Finite Element Analysis of Friction-Induced Stress Concentrations in Press Fits with Chamfer Hubs
Open Access
- 21 May 2025
- journal article
- research article
- Published by MDPI AG in Lubricants
- Vol. 13 (5) , 231
Abstract
The interference fit is a common process for the assembly of mechanical parts on a shaft for diverse mechanical engineering applications. One of the manufacturing methods consists of introducing a shaft into a hub by applying a force being the hub diameter lower than the shaft diameter. This way, contact pressure is generated at the shaft–hub interface at the end of the process, enabling torque transmission. Thus, a non-uniformly distributed stress state appears at the shaft–hub interface with significant stress peaks at the hub edges. In addition, as a consequence of the manufacturing process, local plasticity is generated in the hub on the insertion side causing changes in stress distributions. In this paper, an analysis based on finite elements simulations is carried out to reveal the influence of, on one hand, manufacturing parameters such as friction on stress concentrations at the interface and, on the other hand, geometrical parameters such as hub chamfer angle, considering chamfer hubs and conventional hubs. To achieve this goal, different simulations of the mechanical manufacturing process of the axial assembly of press fits are carried out to reveal the stress fields at the interface. Thus, stress concentrations under different friction conditions from a case without friction to a dry friction case are revealed and analyzed. The results show, on one hand, the friction coefficient as a highly influential factor, causing asymmetrical stress distributions with high stress concentrations that reduce the mechanical performance of press fits and, on the other hand, the beneficial impact of chamfer hubs for lowering stress concentrations.Keywords
Funding Information
- Fundación Memoria D. Samuel Solórzano Barruso (FS/32–2017, FS/12–2021, PID2020–119003GB–I00)
- Ministerio de Ciencia, Innovación y Universidades (FS/32–2017, FS/12–2021, PID2020–119003GB–I00)
This publication has 59 references indexed in Scilit:
- Deep-Learning-Coupled Numerical Optimization Method for Designing Geometric Structure and Insertion-Withdrawal Force of Press-Fit ConnectorActa Mechanica Solida Sinica, 2024
- Influence of Surface Roughness on Press FitsTribology Letters, 2022
- Investigations on design limits and improved material utilization of press-fit connections using elastic-plastic designApplications in Engineering Science, 2022
- Effect of radial interference on torque capacity of press- and shrink-fit gearsInternational Journal of Automotive Technology, 2016
- On optimization of interference fit assemblyStructural and Multidisciplinary Optimization, 2016
- Failure analysis of the pulleys during the press-fit assembling processCase Studies in Engineering Failure Analysis, 2015
- Shrink fit with solid inclusion and functionally graded hubComposite Structures, 2015
- Stress distribution in interference jointsComputers & Structures, 1994
- Stress distribution in shrink fit with elastic-plastic hub exhibiting variable thicknessInternational Journal of Mechanical Sciences, 1993
- Numeric modeling of the process of press fitting dies into ring blocks with allowance for plastic deformation and frictional forcesStrength of Materials, 1990