO2was also measured using high-pressure DSC. The glass transition phase envelope was shifted vertically by approximately 10 °C when compared to the value reported in the literature for neat PMMA. This result suggests that the nanoclay affects the plasticization behaviour of PMMA under high-pressure CO2conditions. The cellular morphologies obtained for these PMMA nanocomposite foams produced by batch processing with subcritical CO2are strongly dependent upon the clay content and the dispersion of the nanoclay in the material. In the case of intercalated nanocomposites, most clay particles exist as agglomerated stacks of silicate sheets. On foaming the cells tend to form around the clay particles causing either irregular-shaped cells or layers to be produced. As a result, the cell density increases and the mean cell size decreases in the foamed nanocomposite on increasing the nanoclay content. Accordingly, the resulting cell structures are highly non-uniform and show large variations in cellular morphologies throughout the foam.Keywords
This publication has 30 references indexed in Scilit:
- Effect of die temperature on the morphology of microcellular foamsPolymer Engineering & Science, 2003
- Effect of dissolved gas on the viscosity of HIPS in the manufacture of microcellular plasticsPolymer Engineering & Science, 2003
- Cell nucleation in solid-state polymeric foams: evidence of a triaxial tensile failure mechanismJournal of Materials Science, 1999
- Production of low‐density LLDPE foams in rotational moldingPolymer Engineering & Science, 1998
- A study of cell nucleation in the extrusion of polypropylene foamsPolymer Engineering & Science, 1997
- A microcellular processing study of poly(ethylene terephthalate) in the amorphous and semicrystalline states. Part I: Microcell nucleationPolymer Engineering & Science, 1996
- Effect of the pressure drop rate on cell nucleation in continuous processing of microcellular polymersPolymer Engineering & Science, 1995
- The Role of Gas Dissolution and Induced Crystallization During Microcellular Polymer Processing: A Study of Poly (Ethylene Terephthalate) and Carbon Dioxide SystemsJournal of Engineering Materials and Technology, 1995
- Production of Microcellular Polycarbonate Using Carbon Dioxide for Bubble NucleationJournal of Engineering for Industry, 1994
- Carbon dioxide foaming of glassy polymersJournal of Applied Polymer Science, 1994