Optical properties of uniform, porous, amorphous Ta2O5coatings on silica: temperature effects
- 23 October 2013
- journal article
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 46 (45) , 455301
Abstract
We present spectroscopic ellipsometry (SE) results, in the 0.75–5 eV spectral range, obtained on highly uniform Ta2O5 coatings deposited on high-quality silica substrates by ion sputtering. The study was motivated mainly by issues related to the exploitation of Ta2O5–SiO2 λ/4 multilayers in detectors of gravitational waves. Two sets of samples with nominal thicknesses of 40 and 500 nm were considered. A sub-set of samples was treated with post-growth annealing in air for several hours at temperatures Tann up to 600 °C. The SE data were complemented with photothermal common-path interferometry measurements at 1064 nm providing data about absorption losses in the 1–4 ppm range. SE data, taken at room temperature, were analysed by exploiting three different three-phase (substrate/film/surface) models (Cody–Lorentz, Tauc–Lorentz and Herzinger–Johs) of the fundamental absorption edge. Following the literature (Stenzel 2009 J. Phys. D: Appl. Phys. 42 055312) the simulations exploited a graded nano-porosity inside the coating, testing both the shape and composition of the pores. The best simulation of data was obtained using the Cody–Lorentz approach and a quasi-uniform density (6–7.5%) of empty spherical pores, slowly degrading from the substrate/film interface towards the film/ambient interface. A comparison with the literature indicated a high stoichiometric quality of the coatings. The analysis of samples annealed to increasingly higher Tann showed (i) a slight blue-shift of the energy gap (ii) an increase in the pore volume fraction, (iii) an increase (1–2%) in the coating thickness, (iv) a small (less than 1%) reduction in the index of refraction in the transparency region and (v) a limited increase in absorption losses. These findings were interpreted in terms of a release of the compressive strain inherent to the deposition process.Keywords
This publication has 60 references indexed in Scilit:
- Virgo: a laser interferometer to detect gravitational wavesJournal of Instrumentation, 2012
- Invited Review Article: Interferometric gravity wave detectorsReview of Scientific Instruments, 2011
- A fast, high-endurance and scalable non-volatile memory device made from asymmetric Ta2O5−x/TaO2−x bilayer structuresNature Materials, 2011
- Mixed oxide coatings for opticsApplied Optics, 2010
- Ion beam deposition of tantalum pentoxide thin film at room temperatureJournal of Vacuum Science & Technology A, 2008
- Comparision of residual stress and optical properties in Ta2O5 thin films deposited by single and dual ion beam sputteringMaterials Science and Engineering: B, 2005
- Influence of postdeposition annealing on the enhanced structural and electrical properties of amorphous and crystalline Ta2O5 thin films for dynamic random access memory applicationsJournal of Applied Physics, 1999
- Tantalum pentoxide (Ta2O5) thin films for advanced dielectric applicationsMaterials Science and Engineering: R: Reports, 1998
- Ion-beam and dual-ion-beam sputter deposition of tantalum oxide filmsOptical Engineering, 1995
- LIGO: The Laser Interferometer Gravitational-Wave ObservatoryScience, 1992